Question about 1996 GMC Jimmy

1 Answer

Gas gauge jumps crazily - 1996 GMC Jimmy

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 59 Answers

Bad float in your tank

Posted on Sep 11, 2013

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Gas gauge problem


check all wiring around starter to see if you pinched 1 or 1 is grounding against starter.
can not add more because you not state make an model

Aug 14, 2015 | Cars & Trucks

1 Answer

Where is the fuse for peril gauge in a Citroen c1


Find the problem? No separate fuse for the gas gauge, if the rest of dash and gauges work (the temperature gauge), not a fuse problem.


Take off the electrical connector at the gas tank, find the wire for the fuel sender unit in the tank to the gas gauge, and ground it temporarily to the car body, with the key ON. If the gas gauge needle jumps when grounding the wire, the gauge is good, and the problem is with the sender unit in the tank.

May 10, 2014 | Cars & Trucks

1 Answer

1999 oldsmobile aurora


Sounds like a bad switch if wiggling it around causes the gauges to jump around.

Jan 01, 2014 | Oldsmobile Aurora Cars & Trucks

2 Answers

I have a 1998 Chevy Blazer. My gas gauge does not work properly. The gas gauge stay's on FULL at all times no matter how much gas is in it. When it get's low on fuel the gas gauge start's to jump back and...


It has 2 possible solutions 1) fuel sending unit is going bad which the tank has to be dropped to change, 2) you have a bad cluster panel. Hope this helps

Dec 18, 2013 | 1998 Chevrolet Blazer

1 Answer

I was trying to jump start my jeep and connected the jumper cables wrong. Now its doing all sorts of funny stuff. What should I do to fix this problem?


I had a battery die on my 02 grand Cherokee, all the gauges went wild, needles bouncing from left to right crazily! You need a new battery!

Sep 06, 2013 | 2000 Jeep Grand Cherokee

1 Answer

My oil and gas gauge on my truck jump .... gas gauge works fine till i get to about half a tank then it starts jumping.. oil gauge jumps from the time i start my car and regulates but when i slow down or...


You probably have a bad sending unit for the fuel level in the tank. this would cause the gauge to be erratic when the level is below 1/2 tank and the float is moving around much more than when full. The oil pressure gauge problem could be caused buy a loose wire connection or a faulty sending unit.

Mar 04, 2011 | Chevrolet Silverado 1500 Cars & Trucks

2 Answers

The gas gauge flucu


It could be a bad ground. Or if someone stuck something in the tank ,like trying to syphen, then the gauge may be bad.

Mar 06, 2010 | 2003 Ford Taurus

1 Answer

Gas gauge jumping around


Gas gauge jumping around usually implies fuel level sensor in tank is going bad...Usually if the gauge in dash is going bad will read empty or at various positions depending on fuel level in tank..Electrical short problem in gauge usually affects other gauges in cluster

Jan 06, 2010 | 1991 Dodge D150

1 Answer

Fuel gauge broken on 2003 Audi A4


You have a fuel gauge sending unit problem, the gauge is not the problem, the sending unit is in the gas tank, u must remove the gas tank to replace it.

May 28, 2009 | 2000 Audi A4

Not finding what you are looking for?
1996 GMC Jimmy Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...