Question about 2002 Chrysler Voyager

1 Answer

The removal of the front cover of the radio to pull it out of the dash

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 20 Answers

On my one pull the heater switch off and undo 4 screws on the front panel then there should be 4 screws on the radio

Posted on Jan 19, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Removeradio 1991


You will have to remove the plastic dash from around it. Some of them just snap out others require removing screws from the entire front dash panel around the instrument cluster. once the front cover( s) are removed You should see 2-4 7mm screws holding the radio assy to the dash. when you remove them the radio should pull out and you can unplug the wire harness and antenna

Sep 11, 2014 | GMC Sonoma Cars & Trucks

1 Answer

How do you change the radio in this vehicle


Not difficult... Remove the front dash cover (check for visible screws and remove them then pull gently but firmly on the cover)...the remainder should be held on by push in clips.
The radio itself is fastened by two bolts at the front. Remove them and slide radio out and disconnect harness and antenna leads. On an aftermarket radio, you will usually need an adapter harness which should be available where you bought the radio. Depending on the radio, you may also need an adapter face plate to mount it. Follow the wiring diagram for the harness that came with the radio.
If factory, just plug it in and put it back together.

Jan 30, 2011 | 1993 Jeep Cherokee Country

2 Answers

How do i remove the factory radio on my 1983 cadillac fleetwood


Hi there,

Locate and remove two (2) phillips screws that secure the top of the plastic panel that surrounds the radio. The plastic dash panel will pull off once the screws are removed as shown in the photo above.
The front of the radio is held in with two (2) 7mm bolt screws at the top of the radio. Remove the 2 bolt screws.
There is a hidden radio that secures the rear of the radio and is located under the radio. Pull the ashtray to its extended position. You will need to lay on your back or side and look behind the ashtray, up to the bottom of the radio.
Once the ashtray has been pull to its extended position, you should be able to locate and remove one (1) 7mm bolt screw as seen in the photo above.
Once all screws have been removed, the radio can then be removed. Pull firmly on the radio to remove it from the dash. The radio will most likely resist pulling from the dash. The antenna cable which plugs into the rear of the radio is very short and gives the radio resistance when trying to pull the radio out of the dash. Continue to pull firmly and the antenna cable will unplug itself as the radio is pulled from the dash.
Unplug (1) blue, (1) white, and (1) black wire harness connector(s) from the rear of the radio. There will also be wires extending from the rear of the radio with a plastic connector attached to the wires about 4 inches from the rear of the radio. Unplug this small connector. The radio can now be completely removed from the dash. Set it aside. You will need to remove the plastic brackets attached to the top and bottom of the GM radio. This will be shown in detail in the "Mount New Radio" section.

Hope these helps....

Jan 23, 2011 | Cadillac Fleetwood Cars & Trucks

1 Answer

How do I remove the factory radio on a Chev.Blazer


yes the whole front dash pulls of a few small screws and some clips thats it

Jul 29, 2010 | 2000 Chevrolet Blazer

2 Answers

How do I remove the fan switch to replace it on the dash under the radio?


Have your radio code before you pull it out with the right radio tool. This pull would involve removing this parts.
  1. Glove compartment
  2. Driver side panel
  3. Center top dash board
  4. Defrost switch carrier
  5. Radio unit
  6. Center lower half of dash
So I'd suggest go to your local public library and look for your car manual. It would be either Chiltons or Clymers manual, it's not as precise a Bentley VW Official factory repair manual. Yes it really involves taking all those parts out just to get to the rotary switch.

Apr 20, 2010 | 2000 Volkswagen Beetle

1 Answer

How do you remove the stereo


need to take off front cover of dash?unscrew the radio pull out the radio disconnect the radio

Oct 28, 2009 | 1991 Mazda 929

1 Answer

How do you remove the radio


Here you can find two reference guides:
- Dodge Intrepid 1998-2004 DG-50-98
- Dodge Intrepid 1993-1997

Hope helped with this (remember rated this help) Good luck.


Oct 23, 2009 | 2001 Dodge Intrepid

1 Answer

How do you take off the speaker on the dashboard in a 2000 eclipse


Remove the two hidden philips screws in the center front cover, below the ac control head.

Gently pull the center front cover off the ac/radio/vents. There are metal push-clips holding the top corners in... be cautious as the dash board can crack from fatigue when removing this part.

Remove the center hood and multi-display.

You now have access to removed the speaker.

Aug 28, 2009 | 2000 Mitsubishi Eclipse

1 Answer

How do i remove factory radio in 1993 chevy caprice?


YOU NEED UNSCREW DASH, SCREWS ARE LOCATED UNDER THE LABEL OF THE DASH. AFTER YOU REMOVE ALL OF THEM, YOU CAN PULL OUT THE FRONT LID COVER GENTLY AND UNSCREW THE BASE OF THE ORIGINAL RADIO

Jul 07, 2009 | 1991 Chevrolet Caprice

2 Answers

Whow to remove center trim panel on dash board for 99 vw beetle


on the dash top the center section is removed by holding tightly from the sides and slide it toward the windshield until it unlatches. if you mean the one around the radio , it is most of the dash face and has 2 screws at top of instrument cluster and 2 more hiding at the bottom under the the a/c controls way back just above the very front of center counsel.

Feb 28, 2009 | 2001 Volkswagen Beetle

Not finding what you are looking for?
2002 Chrysler Voyager Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...