Question about Cars & Trucks

1 Answer

Why is m 93 for ranger running hot

Doesnt get to the red mark but running hot

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 50 Answers

Replace thermostat its probably stuck open.. Follow the top hose from radiator to the engine it will be there..

Posted on Apr 27, 2013

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

What color is the power wire going to my coil pack on my 93 ford ranger


red wire with lite green tracer, four cylinder engine.
It appears to go hot with key on. There is ignition fuse in underhood fuse box.

Sep 20, 2017 | Ford Cars & Trucks

1 Answer

How to installing a solenoid for 86 ford ranger which wires go where?


On your big cables, either copper post is fine, one comes from the battery, one goes to the starter. Once the solenoid is turned on it will send power to either side. The wire with the elbow boot slides onto the silver post marked S. This is the power wire from the computer. Should be red/lt blue. On the other side is your coil wire. That will let the coil have power during cranking. It is marked (-). It should be a wire with a small ring at the end. should be red/lt green. Any other wires with the large ring will hook to the same side as the cable from the battery as they are hot all the time. These wires get hacked up over time, but this should put you in the ballpark.

Mar 07, 2011 | 1990 Ford Ranger SuperCab

1 Answer

Fuel pump will not run


THERE IS A FUEL PUMP SHUT OFF SWITCH(INERTIA) ON THE PASSENGER SIDE KICK PANEL.INSIDE CAB UNDER DASH.IT INTERUPTS POWER TO THE PUMP IF U ARE IN A COLLISION.PUSH THE RED BUTTON ON TOP OF IT.IF THAT DOES NOT WORK CHECK FOR POWER IN AND POWER OUT.NO POWER OUT BAD SWITCH.NO POWER IN OTHER PROBLEM

May 05, 2009 | 1987 Ford Ranger

1 Answer

Temp guage runs in the red! 93 mark VIII 135K miles


has the water pump been changed recently? The water pump on a 4.6L 2v and 4.6L 4v look the same but are different

Apr 18, 2009 | 1993 Lincoln Mark VIII

1 Answer

How do you check the auto trans fluid in 1995 ranger xlt 3.0l?


There are two's to check.
1st way is to check it when the reansmission is still cold, whild the engine is running and it's in park. Pull out the dip stick to the transmission which should have a red handle. Pull it out and clean it and push it back in and pull it out again, at the end of the dip stick there are markings which should say cold and hot. If your transmission is still cold do to your just started it. The oil level should at least be in the cold markings or just above. 
2nd way is the same as the first, just your transmission has been working. Say you have been driving and stop for gas and everything is hot and you check your transmission oil. The you'ld look to see if your transmission oil is up to the full mark where it say's hot. 
Note: It's better to check the fuild to the trasmission when it's hot, just becareful not to burn your self.
Check for oil level and texture of the oil. Oil should be free of bubbles and have a bright red in colour. If there are sign's of bubbles in the oil or the fuild is dark burgundy colour. it's time for a tansmission oil and filter change. Try not to do a transmission flush if you have over 80,000 miles. 
Good luck and hope this helps

Apr 09, 2009 | 1995 Ford Ranger Supercab

1 Answer

Ignition module wiring on 85 f150


The red wire goes to constant hot and the white wire is on the key on/off. The green is a tach signal and the black is ground.

Jul 15, 2008 | 1985 Ford F150

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...