Question about 2009 Hyundai Elantra

Open Question

How do I replace ac/heater blower switch on 2009 Elantra Haundai?

The ac/heater blower switch on works on #4

Posted by Anonymous on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 53 Answers

SOURCE: how can i remove and replace the heater/ac flow controller on my 03 elantra?

are u convinced it is a controller issue as this is rare on that vehicale i am more tempted to say that it is a cable problem. Or a door acuator if it is auto temp control

Posted on Oct 19, 2008

  • 341 Answers

SOURCE: 2004 elantra heater control only operates at #4 setting

If # 4 is the highest fan setting it might be the resistor pack that controls the fan speeds.For each speed increase the fan switch takes a resistor out of the resistor loop The highest speed is a direct connection to the battery. The switch is usually located very close to the fan since it gets quite hot and needs to be cooled by the fan.It is also generaly accessible from under the hood,but not always.Sometimes it is under the dash Hope this helps.

Posted on Dec 09, 2008

  • 1 Answer

SOURCE: need to replace dash board backlights - 2004 hyundai elantra

trying to do the same on my 01. ready to change the bulb but can't find it anywhere.
anyhow, here's how you do it:

remove the dash by taking out 2 screws behind the ashtray and 2 above the instrument cluster
begin prying off the dash from the ashtray up, when you reach the heater vents stop. next take a flat head screwdriver and pry off the dash from the left side with the door open. work left to right till you reach the heater vents and it'll come right off. you don't necessarily have to unplug any of the electric connectors if you don't want to, but you;ll have to reach around the dash while working. all you need to do now is remove the heater control unit via the 4 screws around it, then unplug the electric harnesses from the back of it. make sure you remember which goes where. the bulbs are the 3 white (or is it 2 white and 1 grey) circles on the back of the control unit. just turn them with a flathead screwdriver and turn it over and give it a little bump to get 'em to fall out (or grab 'em with a needle nose pliers if necessary). anyhow, that's how it's done, question is, where do ya find the bulbs?

Posted on Jul 10, 2009

  • 27 Answers

SOURCE: 2000 elantra heater blower stopped working

Check fuse for blower first, or you may need a new one

Posted on Dec 17, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2009 buick lucerne, heater/ac fan intermittent working, then quit. Have already replaced climate control panel, blower resistor and blower motor. Still nothing. Anyone?


My Lesabre did that and I am not sure how my mechanic did it but he said it would cost an arm and leg to repair it so he hooked up a separate switch under the dash and everything worked after that. a seventy five dollar fix is better than three hundred. See if your mechanic has an idea. He said the off and on part of the automatic switch was not working but after he put an off and on switch in the line the climate control worked.

Dec 16, 2016 | 2009 Buick Lucerne

1 Answer

1977 Buick blower / fan comes on however NO heat blower / fan also blows very low.


Buick LeSabre Heater - RepairPal

repairpal.com > Problems > Buick > LeSabre
Buick LeSabre Heater blows only cool air...even w/ defroster on. This is a ... Heater fandoesn't come on . ... The blower works but there is no heat coming out.

Blower Motor Problems ' Auto Repair Help - YouTube

? 4:22
https://www.youtube.com/watch?v=2vmfxYg8LoY
Sep 27, 2009 - Uploaded by mgittelman
The blower motor is a common heater/AC repair within the skill level of ... However if the power wire is a single light purple wire and the ... for blower motor and fuel and relay good but no powercoming on both any ideas? ... my o5 seira, when i start the engine with the air switch on it blows my blower fan ...

Car Air Not Blowing, Heat & Air "How to" Test Testing ...

? 6:22
https://www.youtube.com/watch?v=hgar6Q1lV6A
Apr 5, 2013 - Uploaded by Fixbook
Here I show how to determine the problem if your air, or blowermotor is not ... Click here to check out the the "Car Runs on 2 cylinders" series: ... How to Fix Over-Heating engine & No Heat in car - Buick (2000 yr) Park Ave . ... Car fan / AC only works on high - Replacing the Blower Resistor - Duration: 4:24.

Buick Park Avenue Questions - NO HEAT!!! - CarGurus




Jan 30, 2016 | 1977 Buick Electra

1 Answer

2000 grand prix, temperature won go from ac to heat, stuck on ac.


Pontiac Grand Prix Climate Control/AC - Car Forums at Edmunds.com

forums.edmunds.com > Pontiac > Pontiac Grand Prix
Dec 29, 2007 - 30 posts - ‎20 authors Hi Joe, I had the same problem with no heat on my 2000 grand prix. .... motor and the exterior temperature sensor have both been replaced ... Pontiac Grand Prix Electrical/Lighting
30 posts
Aug 3, 2009
Pontiac Grand Prix Heater blower relay switch
30 posts
May 13, 2009
Pontiac Grand Prix Starting / Stalling Issues
30 posts
Feb 9, 2008
More results from forums.edmunds.com

Fixing AC Temperature Control on my 2002 Pontiac Grand ...

? 9:58
www.youtube.com/watch?v=2BOdhWMdxXc

Jul 13, 2014 - Uploaded by Turbo231
Fixing AC Temperature Control on my 2002 Pontiac Grand Prix... How To Install Replace AC Heater ...

Oct 15, 2015 | 2000 Pontiac Grand Prix SE

1 Answer

THE AC WONT BLOW OR THE HEATER


CHECK BLOWER MOTOR FUSE AND RELAY.IF BOTH GOOD.REMOVE BLOWER MOTOR HOTWIRE IT.IF DONT WORK REPLACE BLOWER MOTOR.IF BLOWER MOTOR WORKS.HEATER AND AC CONTROL SWITCH IS BAD.

Apr 30, 2010 | 2005 Chevrolet TrailBlazer

1 Answer

Ac/ heater fan only works on #4 high . is it the switch or the fan itself ? #1-3 nothing . ac is cold and heater is still hot.


u will need to replace the blower motor resistor, it is located next to the blower motor under the hood on the passenger side

Nov 02, 2009 | 2001 Ford Explorer Sport

3 Answers

Blower speeds on ac/heater for 2003 chevy pickup(v6)


Hi, sounds like your blower motor resistor needs to be replaced. If not the resistor, check the blower motor.

Jul 27, 2009 | 2008 Dodge Ram Pickup 1500

1 Answer

2004 Ford F150 - AC/Heater blower speed 1 & 2 not working.


You might have a bad speed selector switch, or your blower motor resistor is faulty.

Mar 17, 2009 | 2004 Ford F150

1 Answer

Heater & ac


this is usually a bad blower motor resistor. It is usually where your blower motor is and it could be behind or under your glove box.

Jan 23, 2009 | 2001 Hyundai Elantra

Not finding what you are looking for?
2009 Hyundai Elantra Logo

Related Topics:

77 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...