Question about Hyundai Elantra

Open Question

How to remove back seat 2004 hyundai elantra - Elantra Hyundai Cars & Trucks

Posted by Anonymous on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: alternator removal on 2001 Hyundai Elantra

All I did was wiggle the bolt out . You have to loosen the power steering pulley and bracket and remove the fan shroud on the left side.

Posted on Jun 18, 2009

ghost45
  • 1280 Answers

SOURCE: how to remove brake drum rear wheel 2004 Hyundai Elantra

Jack up rear of car till tire is off the ground.
Remove lug nuts & remove wheel.
Remove phillips screw(s) from drum.
Using a hammer, strike the drum to loosen it from the hub.
Remove drum by simutaneously turning it and pulling it outward away from the vehicle.

Posted on Oct 04, 2009

  • 94 Answers

SOURCE: How to replace 2004 Hyundai Elantra starter

First, disconnect the battery. Then the only part that needs to be removed to access the starter is the rubber air plenum boot between the throttle body and the air filter housing. This allows enough room to get an arm in there to access the 14mm bolts that attach the starter to the transmission. After removing the bolts, the starter can be removed from underneath the car. lower it down as much as possible, and unbolt the power cable. You may have to twist and turn it a bit to get around the support between the engine block and intake manifold, but it will come out.

Posted on Feb 07, 2010

  • 181 Answers

SOURCE: Correct torque on cylinder head bolts for Hyundai Elantra 1.8GLS

You have two bolt sizes the shorter or smaller of the two sizes is called M10 the torque is 22ft lbs +65 degrees +65 degrees again The larger of the two bolts is called a M12 the torque for these are 26ft lbs +65+65. There is a tightening order staring at the top center bolt and working in a circle They have to be torqued in three steps. If you dont under stand something about this repost and I can help you farther. If this is helpful please mark that it was I do this for free to help people DRIVE SAFE TIM

Posted on Feb 19, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to remove back seat in a 2001 Hyundai Elantra


esda320a.gif
remove 2 12mm bolts, push the tabs in and pull up

Mar 16, 2013 | 2001 Hyundai Elantra

1 Answer

Where is the fuse panel on a 2004 hyundai elantra


The fuse panel is behind the small storage compartment built into the dash panel on the left side. Open the compartment, then pull up and out to remove. Look in the hole and it is there about 6 inches back in the opening.

Jun 17, 2010 | 2004 Hyundai Elantra

1 Answer

Where is the in line fuel filter?


Its on top of the fuel tank, to get to it you must remove the back seat bottom then remove the access panel.

May 10, 2010 | 2004 Hyundai Elantra

1 Answer

Where is the fuel pump located on a 2000 Hyundai Elantra?


Sorry , its probably inside the gas tank. If you are lucky , there will be an access panel under the back seat , or in the trunk. If not , the fuel tank has to be removed.

Mar 31, 2010 | 2000 Hyundai Elantra

1 Answer

How to replace 2004 Hyundai Elantra starter


First, disconnect the battery. Then the only part that needs to be removed to access the starter is the rubber air plenum boot between the throttle body and the air filter housing. This allows enough room to get an arm in there to access the 14mm bolts that attach the starter to the transmission. After removing the bolts, the starter can be removed from underneath the car. lower it down as much as possible, and unbolt the power cable. You may have to twist and turn it a bit to get around the support between the engine block and intake manifold, but it will come out.

Feb 05, 2010 | 2004 Hyundai Elantra

1 Answer

Hi there, im trying to figure out where my starter is in my 2004 hyundai elantra


The starter motor is located below and back towards the firewall of the thermostat housing, remove airbox to see it. Easiest way to find it would be to follow the large gauge black (negative) wire leading from your battery, down towards the engine. This will connect directly to the starter.

Jan 24, 2010 | 2004 Hyundai Elantra

1 Answer

Where is the fuel filter located in a 2004 Hyundia Elantra????


It should be located inside the fuel tank with the pump assembly. it basically wraps around the pump. Access panel under the rear seats. No need to remove the tank.

I hope helps with this (remember rated this help) Good luck.

Dec 22, 2009 | 2004 Hyundai Elantra

1 Answer

Need to remove rear seat of 1996 hyundai elantra


between the seats there are two bolts in the crack... you will have to take those loose..

Apr 23, 2009 | Hyundai Motor 1996 Elantra

1 Answer

How to replace headlight bulb hyundai elantra 2004


yes , you need to remove the headlight cover from the back after u move the bulb conector then there is a holder for the bulb u need to push down then move.
i hope it help ,,,, thanx

Mar 16, 2009 | 2004 Hyundai Elantra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

61 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...