Question about Mini Cars & Trucks

Open Question

Eml light on r56 mini also outside temperature showing as - 40 on clock?

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

fastboyz
  • 674 Answers

SOURCE: eml on my mini coopers dash board

you have a problem in your emissions and you need to get the code pulled so you can find the problem

Posted on Sep 28, 2008

  • 3 Answers

SOURCE: eml on my mini coopers

the engine control unit has detected a fault light illuminated which in turn reduces ability to gain high revs as a damage limitation exercise , known as limp home , car requires diagnostic computer to check fault codes to indicate faulty component causing ecu to go into limp home mode

Posted on Oct 13, 2008

  • 11 Answers

SOURCE: Neither the Outside Temperature/Clock lights nor

Check the fuse box the controls the lights in the engine compartment. You may need to replace the fuse.

Posted on Sep 11, 2009

  • 271 Answers

SOURCE: outside temperature display is widely inaccurate.

Change heater output temperature sensor.That is a SAAB dealer job.

Posted on Apr 30, 2010

timsauto123
  • 750 Answers

SOURCE: what causes my increased emission light to come on

check gas cap.











tim

Posted on Dec 20, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi the outside temperature display only showing a few lines and the time (clock) has a few lines missing. Mercedes E280 W210 series, can this be repaired. Thanks Frans Hefer 082 903 4228


it seems like the mini display is having an issue there and may need replacing contact Mercedes and they maybe able to replace the dash cluster for you

Jan 06, 2017 | Mercedes-Benz E-Class Cars & Trucks

1 Answer

Keep loosing clock have to re set each time I get in also parking assist stopped


Sounds like it may be a bad fuse.. try checking the fuse box, either the one under the hod, or the one somewhere on the drivers or passenger side dash. there should be a map to which fuses are for what purpose. it may say park assist, or could be marked something about radio, or clock. If not a fuse, it may be a faulty wire somewhere.

Feb 22, 2015 | 2007 Mini Cooper R56

1 Answer

Where does one find the signal ligt flasher unit on a MINI Cooper S R56 Hatchback?


Newer vehicles have the flasher built into the hazard switch.

Feb 05, 2015 | Mini Cars & Trucks

1 Answer

Eml light warning is on and the 2006 Mini Cooper S lost power, the car also had a misfire (P0303) . I replaced the spark plugs, wires and coil pack. Problem still here,


misfires are also caused by low fuel pressure injector electronics faults and faulty injector tips . Replacing plugs is half the fix

Aug 10, 2014 | 2006 Mini Cooper S

1 Answer

Ambient air sensor on 2005 Chrysler Town and Country showing -40


I would suspect the outise air temp sensor is defective, replace it. It is located in front of the AC condensor core.

Jul 19, 2012 | Cars & Trucks

1 Answer

1999 VW Beetle outside temp display not working


For general awareness, the outside air temperature sensor is located above the inside mirror.
Try to reset the temperature measurement unit: 1. Switch engine on. 2. Press and hold clock minute (min) and hour (h) buttons simultaneoutly longer than 3 seconds. The display will show new temperature measurement unit. 

Apr 03, 2009 | 2000 Volkswagen Beetle

4 Answers

Eml on my mini coopers


the engine control unit has detected a fault light illuminated which in turn reduces ability to gain high revs as a damage limitation exercise , known as limp home , car requires diagnostic computer to check fault codes to indicate faulty component causing ecu to go into limp home mode

Sep 28, 2008 | 2003 Mini Cooper

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mini Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75066 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Mini Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...