Question about 2000 Isuzu Trooper

Open Question

P0122 tps trooper - 2000 Isuzu Trooper

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My kia has 0122 code i replaced the tps and still does the samething


While the TPS fault will read p0122 the accelerator pedal position(APP) also has a say in the code p0122. It can be low input, or circuit malfunction ==the causes-- can be wiring short to ground--TP/APP sensor--wiring circuit open, short to ground/short to positive

Nov 14, 2014 | Cars & Trucks

1 Answer

1998 chrysler concorde code P1684 P0122


P01684 just says that the battery has been disconnected within the past 50 starts. If you have already replaced the TPS and still get the P0122 code, it could be a short in the wiring or a problem with your Powertrain Control Module. Other names for the PCM is ECM and ECU. Engine Control Module and Engine Control Unit

Mar 02, 2013 | 1999 Chrysler Concorde

1 Answer

P0122 error code on a 1999 oldsmobile 88


P0122 Code - Throttle Position Sensor/Switch A Circuit Low Input
A P0122 code means that the the car's computer has detected that the TPS (throttle position sensor) is reporting too low a voltage. On some vehicles that lower limit is 0.17 - 0.20 volts (V).

Did you adjust it when you installed it? If the signal value is less than .17V then the PCM sets this code. Could be an open or a short to ground in the signal circuit. Or you may have lost the 5Volt reference voltage.

Symptoms may include:
Rough or low idle
Stalling
Surging
No/little acceleration
other symptoms may also be present

Causes: A code P0122 may mean that one or more of the following has happened:
TPS not mounted securely
TPS circuit short to ground or another wire
Faulty TPS
Damaged computer (PCM)

Possible Solutions: Some recommended troubleshooting and repair steps are:
Carefully check the throttle position sensor (TPS), wiring connector, and wiring for breaks, etc. Repair or replace as necessary
Check the voltage at the TPS (refer to a service manual for your vehicle for specific information). If the voltage is too low that is indicative of a problem. Replace if necessary.
If recently replaced the TPS may need to be adjusted. On some vehicles the installation instructions call for the TPS to be properly aligned or adjusted, consult a repair manual for specifics.
If there are no symptoms at all, the problem may be intermittent and clearing the code may resolve the issue temporarily. If this is the case then you should definitely check the wiring to be sure it's not rubbing on anything, grounding, etc. The code may come back.


Test it and keep us updated.

Jun 12, 2011 | Oldsmobile 88 Cars & Trucks

1 Answer

2004 - JEEP LIBERTY SPORT 3.7/V6 ENGINE LIGHT ON !!! CODE #(P0122) What is it ? Can I fix it ? Dealership fix only ?


P0122 Code - Throttle Position Sensor/Switch A Circuit Low Input

A P0122 code means that the the car's computer has detected that the TPS (throttle position sensor) is reporting too low a voltage. On some vehicles that lower limit is 0.17 - 0.20 volts (V).

Did you adjust it when you installed it? If the signal value is less than .17V then the PCM sets this code. Could be an open or a short to ground in the signal circuit. Or you may have lost the 5Volt reference voltage.

Symptoms may include:
* Rough or low idle
* Stalling
* Surging
* No/little acceleration
* other symptoms may also be present

Causes: A code P0122 may mean that one or more of the following has happened:
* TPS not mounted securely
* TPS circuit short to ground or another wire
* Faulty TPS
* Damaged computer (PCM)

Possible Solutions: Some recommended troubleshooting and repair steps are:
* Carefully check the throttle position sensor (TPS), wiring connector, and wiring for breaks, etc. Repair or replace as necessary
* Check the voltage at the TPS (refer to a service manual for your vehicle for specific information). If the voltage is too low that is indicative of a problem. Replace if necessary.
* If recently replaced the TPS may need to be adjusted. On some vehicles the installation instructions call for the TPS to be properly aligned or adjusted, consult a repair manual for specifics.
* If there are no symptoms at all, the problem may be intermittent and clearing the code may resolve the issue temporarily. If this is the case then you should definitely check the wiring to be sure it's not rubbing on anything, grounding, etc. The code may come back.


Hope helps (remember to rate this answer).

Mar 01, 2011 | Jeep Liberty Cars & Trucks

1 Answer

I have five fault codes for my GM Safari Van what are they and how can I find out what they mean? P0507,P0122,P0106,P0108,P0122


P0507, Idle Control System RPM Higher Than Expected
P0122,Generic TPS/Throttle position sensor A circuit low input
P0106, Manifold Absolute Pressure barometric Pressure Circuit Range/Performance problem
P0108, Manifold Absolute Pressure ( MAP) Sensor circuit high voltage.

Good luck

Dec 16, 2010 | GMC Safari Cars & Trucks

1 Answer

What is Codes PO122 & PO303?


P0122 = TPS (throttle position sensor) voltage reports too low. This means that you could have a problem with the TPS, the wires to the TPS or the computer, if you have not replaced the TPS or do not want to do this work, I would take it in to a shop for this to be done. The TPS may require adjusting after replacement.
P0303= Cylinder Number 3 Missfire Detected, this means that the number 3 cylinder has miss fired, probably set this code as a result of the P0122 code. I would repair code P0122 and clear both codes. Hope this helps, let me know.

Aug 04, 2010 | Ford Ranger Cars & Trucks

2 Answers

Check engine light came on trouble shooting code is P 0122


Code P0122 is a TPS (Throttle Position Sensor) sensor out of range.

The operating range of the TPS is about .5 to 4.8 volts. .5 at idle 2.5 at half throttle and 4.8 at full throttle.

This can be checked easily with a scanner. But can be checked with a multi-meter.
P0122 Tjrottle Position Sensor low voltage

You can try replacing it for a start and see what happens
(location image)...

f1c255f.gif

Hope this help.

Mar 29, 2010 | 2005 Kia Sedona

Not finding what you are looking for?
2000 Isuzu Trooper Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...