Question about 1995 Honda Odyssey

Open Question

Ballast resistor Does the 1995 odyssey have a ballast resistor? If so, where is it located.

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Does a 1951 Plymouth Cranbrook have a primary resistor that has to do with starting the car?


Older cars had a ballast resistor to limit the voltage to the ignition coil in order to prolong the life of the coil. The way it was set up, when the starter was engaged, the ballast resistor was bypassed, providing full voltage to the coil for a 'hot' spark. Once the engine was running, current to the coil was routed through the ballast resistor. I think this was usually accomplished in the ignition switch - full power in 'Start' position, through the ballast resistor in the 'Run' position.

Nov 25, 2016 | Plymouth Cars & Trucks

1 Answer

1965 falcon sedan resistor


Ignition ballast resistor is usually mounted on the firewall near the back of the engine. It's white, rectangular, and has a wire connector on each end. It's function is to limit primary coil current during engine running. The ballast is bypassed during starting so you get a higher spark voltage. If you remove the ballast, you will burn out your coil.

Feb 23, 2014 | Ford Falcon Cars & Trucks

1 Answer

I have a 1985 plymouth gran fury that has no spark. I replaced coil and test for proper volts. Replaced Distributer cap and rotor, new pick up, new plugs, new ECU mounted on air box, tested fusible links,...


Check out this site: https://www.allpar.com/forums/topic/40994-ballast-resistor/

Seems to be some debate as to whether or not your car even has a ballast resistor, and if it does, where it may be located. I've always seen ballast resistors mounted on the firewall away from the engine's heat...but those were on older models (50's, 60's 70's). Good luck.

Oct 08, 2013 | Plymouth Gran Fury Cars & Trucks

1 Answer

Where is the ballast resistor located on a 1996 dodge dakota


cant see a listing for a 1996 dakota ballast resistor
if it had one would be a ceramic block close to the old school round coil

this is its coil
there is an ignition coil driver in the wiring diagram
automotive wiring diagram Ignition Coil Driver 1995 Dodge Dakota Wiring... 17671761-1xghuso0dtf1wvqnhgyxjoi3-1-0.jpg

17671761-1xghuso0dtf1wvqnhgyxjoi3-1-1.jpg

Apr 13, 2013 | Dodge Dakota Cars & Trucks

1 Answer

I dont know how the engine ballast resistor look on 99 nissan maxima


What code did autozone say you had. Ballast resistors have been used in cars since the late 1970's.

Apr 02, 2013 | Cars & Trucks

1 Answer

Where is the ballast resistor located in a 1994 dodge ram 250 van?


You must be living in the 1960's

Ballast resistors were for ignition with points,
to reduce the coil voltage to under 10 Volts

Mar 21, 2013 | Cars & Trucks

1 Answer

How do I test the ballast resister on my 1995 jeep wrangler? I have a multimeter but no manual. I have no power to the fuel pump.


The Multimeter has several functions.It test voltages [a/c, d.c. (+ plus, - minus)], then the RESISTANCE test to test 'ballast resistors". If the tester has a on-off switch, make sure that the scitch is OFF. If you can disconnect one side of the resistor, do so !! Place (+plus) side of probe on DISCONNECTED side, turn meter ON, place other side of probe (- minus)on other side of resistor.You should mesure the resistance you see written on the ballast. IF YOU CAN'T DISCONNECT ONE SIDE, just follow the same rules WITHOUT DISCONNECTING one side.
NOTE:: Rustyrooster, what Salkim08 said is true, but he simplifed it. Connected to the ballast on either side or both sides is a circukt (ckt.) that could effect the measurement.

Oct 08, 2009 | 1994 Jeep Wrangler

1 Answer

1997 Millenia won't start, no spark.


If theres no spark try replacing the rotor button and coil, not sure where the ballast resistor is located.

Jun 22, 2009 | 1997 Mazda Millenia

Not finding what you are looking for?
1995 Honda Odyssey Logo

Related Topics:

37 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...