Question about 2009 Lexus IS 250

Open Question

Engine light is and slip indicator light is on

My car has been sitting idle for about a month without cranking. Was getting body work done...new tires, new bumper and paint job. After about sitting idle for 3 weeks, when the repair guy tried to crank it, it wouldn't start. We had to jump the battery, but it is running now. However, the check engine and slip indicator lights are on. The car runs smoothly, but I'm concerned as to what could be the problem. Pepboys ran scan on it and came back with misfire codes for cyclinder 2 and cyclinder 6. Anyone have any ideas as to what the diagnosis could be?

Posted by Anonymous on

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 55 Answers

SOURCE: No dash lights, power seats or windows. alternator not charging. Engine runs

  1. It might be that when you changer the battery post you might not have connected all of the leads on the positive post. You might also check for blown circit breakers caused while changing the terminals.Try using a dc tester and search the main breakers for power. If you have the manual it shows the breakers and links in the bulb replacement section. JOHN-LA.

Posted on Sep 01, 2008

Ad
  • 156 Answers

SOURCE: My Car has been sitting

There could be 2 reasons for this. One is that the fuel pump burned out (you would be able to recognize this if you turn the ignition key over and get close to the gas tank you will hear it spinning). The other is there is a sensor on the bottom of the gas tank that reads when you are completely out of gas and you will need to contact the dealer on how to get it reset. Hope this helps you out! Have a good one!

Posted on Feb 20, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2010 Ford F150 would suddenly loose power and only idle. Pull over shut off sit a couple minutes crank and run fine for a while then do same thing again. Wrench would show up on instrument panel


Sounds like the catalytic converter or muffler maybe getting plugged up and the computer is putting the truck in limp home mode. Did you put a scanner on the truck. You might try to remove the 02 sensor ahead of the cat and see if it runs a little better it will not be perfect but should stay running if so do an exhaust check. When the cat or muffler gets plugged it puts back pressure on the engine and won't allow the fuel to be pulled into the engine properly.

May 19, 2017 | Ford Cars & Trucks

1 Answer

IDLE CONTROL SYSTEM!! HELP


Poss clogged injector, vacuum leak Throttle body gasket Good luck

Mar 29, 2017 | 2003 Saab 9-3

2 Answers

2005 trailblazer... here's what I've had done to stop this problem, new cat. converter, new o2 sensors all around, new plugs... Now $800 later it's still doing it: engine idle at stop signs and red...


Hello: It sounds like you have a throttle with excessive carbon build up, remove the hose (air induction) from the throttle body use a clean soft towel and carburetor cleaner and clean the throttle plate and bore of the throttle body, do not spray an excessive amount of cleaner into the throttle body. After cleaning and reassembly, make sure key is off and disconnect negative (black) battery cable for 15 seconds.

Mar 04, 2011 | Chevrolet TrailBlazer Cars & Trucks

1 Answer

Engine cuts off after several minutes despite enough fuel, new spark plugs and no physical indication of overheating or engine wear.


there is on the throttle body,a unit called an idle air control valve.it controls the idle speed,and it results in a very low idle or stall if defective.you could have a bad cap rotor or distributor or coil.There is also the crank and cam sensors,but they would set a check engine code if bad.

May 18, 2010 | 1995 Mazda 626

1 Answer

My 2005 Ford Five Hundred just quit whie sitting with it running I have checked fuses and relays and the fuel reset on passenger side and I even pulled the fuel pump out and checked it and it works but I...


You will need a scanner put on it,with body module software,to diagnose the issue. If the Fuel Pump has a Driver Module,you won't see voltage unless certain conditions are met
Did you check fuel pressure at rail when cranking.
Without a wiring diagram of your veh,your pretty much done. Too high tech
I assume you got a crank sensor signal and spark,while cranking.
No codes stored,even without a MIL Light?

May 07, 2010 | 2005 Ford Five Hundred

2 Answers

I got code p2176 I changed out the tps still got same problem did not have this problem with other engine just changed engine out now cant seem to get this code off causing the car to rough idle and low...


P2176=Throttle Actuator Control System - Idle Position Not Learned
Did you use all you old sensors,or is some of them from the new engine,I would swap out the IAC sensor or check for wires not hooked up.
If it can't relearn to idle the Idle air control might be different then your old one,but its not registering with the computer

Dec 17, 2009 | 2006 Chevrolet Impala

1 Answer

2002 Tahoe will not start


check and recheck all conections on battery and starter and grounds on battery and the ground on engine bblock and body ground or grounds,if not sure make another one ,check connections at battery ,it does sound like a bad ground to body and eng just make ur owne and see what happens

Jun 28, 2009 | 2002 Chevrolet Tahoe

2 Answers

2004 Honda Civic -Code P0122 Throttle Position Sensor Voltage Low


yes, this is the case of a failed throttle body, in which case it needs replaced, the car is getting too much fuel causing the high idle. this needs replaced asap. you could proably find a small independant honda shop that could do the work for less.

May 12, 2009 | 2004 Honda Civic

1 Answer

2001 Ford escort zx2 wants to die while idling


The check engine light indicates a problem. You need to have the codes read. Most parts stores do this for free. Write down the codes and ask them what they mean, and what u should do. You can come back here if u need more info.

Dec 09, 2008 | 1998 Ford Escort

1 Answer

SLIP/TCS


You need to go to the dealer and have the vehicle scanned for codes. If it has an ISC code it may just need the Idle Volume Learn performed. This can happen when the battery is disconnected for a long period of time. Hope this helps.

Aug 18, 2008 | 2004 Nissan 350Z

Not finding what you are looking for?
2009 Lexus IS 250 Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lexus Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

905 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a Lexus Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...