Question about Peugeot Cars & Trucks

Open Question


Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 79865 Answers

SOURCE: code p1135 what wrong help,toyota 2000,highlander

That code is specific to the Air-Fuel Ratio (A/F) Sensor Heater Circuit Malfunction (Bank 1 Sensor 1)

P1135 Trouble Area:
 Open or short in A/F sensor (bank 1, sensor 1)
 A/F sensor (bank 1, sensor 1) heater
 ECM __________________

Posted on Jun 17, 2009

  • 73 Answers

SOURCE: 2003 Rav 4 has P1135 error code. What is wrong

A/F Sensor Heater Circuit Malfunction (Bank
1 Sensor 1).
You most likely have a bad Air fuel sensor bank 1 sensor 1.

Posted on Oct 25, 2009

  • 1861 Answers

SOURCE: 2001 6cy camry has check engine light on. code 1135

Hello. You can do this yourself.

You need to replace the Air-fuel sensor. I would strongly suggest that you purchase and install a Toyota sensor, however. The "aftermarket" sensors do not have the exact same voltage signals, and will not rectify the condition; the light will remain on. We see this quite a bit in our service dept.

We hope that this helps you out.

Posted on Dec 30, 2009

Testimonial: "thank you for sharing you knoledge on this matter! where is the sensor located?"

  • 3640 Answers

SOURCE: how to change a fuel bank sensor #1 code p1135 on

P1135 Air/Fuel Sensor Heater Circuit Response. (Bank 1 Sensor 1) ask any auto parts store what the fix is.

Posted on May 17, 2010

  • 376 Answers

SOURCE: the computer that tells the

this means that this setting is set at the factory and cannot be adjusted in any way.This problem is going to have to be handled by a factory approved Toyota repair shop or a dealer.

Posted on Mar 14, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1999 toyota camry shows code p0125 and also p1135 how do i fix it

code p 0125 refers to insufficient cioolant temperature for closed loop fuel control===causes ---wiring--cooling system---coolant thermostat--- ECT sensor --- ECM
first place to check the level in the radiator
code p 1135 refers to air/fuel sensor heater circuit response ( bank1 sensor 1)
replace the HO2S ( heated oxygen sensor bank 1 in the exhaust manifold before the cat converter
it is possible that the faulty HO2S is triggering the first code so I wpuld consider changing it then resetting the ECM then running for 15 minutes then reading the codes again

Mar 19, 2018 | Toyota Cars & Trucks

1 Answer

Part no code p1135

is this a suzuki or a toyota? or a frenza that is really a POS Daewoo?
wow ! no car even stated only a maker, Suzuki. ouch.
and worse ,no year, ouch.
(my worst guess ever....)
P1 means mfg code.
1135 is oxygen sensors reading wrong, (they can be good)
what engine? suzuki has 56 engines.
the engines have 2 to 4 oxygen sensors.
best i can tell its the 02 heater is bad(wires cut?)
best i can tell it is B1S1 (left bank front sensor) bank 1 sensor 1.?
post car make, car brand model and engine?
and for sure displacment or at least the number of cylinders.
i can then post the full FSM spec, on 1135s

Nov 28, 2013 | Suzuki Cars & Trucks

1 Answer

Error code 1135

P1135 is Air/Fuel sensor Heater Circuit these are because cylinders 1,3,and 5 are not firing which also causes code P0125 .These cylinders are not making heat. the P0300 is because 1,3,and 5 dont miss constantly but they do frequently hence 301,303,and 305. P codes are for Powertrain. I would give the vehicle a good tuneup and make sure you are firing on all cylinders. Possibly need new O2 sensors if those codes don't go away(1130 & 1135) The definitions you DO have are correct. The P0125 "closed loop fuel control" thing is referring about your vehicle no longer being in "warm up" mode. In warm up mode you vehicle does not rely on sensors, it just follows default values for a specific length of time to warm up the engine, then it will adjust everything according to the sensors's inputs to the computer on the vehicle

Oct 05, 2011 | Cars & Trucks

2 Answers

I have a p1135 code does that mean it the o2 sensor cause i have change the mass air sensor

Code P1135 is a vehicle specific code for selected Toyota vehicles - it really helps to know what car you are working on...Year, Make, Model, Engine Size, Automatic or Manual Transmission, etc. There may be Technical Service Bulletins that apply to your vehicle that cover things like reprogramming the engine controller to correct this code, etc. Nobody can give you that information if they don't know what kind of vehicle we are talking about.

In general, the code description for code P1135 is "Air Fuel Ratio Sensor Circuit (California Emissions )"
The possible causes are
1. Open or shorted Air Fuel Ratio Sensor (AF) circuit
2. Faulty AF sensor
3 AF sensor heater or heater circuit shorted or open
4. Engine Control Module (ECM) Fault

The Mass Airflow Sensor (MAF) cannot cause this code - this is a "CIRCUIT" code, not a not a "LEAN" or "RICH" Oxygen Sensor (or AF Sensor) code. The MAF can only cause lean or rich codes.

Most of the time, this code is caused by the sensor itself, however, as I mentioned earlier, there are Technical Service Bulletins for several Toyotas that involve reprogramming of the Engine Computer.

Mar 26, 2011 | Toyota Pickup Cars & Trucks

1 Answer

Error code P 1135. what part needs to be replaced?

P1135. Air/Fuel Sensor Heater Circuit Response. (Bank 1 Sensor 1).

The P1135 code on your Toyota is Air fuel ratio sensor - heater circuit malfunction. Basically the problem there will be with the air/fuel ratio sensor (on other vehicles it is refered to as an O2 oxygen sensor), or the wiring/connectors leading to it. It could also be a problem with a fuse or relay on the heater circuit. Again, not a real difficult problem to solve.

Now, to specifically answer your question. I'm not familiar with the inspections in New Jersey, however just fixing the P1135 code will not cause the check engine light to stay off because there are other unrelated codes. If the code P1135 was causing the other problems then perhaps fixing that code would fix the others, but that's not the case here. The reality is you'll need to have all the problem areas looked at (IAT sensor, MAF sensor, Air/fuel ratio sensor) and repaired in order for your engine light to stay off. Normally if there are codes stored a vehicle cannot pass inspection. I would get a second opinion from another local mechanic as what you've been told may not be 100% correct.

Good luck.

Oct 02, 2010 | 2001 Toyota Sienna

1 Answer

Check engine code P1135 Toyota Highlander v-6

what you looking at on that code is an o2 sensor, the 1135 is bank 1 sensor 1, that says which o2 sensor it is, since most vehicals, especially new foreigns have more than one, this code refers to the first one in your system so if you follow your exhaust manifold back to your pipes, the first one you see, probally right on the manifold, is the one thats malfunctioning. To change it, simply disconect the plug, and use a o2 sensor socket with a ratchet to remove it, and screw the new one back in and plug it in. Pretty simple, wish you luck.....

Mar 21, 2010 | 2002 Toyota Highlander

2 Answers

2002 4runner. P1135 air/fuel metering. Waht does this mean?

hi i have the same problem with my 02 4runner with the code p1135 can someone plese tell me the part no for this code please...

Oct 05, 2009 | 2002 Toyota 4Runner

1 Answer

Code p1135 what wrong help,toyota 2000,highlander

That code is specific to the Air-Fuel Ratio (A/F) Sensor Heater Circuit Malfunction (Bank 1 Sensor 1)

P1135 Trouble Area:
 Open or short in A/F sensor (bank 1, sensor 1)
 A/F sensor (bank 1, sensor 1) heater
 ECM __________________

Jun 17, 2009 | 2001 Toyota Highlander

2 Answers

P1135 code 2002 toyota highlander 3.0 v6.

P1135 is the A/F sensor Bank 1 Sensor 1. Unfortunately, it is the sensor on the back side of the motor, in the manifold against the firewall. Its extremely common, and its not very difficult to replace, just dont try doing it with the motor hot. If you installed an aftermarket sensor, or an Oxygen sensor instead of A/F, you will still have problems. old exhaust gaskets tend to crumble, dont worry, your air mix didnt cause that. Which sensor was replaced?

Jul 24, 2008 | 2006 Toyota Highlander

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

201 people viewed this question

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

mike hayward

Level 2 Expert

279 Answers

Wahs Team

Level 2 Expert

215 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides