Question about Cars & Trucks

1 Answer

Bobcat s185 I'm having trouble starting a bobcat s185 you turn the key and the air con powers up but it won't start so you leave it on acc for about a minute then the fuel gauge gets power and it will start. it is like it has a start delay but it only just started the fuses are all fine

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 1,209 Answers

Make sure your battery is in good condition. It sounds like your glow plug cycle is taking all of the battery power and after the glow plugs kick off then you have enough power to crank the engine.

Posted on Apr 26, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

ginko
  • 19396 Answers

SOURCE: will not start

Try replacing spark plugs and battery, check the distributor cap.

Posted on Jul 29, 2008

  • 1 Answer

SOURCE: auto sometimes will not start but is getting power to ignition

It sounds like the problem i have, but i think it's the neutral position safety switch. it only lets the engine start if the transaxle is in park or neutral. if it's broken or is out of adjustment, it won't let you start the car because it thinks it's in gear... I'm going to see how hard it is to change and I'll let you know if it fixes it.

Posted on Apr 22, 2009

daves944
  • 1050 Answers

SOURCE: Buick Regal dying

You have a problem in the fuel pump relay circuit for sure then. I'm betting the relay, but it could be that dropping resistor.

Posted on May 11, 2009

Yuma Duner
  • 5 Answers

SOURCE: Intermittent fuel pump engagement when turning key - 2001 Taurus

try cleaning the connector that goes to the fuel pump, sometimes they corrode on inside. If that does not fix, test the wires feeding fuel pump with a multi meter until the condition shows itself again, if voltage drops to zero or very low then wiring problem, if voltage is unchanged with problem and fuel pump is not working and connectors are all clean, try replacement of fuel pump.

Posted on Oct 09, 2009

  • 78 Answers

SOURCE: I have a 1995 Jeep Grand Cherokee Limited ,when I

Certainly sounds like a bad fuel pump regulator. You have a 95 so the regulator isn't part of the fuel pump (on 96 and newer its all one assembly.) You don't have a fuel pressure tester by any chance do you? That would be a great tool in this situation.
Here is a link to the item
It is $60.00

Posted on Jul 13, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 chevy trailblazer when I turn on the air con my dash lighs for ABS and Brake come on, my cruise goes off and the air con will not work.


Have you had the vehicle checked for DTC'S - diagnostic trouble codes ? I would start there first . Battery , charging system all good ? What computer , the ABS has a control module all to it self . The Air con has a relay in the under hood fuse box controlled by the PCM / engine computer . If there is a problem with ABS , The EBCM - electronic brake control module will turn on ABS and the red brake light .
A low voltage condition could cause this problem , but I would expect more of the lights to be lit on the dash . Including the check engine light , battery light . This are not connected , Power or ground wise . Have the vehicle checked for codes , that should be the first place to start any diagnostic's always !

Dec 02, 2016 | 2004 Chevrolet TrailBlazer

1 Answer

I have a 1999 jeep cjerokee lorado How do reset my jeep to turn off the anti theft mode so I can get my jeep engine to stay started


Roll the key ford to acc not started just forward so radio comes onand leave this way for 5 min til security light goes away turn off atempt to start. May die instantly. Just turn off again and restart. Works for my camaro. Or turn key to acc. Then back to off and repeat. This step usually 25 -50 times and it may resrt system. Youll hear a bit off clicking if it works.

Apr 09, 2016 | Jeep Cars & Trucks

2 Answers

Van was stolen, key colum broken, keys gone, cant afford to replace, help please. I can get the radio on.


This may be related to the antitheft system The system is known for turning off the starter and/or injectors when it fails. Is there a light on the dash that says SECURITY? This is a common problem worth looking into. http://www.diy-gm-security.com/
26010581-vfk25ejnbc30ilk3id0obyfh-4-0.png

Dec 16, 2015 | 2000 Pontiac Montana

1 Answer

Bobcat 323 hard start


check for fuel leaks/air getting into the system. Check that the injector tips are clean and atomising -not squirting Best have them replaced by a diesel shop as they require a specialist setting.

Aug 12, 2014 | Cars & Trucks

1 Answer

Why does my 2005 chevrolet classic theft system keep coming on and then the car won't start afterwards unless reset by turning the key to ACC for 10 minutes then the car starts?


If you have a spare set of keys try using the different key. The identity chip in your key may be shorting.

Otherwise the "Reader" in your ignition switch may be cutting out. This puts it into an activation loop.

Nov 08, 2012 | Cars & Trucks

2 Answers

Lost set of keys, alarm was on car locked. Found spare key only, it will open door, alarm goes off, but the key won't start engine. It will turn in ignition, but dead! It's a Chevy HHR 2006! HELP


Close the doors. Lock the doors using the buttons on the key fob. Use the fob to again unlock the doors. The key should then work the ignition. If this will not work, you will have to tow your vehicle to the dealer and buy a new key and/or fob and have it programmed to the vehicle.

May 13, 2012 | 2006 Chevrolet HHR

3 Answers

2009 HHR won't start. Battery is good.


Is the security light on or blinking?If not then do you have power to the starter.You can check this with a test light.You should have power when you turn the key to start.The test light should light up.Should be the small wire.I believe it is purple in color.If the security light is on then you will have to get the codes to see what is causing the no start.Hope this helps.Good luck.

Dec 07, 2011 | 2009 Chevrolet HHR

1 Answer

I have 2003 model, 5-speed maual transmission. Had trouble starting engine a few times in last cople of days. Thought I didn't push clutch in all the way. Started after a couple of tries. Eventually...


If there is no "clicking noises" at all first you have to bypass the Clutch Start Switch. To do so remove two wires from the Start Switch and connect them together.
If it doesn't work trouble shoot starter and solenoid. With a wire connected to (+) terminal of the battery power up the solenoid, at the thin wire contact of the starter. You need another person to help you, in the cabin turning the ignition key in ON and start position. If starter and solenoid are O.K this will start your car. If not you have to replace the starter + solenoid assembly. Good Luck.
Sam from,
American Car Co.
862b0b2.gif

Oct 31, 2010 | 2003 Toyota Tacoma

1 Answer

2005 Hummer H2 battery went down and when I replaced it the alarm keeps going off and it will not start.


if it is the factory alarm you will have to do a relearn. G.M. uses a couple different ways to do the relearn and I would think it would be the same for hummer. turn off all acc and then turn the key to the on position wait 10 minutes you will see the light on the dash flash and go out . asap turn the key to off to on 3 times quickly and the third time leave it on on again do this 3 times for 30 minutes then after the final turning of the key 3 times on the 4th time start the car. so turn off all acc like radio , a/c ect then turn key to on in 10 minutes the light on dash will flash and go out quickly turn key from off to on 3 times and once again leave on on do that 3x for 30 minutes then start the car. that is the gm relearn for security they have one on some models that start after 10 minutes but that is usualy on the cheaper cars so just do the 30 minute.

Jun 04, 2009 | 2006 Hummer H3

1 Answer

Won'


Check connections at battery cables,should be tight & not be able to move cables.Check for corrosion at battery terminals.Also I have seen problems at the inside fuse block where a terminal burns causing similar concerns as yours.Hope this helps

May 11, 2009 | 1994 Saturn Sl

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

428 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...