Question about Cars & Trucks

1 Answer

Kawazaki kz1000 1980 kz1000j won't start battery is good but barely turns over

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 18 Answers

What you need to do is check you fuel pressure. Go to a local auto parts store and buy a fuel injection pressure tester. The pressure fitting is on the top of the motor its a 3/8 ish sized metal line and has a screw on fitting like a tire valve does. This line comes up from the back of the motor to the right of the distributor and goes down into the intake. Make sure to have a rag handy to catch the fuel seepage. After you connect the pressure tester turn the key on and off three times and read the gage you should have atleast 58 pounds of pressure. If you have 56 pounds it won't run because the fuel injectors are a poppit valve style and need atleast 58 pounds of pressure to operate.

Posted on Apr 25, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 116 Answers

SOURCE: 2007 chevy cobalt ls won't

Ignition relay or fuse could be the problem. When you turn the key to start do you hear a fuel pump kicking on and or do you have spark when you hot wire the starter (I know it's hard to check while trying to start it)? You can email me back and I might be able to pinpoint it more.

Posted on Jun 06, 2011

jgwhomeequip
  • 1902 Answers

SOURCE: the car won't start; lights,

Check the starter and the starter relay or fuse. A client of mines car was doing the same thing, it ended up being two issues, the starter not working anymore, and a relay that was bad. If I am not mistaken everything should be labeled in the fuse box under the hood and will tell you where the fuse/ relay is for your vehicle

Posted on Jun 12, 2011

ginko
  • 19396 Answers

SOURCE: 1994 BMW 740i with 222,000

Hi.

If it does turn over and electrical works, then the problem is unlikely the battery. You can try jump starting. If it cranks when jump-starting it may be a weak battery, starter motor or alternator, but I don't think that this is the problem.

Check if there is spark on all cylinders. Do a code scanning (this car is OBD1, you will need to do the scan at the dealer place or to find a BMW OBD1 tool- Universal OBD2 scanner will not work on a 1994 BMW). If the codes return misfire or mixture related errors check fuel pressure, check sensors and parts that determine the mixture (MAF/MAP, AIT, O2 sensors, IAC and EGR system), check the vacuum system for leaks and check the crank sensor.

Regards.

Ginko

Posted on Aug 08, 2011

SOURCE: My Volvo s60 won't start

you will need to try to turn the engine manually to make sure its not frooze. if it turns then you might need to check the starter again.

Posted on Aug 30, 2011

  • 2 Answers

SOURCE: 1999 CHEVY LUNINA WON'T START BATTERY AND

Check the dash once you turn the key to the run position the passlock runs a security check using a set resistance value through the chip in the key. If the security light begins to flash the reading it received was incorrect or it didn't get a reading at all. You can try reseting the value it is looking for by turning the key to start then releasing it. After 10 minutes turn it off then cycle it start again leaving it in on for 10 minutes then back to off then one more time. After the third cycle has completed for a total of 30 minutes. You should be able to turn the key on and start the vehicle. If the light continues to flash their is a problem with the chip in the key or the connections within the ignition its self. Both are common but a Pass Lock Relearn as described above will usually adapt to the poor connection values. Hope this helps.

Posted on Sep 09, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1987 oldsmobile 98, I replaced the battery and the car still won't start ?


maybe the points need adjusting or check the exhaust at rear and see what tis colour black inside...... may need decarbonising.

Jan 15, 2013 | Cars & Trucks

1 Answer

My 1992 Toyota Celica GTS (2.2) Won't start. The battery cable (+) came undone, and I had stripped it and reattatched it, and now the door open light will come on when I open the door, but the min


you dont have a good enough connection from the battery to the ground or the live wire on the battery is a weak connection.. Run a new wire from the negative side of the battery and attach it to the body somewhere to a nut but bare the paint to do so and clean the bolt so you get good contact, can also run a wire to a bolt on the engine. Also check the connections to the battery both positive and neg and clean the battery terminals and cable terminals. A corroded terminal reduces cranking power by 80 percent.

Dec 17, 2017 | Cars & Trucks

2 Answers

It won't turn over


Try this procedure:
Check the battery like this:
Turn on the headlights, then try to start the car.
If the headlights do not dim or go out, then the battery is likely ok.
Check that the battery cable plus post, goes to the starter, Minus post to a good ground, like the engine.
If wiring is ok, then look at the starter solenoid for a good connection, and proper voltage at the starter.
Problem is most likely the Solenoid's bendix gear or starting relay, Have someone bang on the starter while you try to start the car. This usually works by dislodging the bendix gear..
Hope this helps.

Jul 27, 2012 | 1994 Oldsmobile Cutlass Ciera

1 Answer

Cant hear fuel pump, won't start 98 gmc sierra 1500


THAT PART ABOUT BARELY GETTING HOME BOTHERS ME LOW VOLTAGE TO COMPUTER CAN BURN IT OUT HAVE IT TESTED GOOD LUCK CHECK RED FUSES

Dec 22, 2011 | 1998 GMC Sierra

1 Answer

My Volvo s60 won't start replaced battery and starter and still won't start battery test fine what can I do I have good power throught out


you will need to try to turn the engine manually to make sure its not frooze. if it turns then you might need to check the starter again.

Aug 28, 2011 | 2001 Volvo S60

1 Answer

My 2000 Chevy Impala won't turn over


1st, make sure that your car's battery is in good condition, if so, then check the battery cables out to make sure they are tight, and not corroded. if they are corroded with acid, you can clean them with a solution of water and baking soda, then rinse the cables off , and dry them off. you mentioned that your car won't turn over, do you mean not starting, or just won't try to start, either way, you can check out the start relay, located under the hood in a black box, on the drivers side.

May 10, 2011 | 2000 Chevrolet Impala

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

80637 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

15427 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...