Question about 2006 Dodge Stratus

1 Answer

Where is number 2 cyinder at - 2006 Dodge Stratus

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Dodge Master
  • 5,628 Answers

This car has coils if has look #2 coil and follow wire.

Posted on Apr 25, 2013

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My compression on cyinder 1 and 4 are at 152 but 2 and 3 are at 190 psi


It is a bit odd to get the same low compression in 2 cylinders so far apart. Are you sure you are measuring the compression at those 1 and 4 cylinders properly. Confirm you are following the right procedure for measuring the compression. If you have got the right readings then you likely have a head problem because rings tend not to go bad like that at the same time. Could be a warped head or valve issues. You might be noticing pressure related issues in the crankcase or poor running due to the pressure bypassing the exhaust.

Nov 19, 2013 | 1992 Saturn SL1

1 Answer

2000 daewoo lanos code po202 po302


It is P0202 and P0302
P0202 - Fuel Injector Circuit Malfunction Cylinder 2
Most likely cause a failed fuel injector or shorted wiring harness.
P0302 is a misfire in cyinder #2 from the injector problem.

Nov 05, 2012 | 2000 Daewoo Lanos

1 Answer

Kia cord po019


P0019 KIA - Crankshaft/Camshaft Correlation Error engine cyinder Bank 2 Sensor 2

Possible causes- Dirty Oil
- Engine mechanical problems
- Camshaft timing incorrectly set
- Faulty camshaft position sensor
- Faulty crankshaft position sensor
- Faulty actuator assembly

Jun 26, 2012 | Kia Cars & Trucks

1 Answer

Where is knock sensor on bank 2 on 2.0 neon


There is just one bank of cyinder since thjis is afour banger. the knock sensor is located at the rear of the engine about middle of the block.

Jun 19, 2012 | 2006 Chrysler Pacifica

1 Answer

Brake pad stick get hot


did both rear wheels get hot? if only one then perhaps the wheel cylinder is seized if both then maybe the pads are 2 thick or the master cyinder is seizing

May 22, 2012 | GMC Cars & Trucks

1 Answer

Have code p0300 active just replaced fuel pump, all spark plugs, wires, cap, and rotor, engine back fires, and has explosion in the air filter area


Code p0300 is multi- misfires [ any number of the cyinders ]. Sometimes when a fuel pump is replaced, the system will have air inside and will mis & backfire untill the air is cleared back thru the return line, or blead out the test port. This will set the p0300 code. It's rare to have a backfire bad enough to have an explosion, bleed the lines thru the test port untill you see no more bubbles comming out.

Jun 28, 2011 | 2003 Chevrolet Silverado 1500

2 Answers

Need to know where cylinder number 4 is


here is a picture of the engine cylinder and how they are numbered.

5c64b6a.gifSo #4 is the fron left cyinder in the cylinder bank closest to the radiator.

Oct 22, 2010 | 2004 Mazda MPV

1 Answer

Bleed Clutch @ slave cyl.


most clutch and slave cyinders bleed by constantly working the clutch pedal. its tiring and can be a long process. Also keep an eye on the fluid level because u are trying to remove the air in the line and not let additinal air in.

What i have done before is pump pedal slowly aboout 10 times then check the fluid level and add if needed. repeat untill the level does not need to be topped off again. Best done with 2 ppl as u can rotate the pedal pumping duty.

Oct 05, 2009 | 1992 Jeep Wrangler

Not finding what you are looking for?
2006 Dodge Stratus Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...