Question about Cars & Trucks

1 Answer

Car vibrates in the front in when turning to the right but when turning to left it stopsAlso when accelerating it vibrates feel bad but when I let off the gas it stops. Could it be a bad motor mounts or Wheel bearing.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 15,478 Answers

CV joint! They are not easy to replace yourself

Posted on Apr 26, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Loud hum/vibration on acceleration - Saab 95 Linear 2.3t

I have the same issue. I have a harmonic hum that appears to come from the rear of the vehicle but with a vibration through the floor board. I have a 2009, Saab, 95. Have had the wheel bearings replace and rotators. The noise was load when you pulled up on the emergy brake one level. Adjusted assembly but still have hum.

Posted on Oct 29, 2010

  • 15 Answers

SOURCE: Front End noise and vibration

Check the U-joints and axle baerings. But its most likely because the truck is in four wheel drive.

Posted on Oct 22, 2008

  • 79 Answers

SOURCE: Vibration and noise from front end while driving

Jack up the front end and put stands under it and block rear wheels. Look at axle boots and see if they are cracked. Try turning wheel back and forth sharply and see if you can hear any clicking. Problem could be outer axle joints. If the boots are cracked or you hear a clicking noise you will have to replace the axle. The axle and boot come as a complete unit. Please let me know what you find out.

Posted on Apr 15, 2009

  • 1118 Answers

SOURCE: 2004 camry, vibration right front

If the wheel is in balance and there is no other signs of what is causing the vibration than yes that cv joint should be chk. Is the strut ok? might want to chk. that too.

Posted on May 31, 2009

  • 25 Answers

SOURCE: 2004 audi a4 1.8 t cabriolet..car begins to shake

Are you getting any error codes? Is the check engine light on and/or blinking? The vibrating and other symptoms you described are common from shorted ignition coils. It also sounds like there's a separate issue with power steering - check your fluids, pump, and hoses.

Posted on Sep 30, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 F350 6L Diesel, 6 speed manual transmission. Vibration/noise right front when under medium to heavy acceleration, vibration/noise becomes very prominent starting at 1900 rpm in all gears (still can...


Rob, assuming this is a 4X4? Sounds like a bearing. They can vibrate, snap, clunk, all kinds of terrible noises or vibrations.
Axle u joints will also do this. Is it all wheel drive?

Nov 02, 2013 | Ford F-350 Cars & Trucks

1 Answer

2011 Kia sorento front end vibration when turning


Check front wheel bearings for adjustment. Check cv joints are not worn. Check suspension rubbers. Check tie rod ends for wear. Check the bushes of the tie rods that hold the wheels in alignment

Feb 25, 2013 | 2011 Kia Sorento

1 Answer

My chevy impala starts vibrating as i accelerate


Have the outer front drive axle CV joints checked and do it soon.

Aug 30, 2012 | 2004 Chevrolet Impala

1 Answer

Bad vibration on right front tire even after new tires


Does it feel like its coming from the front or a certain side in the front and can you feel it in the steering wheel or brake pedal.Is it only at certain speeds accelerating,braking,decelerating or is it constant.

Jul 16, 2012 | 2003 Kia Sedona

1 Answer

Vibration coming from front axle when coming to a stop it gets worse, brakes are good , maybe cv joint?


if you feel the pulsation in brake pedal when stopping. its a warped brake rotor thats causing it. for bad cv joint symtoms--- Unusual noises when making turns. As you are driving on the road and you make a turn at the corner, if you start hearing unusual sounds coming from under the car then this is one of the symptoms of a bad CV joint. These noises will sound like something is clicking beneath the car every time you turn the steering wheel. Evidence of a damaged boot. Steering wheel feels heavier. The steering wheel will start to feel tighter and heavier and you can hardly make simple turns to the left or right. In severe cases you might even feel heavy vibrations like you are driving down a rocky road.

May 02, 2012 | 2004 Jeep Grand Cherokee

1 Answer

2001 Impala, strong right to left vibration felt in the front end ONLY when accelerating, NOT felt through steering wheel NOT felt when coasting, or slowing down, strait or turning vehicle tracks...


Has to be a drive axle,most likely an inner joint,should be able to feel the play if one is bad (jacked up to let the wheel spin freely).
Also. If the front suspension is weak,or lowered, the CV axle will bottom out in the inner plunge cup and make a terrible vibration.

Feb 02, 2011 | 2001 Chevrolet Impala

1 Answer

Very LOUD banging noise from front left wheel


the right outer tierodending needs replaced.

Apr 03, 2010 | 2001 Chevrolet Impala

1 Answer

2002 monte carlo front end vibration


Does the left front go click, click, click on tight slow turns.

Jul 07, 2009 | 2002 Chevrolet Monte Carlo

2 Answers

2001 Century Front End Vibration


Me too i think it a cv joint problem a cv joint got 3 rond bearing when turning each rond ball goes in a chanel it spin in there sometime that chanel get damaged a little hole appear and in occasion the ball get stuck in that hole and that your bad vibration i gave you example

Jun 23, 2009 | 2001 Buick Century

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...