Question about 2004 Nissan Sentra

Open Question

Looking for a nissan serena stepper motor

Could not change gears after traveling around 200km at 100km per hour. stop it for 15mins will start again as normal. shall i change the gear box completely or step motor or the electrical cables. this hapens mostly if the air conditioner is on or when traveling during the when is hot.

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

CMV9
  • 594 Answers

SOURCE: Nissan Maxima QX 1995cc 1999 - Engine hesitation and sometimes cutting out - intermittant problem

what do you mean by hunting?

Posted on Aug 10, 2008

  • 37 Answers

SOURCE: Nissan power cuts out when I step on gas

either the crank sensor, tune up, or a transmission sensor are bad

Posted on Sep 24, 2008

frcs68
  • 1605 Answers

SOURCE: nissan serena does not start

most likeliy is the ignation module located at the side of the distributor.
chekc the spark from the high voltage plug first, if no spark then you need to replace the IM.




if this answer is helpful, please rate the answer

thank you

Posted on Oct 16, 2008

fyrebyrd1
  • 121 Answers

SOURCE: Faulty Air Conditioning in a 2000 Nissan Pulsar N16

It's quite possible that your A/C compressor is locking up, thereby causing excessive load on the engine.(translates into lack of power to drive wheels) Typically there are signs, such as the noises you heard, or a slipping or thrown belt. If the compressor is locking up, being belt driven it will draw excess power from the engine. It's also possible that the compressor clutch in conjunction with compressor is going bad as well (both are usually related). That would cause excessive amperage to be drawn through the circuit, thereby blowing the fuse. Ultimately, it sounds like you have figured out your own problem, but I hope what I've posted helps.

Posted on Nov 13, 2008

  • 112 Answers

SOURCE: air conditioner is not cooling

Are you sure the compressor is engaging? It normally wont engage if the line pressure is to low(meaning the system is out of freon.)

Posted on Mar 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Loss of power


Throttle Position Sensor__ Throttle Body Cleaning___Test O2 Sensor___Check EGR Valve Clean or Replace EGR Valve.

Dec 27, 2015 | Nissan Cars & Trucks

1 Answer

I have a 2003 nissan serena after running far about 20 minite it start to make a lot of loud noise coming from the ingine and thee timming is not changing out what could be the problem i need some help...


These nissan serenas with the diesel engine suffer from the camshaft timing gear locating pin wearing out ,,Do not try to start the engine but remove the timing belt then take the camshaft gear off and look on the inside where it should have a cast lug that locates the gearwheel ,fit a new gearwheel if its locating lug is worn away ,then before you fit the big bolt you drill a 4 mm hole through the gearwheel into the camshaft so the hole into the camshaft goes in anout 6/7 mm drilling in from the front of the gearwheel then make a steel pin or cut a maisonary nail down to fit then refit the bolt so the head of the flanged bolt holds the pin in this will stop it going in the futrue ,yes i know its not a recomended type of repair according to the dealer but iam a old fleet vehicle fitter and this is the sort of modification that a proper fleet mechanic would ensure was carried out .

Nov 27, 2013 | Cars & Trucks

2 Answers

CVT jerking in 2012 Nissan Murano SL


nissan cvt's are well known for stepper motor failure.Plug the ECU onto a diagnosis machine to be sure but if the jerking is accompanied by failure to smoothly change up and down gears it is the stepper motor.If everythng else is ok check fuel pump

Jun 12, 2012 | 2012 Nissan Murano S 4dr SUV 3.5L V6 CVT...

1 Answer

I have a 2001 nissan maxima. my car sometimes would not change out of first gear only going 20 miles per hour and the rpm is dangerously high. it sounds like the engine is traveling at a high speed but the...


Welcome to fixya

Hello


I have a solution for this


Press Ok, Accept or replay so we may get started


Your pre-solution is coming up shortly


PLEASE REPLY OR LEAVE COMMENT TO CONFIRM YOU RECEIVED THIS EMAIL


My name is Bruce

Jan 16, 2011 | 2001 Nissan Maxima

1 Answer

My nissan serena will not go lower than 1200 rpm on idle any ideasno nissan dealers close to me if there was they would charge the earth


my nissan serena will not go to change auto gear system. who can solve it please help me to solve the problame.
Thank your verymuch.
Saman.

Apr 15, 2009 | 2000 Nissan Xterra

1 Answer

Nissan serena side door stuck cannot open


i have a nissan serena front wipers were moving slowly and then just stopped is this a wiper motor problem?

Oct 29, 2008 | Nissan Minivan Cars & Trucks

Not finding what you are looking for?
2004 Nissan Sentra Logo

Related Topics:

169 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...