Question about Cars & Trucks

Open Question

2008 dodge ram 3500 ac code b1032

Ac clutch not on &replaced temp.sensor

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: Problems with Lift pump and

we have a 2005 dodge diesel, has been in the shop 3 times for the same problem.! lift pump.,failure, and fuel filter failure,
Does any one out there have any feed back,?? I filter all of my fuel after i buy it , before it goes in truck.... This is getting expensive,, HAS ANY BODY ELSE HAD THIS PROBLEM???
Need a attorney and some advice..
STRANDED,,!!!!!

Posted on Sep 05, 2008

Ad
  • 840 Answers

SOURCE: Need serpentine belt diagram for Dodge Ram 3500 diesel truck

no you should be able to do it There should be a routing label on the underside of hood or on the radiator support/ Its should not be very hard if you have one already just loosen the Alternator it will slide down get the other one ready look to see the way its routed then slide the new one and tighten up the alternator thats it/ Please rate my response thank you very much

Posted on Jan 31, 2009

co7196
  • 3433 Answers

SOURCE: how do you remove the flywheel when replacing the clutch

Take trans out, clutch out, and remove the flywheel bolts.

Posted on May 30, 2009

  • 1149 Answers

SOURCE: bypass ac compressor 2006 dodge ram 3500 5.9 L

Hi:
The easiest method to do this is to go to an auto parts store and buy a belt designed for a truck with no air conditioning. The belt will be the right size, and you just install it as normal, and bypass the compressor

Posted on Dec 15, 2009

Testimonial: "a"

  • 1810 Answers

SOURCE: 1999 dodge ram 1500 2wd 5.2L gives different intermittent codes

pcm posably but i think i would look at the grounds from the battery to body and bat to engine

Posted on Jan 28, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fan clutch wont come on


the coolant temp sensor should be tied into both the gauge and the clutch . the sensor tells the fan clutch to come on if the vehicle is going above the normal operating temp. also check the wiring leading to the sensor and the clutch for broken or frayed .

Feb 28, 2014 | 2005 Dodge Ram 3500

1 Answer

Dodge Ram 3500 code 0088 truck running hot and Ac not working


Engine code p0088 is for a problem with the fuel rail pressure sensor.
You did not say what the year and engine size is, do you have a fan clutch or an electric fan on the radiator ?

May 11, 2013 | Cars & Trucks

2 Answers

Ac compressed wont come om


test and or replace a/c relay. if not check clutch on front of a/c compressor

Jan 21, 2013 | 2006 Dodge Ram 3500 Truck

2 Answers

2006 Dodge Ram Diesel AC will not work, found code P1274


P1274-a/c Clutch Control Circuit 2 Open You will need the help of the dealer or a factory wiring diagram and diagnostic flow chart to fix this one. I can't find a clear cut answer other than someone that used a fuse for the AC circuit to power another system and the fuse blew out.

Jul 24, 2012 | 2006 Dodge Ram 3500 Truck

2 Answers

I just replaced the AC compressor in my 06 3500 Dodge Ram. It worked great for a week, then the passenger side started blowing warm, now all vents blow warm? Had freon checked and compressor, both are...


The expansion valve could be sticking or the blend doors not opening. Since the problem started on one vent, then i would lean more toward the actuator on the blend doors. I hope this helps.

Jul 29, 2011 | 2008 Dodge Ram Pickup 3500

2 Answers

I have a problem with my overdrive engaging and diengaging in my 2002 2500 dodge ram cummings diesil truck any suggestions on what could be causing this?


many possible causes,
tires too large brakes dragging???
;possible torque convertor problems,
outside air temp sensor for trans probs
ECM /electrical connection /lockup issues
Trans may need a service?? change oil & filter
Is this a high miler??
Has it sent up any fault codes?

Sep 26, 2010 | 2001 Dodge Ram 2500 Truck

1 Answer

I keep getting a low temp error code PO128 on my 2004 Ram 1500 I changed the thermostat & that was not it...What should I change next? Fan Clutch or temp sensor?


replace next?? your boy racer weekend mechanic scanner ,its leading you up the garden path ,if vehicle works ok leave it alone

Jan 18, 2010 | 1997 Dodge Ram 1500 Club Cab

1 Answer

Bypass ac compressor 2006 dodge ram 3500 5.9 L diesel I need to bypass stuck ac compressor


Hi:
The easiest method to do this is to go to an auto parts store and buy a belt designed for a truck with no air conditioning. The belt will be the right size, and you just install it as normal, and bypass the compressor

Dec 15, 2009 | 2008 Dodge Ram Pickup 3500

1 Answer

Coolant temp sensor located on a 2004 dodge ram 1500 4.7


YOUR ENGINE OPERATING RATING TEMPERATURE SUPPOSE TO BE 190 TO 200 DEGREES. IF COOLANT SENSOR DEGREES IS SHOWING 190 OR 200 DEGREES IT WORKING.THAT RIGHT.IF ITS SHOWING 60 OR 80 DEGREES IT FAULTY. AND ENGINE WILL RUN POORLY.

Jul 30, 2009 | 2004 Dodge Ram 1500

1 Answer

I cant find where the trans fluid thermostat goes in my 2001 dodge ram 3500 with a 46re trans and a 5.9 engine


if your vehicle is a diesel truck then removed transmission pan. removed transmission filter as well. you will find wiring going to two solenoids side by side. follow harness to other sensor. single solenoid which is located on governor. there will be a square sensor on side, should be black in color. that is your temp sensor. make sure to replace the governor and sensor together. they can be bought seperately but not advisable to just replace temp sensor. should range in price of $200 for both.

Apr 22, 2009 | 2001 Dodge Ram 3500 Truck

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

98 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...