Question about Nissan Quest

Open Question

Reset tpms on 2005 nissan quest - Quest Nissan Cars & Trucks

Posted by Anonymous on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 15 Answers

SOURCE: Strong fuel smell in cabin. 2005 Nissan. 2005

Well first if you smell gasoline don't start the vehicle, check the entire fuel system locate the filter and check for leaking, also this vehicle uses a cabin filter to filter incoming air to the passenger compartment, locate this filter and replace it. there located sometimes behind the glove box door, or under the front cowling under the hood, in that space just under the wipers, If you can't find the solution and the smell persists, you need professional help ( with the car)

Posted on Jun 04, 2010

Ad
bendarden
  • 984 Answers

SOURCE: timeing chain tensioner replacement on a 2005 nissan quest sl

Improve the FixYa experience for everyone by voting. I want you to let me know if the solution(s) suggested were of any value. Constructive criticism is welcomed.

Hi,

I'm Ben and -- hopefully -- I can provide some meaningful assistance.

I'm not certain that I fully understand your problem. Therefore, I'm probably provide more information than you'll need.

Discussion:

A timing chain tensioner for your quest will cost $59-$75. The tensioner sits behind a small cover on the front of the engine. It;s difficult to reach but the replacement should take no more than 2 hours.

  1. Move power steering and coolant/antifreeze resevoirs out of the way for access .
  2. You may have to use a c-clamp to hold the guide and chain up out of the way.
  3. The difficult part is installing the tensioner without pulling the plunger stopper pin.

The following link is a tutorial on how to replace the chain, guide and tensioner and covers everything in far more detail than I'm permitted here. CLICK HERE

The following video should be of some additional assistance.

Posted on May 31, 2012

  • 5341 Answers

SOURCE: 05 Nissan Quest sputtering when breaking and service engine light came on

Have the fuel pressure tested to see if your pump is still performing at optimum. The test takes about 20 minutes, and will confirm if the pump and pressure regulator are doing their job.

Posted on Nov 19, 2012

  • 44524 Answers

SOURCE: I can't seem to locate the blower motor resistor for my 2005 Nissan quest.can you help me?

normally in the blower motor enclosure as it uses air flow to help cool the resistors

Posted on Mar 23, 2013

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

One day TPMS sensor light was on on my instrument panel so I went to the repair shop so they reset it with the diagnosis machine and the sensor light was gone from the instrument panel temporarily. The...


The TMPS device in the tire attached to the wheel once introduced to the TPMS computer receiver it continuously checks air pressure and sends that info to the reciver (each whel does this) the reveiver compares the pressure data betwen the 4 wheels. If they are not the same it will put up a message to the dash TPMS icon.

So if all of your wheel sensors are sending messages and you are getting a message tire low -- they are working.
If you simply get the TMPS symbol or lettring and it is only becuase of one wheel -- replace the wheel sensor.
If all wheels are not working (each one off and on) then have technician remove the the electronic hadnshake for the car to the 4 wheels and then reintroduce the wheels to the car. If that fails then have the revieving computer check for faults and replace or replace it.
Note the wheel sensors each have a battery -- hence the batteries can go dead. Some sensors can have the battery repplaced. It is recommended that all 4 be done at the same time.

Dec 26, 2014 | 2007 Nissan Quest 3.5 Minivan

1 Answer

Reset low tire pressure light on 2005 nissan titan


Hi David,here's a link to read to see how to to get your light to go out. How to Reset TPMs on the Nissan Titan eHow

Oct 24, 2014 | 2005 Nissan Titan

1 Answer

HOW DO YOU RESET THE TPMS ON 06 NISSAN PATHFINDER


If the wheel tpms sensors work,when you turn on the
ignition switch, the dash light should go off in one second

When you drive 16mph the system is activated & if
tire pressure in the 4 driven wheels are okey, the light
stays off

Other wise you have tire & sensor work to do

Aug 27, 2014 | 2006 Nissan Pathfinder

1 Answer

How do you reset the tpms with no tools?


you mean if a tire is low? just set all tires to the spec on the drivers door, it should reset itself. If there is a problem with a sensor, a scanner will be needed to determine which one.

Sep 16, 2011 | 2006 Nissan Quest

1 Answer

I have a 2005 Nissan quest and I'm getting a p0507


No..you can't adjust the idle...

Possible cause---Electric throttle control actuator, intake air leak or PVC system...check these 3 things...

Jun 04, 2011 | 2005 Nissan Quest

1 Answer

How do you turn of a check engine light off on Nissan Quest 2005


There are two ways to turn off the light. The preferred way is to have the car scanned and at the end of the scan, have the light reset. The other way is to disconnect the battery for a minute. When you reconnect the battery you will find that the check enging light is off.

Nov 21, 2009 | 2007 Nissan Quest 3.5 Minivan

1 Answer

2005 NIssan quest camshaft sensor


for a Nissan Quest, it is in the distributor. Not serviceable, replace distributor. Famous for nearing failing and getting brown dust on optical sensor for camshaft sensor. buy on ebay for $200. Cleaning optical sensor is temp repair.

Call dealer & see if yours is there too.

Jun 21, 2009 | 1997 Nissan Quest

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

74 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...