Question about 2009 Dodge Journey

1 Answer

What voltage should alternator put out for a Dodge Journey 2009 2.4L 4 cylinder

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Dodge Master
  • 5,649 Answers

Should be 14.5+V mean good alternator.

Posted on Apr 25, 2013

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Dodge Journey 2011 alternator replacement


https://www.youtube.com/watch?v=v5QqYUbjrj4

https://www.youtube.com/watch?v=kr1PLeA26WQ

Hope these help

Nov 14, 2016 | 2011 Dodge Journey

1 Answer

I need the firing order for a 2010 dodge journey sxt 3.5l


Firing order is 1-2-3-4-5-6. #1 cylinder is rear bank on passenger side (1-3-5 on rear bank, 2-4-6 on front bank).

Oct 17, 2016 | 2010 Dodge Journey

1 Answer

Trying to figure out alternator fuse number on 2010 Dodge journey sxt don't see the word alternator on fuse box have new battery and alternator but still goes click click when trying to start it


The alternator fuse has nothing to do with that . If starter solenoid is just clicking an you have a new battery it's more then likely battery cables or connections . To test the starter circuit you need to do voltage drop testing . The alternator doesn't start working till the vehicle starts an is running . Starter Voltage Drop

Oct 02, 2016 | 2010 Dodge Journey SXT

1 Answer

My dodge caravan 4 cylinder engine has trouble codes 0016,0113,0700,0562


code p0016refers to the crankshaft /cam shaft position sensor bank 1 sensor A-- correlation===causes---Wiring CKP sensor--CMP sensor--mechanical fault Check timing belt is not broken
code po113 refers to intake air temp (IAT) sensor--circuit malfunction===causes ---wiring open circuit/short to positive--wiring short to ground---ground wire defective IAT sensor---ECM
code mp0700 refers to transmission control system/MIL-malfunction===causes--wiring ---TCM
code po562 refers to system voltage low==causes---wiring poor connections---battery---alternator or it also refers to ECM power relay control--circuit open===causes ---wiring--ECM ---relay. For this one check the battery terminals and posts are shiny clean and tight . Have a load test done on the battery to check for faulty cell. check condition of alternator drive belt and check alternator out put.

Sep 27, 2013 | 2003 Dodge Caravan

1 Answer

Where is the starter located on a 4 cylinder 2009 dodge journey?


Lower left rear of engine as viewed from the flywheel side.

Aug 21, 2013 | 2009 Dodge Journey

2 Answers

What is the order to bleed brakes on a 2009 Dodge Journey


Start at the wheel farthest from the master cylinder and work your way to the closest for last. Typically RR, LR, RF, LF.

lp

Jan 11, 2011 | 2009 Dodge Journey

2 Answers

Ignition coils burning up code p0352 misfire on #2 and 5 cylinder check eng light on replaced four coil packs now the van is dead.


Is it possible your alternator was putting out too much voltage? Did you check that when it was running? Looking at your diagram, the only causes I can see for this problem is excess voltage or failed PCM. You might consider taking the alternator off and have it checked; but, by the way, your PCM also controls the alternator stator voltage.

d584cad.gif ea2ae39.gif

Oct 29, 2010 | 1998 Plymouth Grand Voyager

1 Answer

Charging problem


Could you clarify your engine size?

4 Cylinders K 2.5L TBI SOHC 6 Cylinders 3 3.0L FI (found in 36% of 1990 Dodge Dynasty) 6 Cylinders R 3.3L FI (found in 64% of 1990 Dodge Dynasty)


If you have the 3.3L the voltage regulators are located in the Powertrain Control Module (PCM) or Single Board Engine Controller (SBEC), depending on the model. If, after diagnosis, the regulator is deemed faulty, the PCM/SBEC must be replaced with a new one.

Hope this helps for now

Jul 06, 2008 | 1990 Dodge Dynasty

Not finding what you are looking for?
2009 Dodge Journey Logo

Related Topics:

105 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...