Question about 1993 Pontiac Bonneville

Open Question

Trip meter wont reset

I click the reset button and the numbers won't reset. What do I do?

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

P1237 fuel pump driver module


Have you checked the fuel shutoff switch? it's a safety device to shut off fuel flow in case of severe front or rear impacts, but sometimes it just trips for unknown reasons. It's behind the liner on the driver's side of the trunk. Look at the round opening on top: if you can see that the red button is setting level with top of the switch it has been activated. To reset it, push the button back down until it "clicks" into place (usually 1/2 inch down or so). If it has been activated and the button will not reset the unit must be replaced, and it is a dealer only item.

May 22, 2013 | 2000 Ford Contour

1 Answer

2000 explorer won't start cranks OK, drove it to the store with no problems got back in won't turn over to start.


Try some starting fluid, if it wants to run then you need to check the Inertia switch. The location of this switch is behind the passengers foot kickpanel.

There is a Reset button that you push and it will reconnect the fuelpump. Please rate my info. You can try the Reset without testing with starting fluid but the fluid verifies fuel starvation as the problem.

Nov 19, 2012 | 2000 Ford Explorer

1 Answer

2006 chevy colorado out of the blue will not start. just makes clicking sound. Started it drove out of garage shut it off. Went back out 5 minutes later won't start. Clock even reset.


Sounds like a bad battery. A number of chain auto parts stores will check it and your charging system free. Before that, if your battery has removable caps, check the water level, if it's down, fill to the bottom of the fill rings and charge the battery, if you have a battery hydrometer, all the cells should have about the same charge level, if one or more show a lot lower than the others, battery is probably bad. Hope this helps.

Jul 29, 2012 | 2006 Chevrolet Colorado

2 Answers

2002 Ford Explorer ran out of gas put gas in and won't restart. replaced fuel pump and fuel filter still won't start. Cranks but won't start


Most Fords have a fuel reset button. When you ran out of gas you tripped the circuit. Most of the time the button will be on the passenger side by the kick panel. The exact location should be in your owners manual or your local library or auto parts store will have a copy of one for your specific vehicle.

May 08, 2012 | 2000 Cadillac Seville

1 Answer

Won't read any DVD's


Have you tried using a CD player cleaner in the unit? Try a "wet" system. One that uses a cd with tiny brushes on it that you pour a little (included) cleaner on it and run it in the player as if it were any other cd. They have worked miracles for me in the past. Also, although I'm not sure about Kenwoods, I have had a number of aftermarket head units and they have all had. "Reset" button on them. I usually find them on the front located behind the faceplate. Simply remove cd's, press and hold button (with ballpoint pen) for 10- 20 seconds. This will require you to reset time, memory etc... Good luck!

Jan 16, 2012 | Cars & Trucks

1 Answer

Reset oil light


If you have steering wheel controls you can reset it by getting to the oil life indicator (mine is on the left side lower button menu when wheel is facing forward). Then press the arrow button for a few seconds to reset it. If you don't have steering wheel controls you can reset it by turning key to on position but don't start vehicle. Press gas pedal all the way to the floor three times (some say 6 times). Turn key off. Oil life should be reset went you start engine next time. I hope this works for you.

Dec 30, 2011 | 2003 Chevrolet Silverado 1500

1 Answer

How do I reset the computer after changing the battery in my 2004 mini cooper S? The car started three times. Now it won't start even though all of the other electrics work


Turn off ignition. Press and hold the trip reset button, then turn the ignition on (don't start the engine), within 5 sec the SIA status will be displayed. Release the reset button. Press and hold the trip reset button for 5 sec, "rst" will be displayed. Release and re-press trip reset button.

The new status should be displayed.

Oct 02, 2011 | 2004 Mini Cooper

1 Answer

1995 geo tracker won't start. I've replaced everything except the ignition switch. It used to click when i turn the key, now it won't even click.


DISCONNECT YOUR BATTERY AND RECONNECT, THIS SHOULD RESET THE BRAIN.

ALSO...WHEN YOU TURN THE KEY, LISTEN TO HEAR IF YOU CAN HEAR THE FUEL PUMP COME ON...IF NOT, GUESS WHAT? HOPEFULLY NOT!... BUT,YOU MAY NEED TO REPLACE THE FUEL PUMP, IF YOU CAN'T HEAR IT WHEN YOU TURN THE KEY, AFTER YOU'VE RESET THE BATTERY!

HOPE THIS HELPS!

Aug 30, 2011 | Geo Tracker Cars & Trucks

1 Answer

I was wondering if you could give me some things to check on my van won't start and we tried jumping it. The lights all come on with full charge . So I was wanting to know if there is a reset button...


if u unplug your battery for acouple hours it will reset youre ecu/cpu. (everything) does it turn over? or absolutly nothing? if nothing sometimes ur battery loses so many electrolytes it can't retain a charge therefore jumping won't help. new battery first step! local junkyards probably have a good battery for $20. Let me know if this helps.

May 15, 2011 | 2009 Volkswagen Routan

Not finding what you are looking for?
1993 Pontiac Bonneville Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

77544 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8826 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...