Question about Cars & Trucks

Open Question

My headlights and high beams stopped working on my 1980 toyota supra. We're is the fuse for the headlights located? Or what else could it be?

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The headlights and high-beam search lights on my 1987 Toyota land cruiser wont turn on. Is this a fuse problem? If so where is the corresponding fuse/fuse-box located? I've already look on the und


The left and right headlights are on different fuses. If both are not working, you need to check the fusible link, headlight relay, and the switch itself. See diagram below.
0900c1528004d7e2-dwbgzyjx1s1bj3innjxcfx0i-3-0.gif

Jun 15, 2017 | 1987 Toyota Land Cruiser

3 Answers

Daytime Running Lights Inoperative 2002 Toyota Camry


[Information] For a 2002 Toyota Camry, the Daytime Running Lights (DRL) operate utilizing the High Beams (inner Lamps closer to the center of the vehicle front) at a reduced power.

[The troubleshooting process:] Review the Owner's Manual and ensure the test configuration matches the following criteria:
1. According to the 2002 Toyota Camry Owner's Manual (Check your Owners Manual):
"The DRL system will make your headlights come on at a reduced brightness when:
The light switch s in the "DRL" position.
The ignition is on with the engine running.
The headlight switch is off.
The parking brake is released."


2. Set the Test Conditions according to Step 1 above.

3. Check the headlight bulbs to ensure they are not burned out. If one burns out, there is a fair chance that the other would have burned out at the same time. Replace as necessary. In this case, if the high beams operate, the DRLs should also operate.
4. Test the system, ensuring the step 1 conditions are set. (Engine running, Multi-function Switch on Turn Signals in "DRL" position, headlight switch off (repeating what the manual says -- it should be obvious that in the "DRL" position, the headlight switch should be off / do not have the switch positioned to "High Beam"), and the Parking Brake "off").
5. If DRL lights do not work, check the engine compartment Fuse and Relay Box. there is a 5 Amp DRL fuse -- replace it with the spare. Test (step 4).
6. If it does not work, swap around or replace relays -- there are three (3). Any one of them could be bad (stuck or burned out). Test (step 4).
7. Other less likely possible issues could be that the Multi-function Switch is broken or a connection / wire is broken. [Beyond the scope of this process.]


My problem was that the test configuration did not have the engine running and parking brake off - Step 1. Problem solved with much thought, repetitive tests on the vehicle and going back to the basics -- what does the Owner's Manual say and where are the applicable fuses and relays located?

Dec 30, 2011 | 2002 Toyota Camry

4 Answers

Both Low beam headlights aren't working in my 2002


my suggestion is that you check/ replacr the HDM(headlight driver module) relay in the main fuse box located under the hood near the battery.

Jul 30, 2011 | 2002 Chevrolet TrailBlazer

2 Answers

I have a 2001 toyota celica gt. both front headlights will not come on. the high beams work. the car was hit in the front. does the headlight circuit have a fuse or a relay and where is it located. i found...


Have you checked the light globes ? The globes have a filament for each of Low and High Beams and the Low Beam ones fail much sooner than the high. A bump as you describe may have been enough for the Low beam filaments to fail as the filaments get brittle through age.

Sep 07, 2010 | 2001 Toyota Celica

2 Answers

Audi A4 2002 Low beams & Right front turn signal stopped working


For Audi A4 the fuse box is located on the left side of dashboard behind a plastic cover (for left hand steering wheel vehicle). On inner face of the plastic cover you will find the fuse diagram.
First fuse on first row from left upper corner is Fuse Nr.20 = F20 (15A) - RH headlamp low beam, headlamp adjustment.
First fuse on second row from left upper corner is Fuse Nr.21 = F21 (15A) - LH headlamp low beam, headlamp adjustment.

Feb 15, 2010 | 2002 Audi A4

2 Answers

Low beam headlights don't work


I have e-mailed you 2 .pdf files, one is the complete headlamp diagram, and the other is the relay locations. Please advise if you need further assistance.

Toyota Ed

Dec 31, 2008 | 2005 Toyota Corolla

1 Answer

Headlite high beams don't work


check bulbs first. then fuse and relay. can check for voltage to headlight with high beam selected. If none of the above it just about has to be in the switch

Dec 14, 2008 | 2005 Toyota Highlander

1 Answer

Head / fog light adjustment


on each headlamp assembly, there will be either one or two plastic nuts that you can turn.

If you only have one nut on each, that will adjust the vertical aim of the headlights.

If you have two nuts on each, one will adjust the vertical and the other will adjust the horizontal.

Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)

If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.

Jul 02, 2008 | 1994 Toyota Supra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...