Question about 1992 Mazda 626

Open Question

Cant get the transmission out of drive in all gears

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My Isuzu kb250 diesel engine model 2008 it doesn't want to take gears when running


YOU probably have a problem with the clutch not fully releasing when you are driving.


Clutch Drag Kills Synchros

Feb 02, 2016 | Isuzu Cars & Trucks

1 Answer

My 2010 chevy hhr is stuck in park wont go into gear transmission auto I start the car push down on the brake and cant move the shifter at all cant put it in drive or any gear


Look on the brake pedal lever for an electric switch. Replace the switch and see if that works. If not, get under the vehicle and look for a loose wire on the transmission. If this doesn't work, you will have to take the vehicle to a transmission shop. There is likely a loose wire or a bad servo inside the transmission. But the shop will first run a diagnostic check. They will then know what the problem is and repair it.

Feb 03, 2015 | 2010 Chevrolet HHR

1 Answer

CAR IS IN GEAR AND WONT MOVE...WHERE IS THE TRANSMISSION DIPSTICK?


Should be on the driver's side near the transaxle.

Jul 18, 2012 | 2001 Oldsmobile Alero

1 Answer

How to check transmission fluid level? with the engine idling or?


TRANSMISSION CANT BE TOO HOT AFTER DOING A LOT OF DRIVING.BEST TIME TO CHECK TRANSMISSION FLUID WHEN ENGINE COOL.TO CHECK FLUID LEVEL.CRANK ENGINE UP.LET IT IDLE UNTIL ENGINE AND TRANSMISSION GET WARM. WITH ENGINE IDLING.SHIFT TRANSMISSION FROM PARK TO LOW 1 GEAR. TWICE DO EACH GEARS AT ONE TIME. WITH TRANSMISSION BACK IN PARK.CHECK TRANSMISSION FLUID LEVEL ON DIP STICK SHOULD BE AT THE FULL MARK IF NOT ADD A PINT AT A TIME TO GET TRANSMISSION FLUID LEVEL CORRECT. DONT OVER FILL.

Aug 18, 2011 | 2002 Ford Mustang

1 Answer

1995 lincoln occasionally has problems getting in gear to go. Seems like it is stuck in neutral. Lasts a few seconds then it gets into gear and goes.


SEEMS LIKE TRANSMISSION FLUID LOW.TRANSMISSION SLIPPING TRYING TO GO IN DRIVE.CHECK TRANSMISSION FLUID LEVEL. IF LOW ADD FLUID UNTIL YOU REACH FULL MARK ON TRANSMISSION DIP STICK. WITH ENGINE RUNNING A IN OPERATING TEMPERATURE.IF FLUID LEVEL OKAY.CHANGE TRANSMISSION FLUID AND FILTER IF YOU HAVE NOT CHANGED IN A LONG WHILE.A DIRTY STOPPED UP FILTER WILL CAUSE TRANSMISSION TO SLIP.CANT PICK UP FLUID.

Dec 26, 2010 | 1995 Lincoln Town Car

1 Answer

My car wouldnt shift into first nor reverse


you have a definate concern inside the transmission your gears are marred badly the gears 2-5 are synchrnized and helical style for smooth shifting 1st and reverse are spur cut so you cant accidentally shift into these gears while driving i would look for a good used transmission

May 03, 2010 | 1999 Volkswagen Passat

2 Answers

Cant get vehicle to drive when vehicle is put into drive it not take gear


Have you checked the transmission fluid level? If the level is ok, you need to get the transmission checked out. Does reverse or any other gear work?

Sep 30, 2009 | 1999 Land Rover Range Rover

1 Answer

96 jeep lardeo cant use reverse what can be wrong


Have you checked the transmission oil? how does it drive in other gears, if the oil level is ok and drive in other gears is fine then I suspect you have an internal transmission fault with the reverse gear.

Dec 02, 2008 | 1996 Jeep Grand Cherokee

2 Answers

Cant select gears


i have seen these break shifter cables often

Jun 15, 2008 | 1999 Mercury Sable

Not finding what you are looking for?
1992 Mazda 626 Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...