Question about 1999 Mercury Cougar

2 Answers

Where do you find Diagram on 1999 Mercury Cougar blower motor resistor switch? i cant find it on the car?

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,066 Answers

Library...Haynes or Chilton manual

Posted on Mar 13, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 856 Answers

Http://www.autozone.com/addVehicleId,2523402/initialAction,repairGuide/shopping/repairGuide.htm?pageId=0900c152800a8c49
Try this web site. I was able to find what you are looking for. Just fill in your info for your vehicle.

Good Luck

Posted on Mar 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Blower fuse on 99 mercury cougar continues to blow


Internal blower motor short, check this and ground connections.

Dec 14, 2011 | 1999 Mercury Cougar

2 Answers

Blower motor removal in a 1999 mercury cougar


SECTION 412-02: Heating and Ventilation 1999 Cougar Workshop Manual REMOVAL AND INSTALLATION Procedure revision date: 02/8/2001 Blower Motor Removal
  1. Remove the footwell upper trim panel (passenger side).
    • Remove the pushpins.
    m3401035.jpg
  1. Remove the blower motor.
    1. Disconnect the electrical connector.
    1. Lift the securing tab, turn the motor approximately 30 degrees counter-clockwise and remove the motor.
    m3401077.jpg
Installation
  1. NOTE: Engage the securing tab for the blower motor.

Nov 12, 2010 | 1999 Mercury Cougar

3 Answers

A/c and blower does not work i have 14 vots to the fan but still wont work


If it has power you need to confirm if it has a good ground. If it does it may be a defective motor. If not it may just need a blower resistor or have a wiring problem.

May 19, 2010 | 1999 Mercury Cougar

1 Answer

1999 mercury cougar. 3 of my 4 blower settings for a/c stopped working 6 weeks ago and today the 4th went out. i had the blower test and is fine. I replaced the blower resistor and blower switch and still...


Make sure you contact a Mercury Dealer or Ford Dealer and run your vehicle ID number to see if it has a recall on the blower switch. I worked for Ford for years and I think I remember that vehicle having a blower switch and or relay recall. Some of these recalls did not expire and if that is the case it would not cost you anything to have this done. Good luck, hope this helped

Feb 06, 2010 | 1999 Mercury Cougar

3 Answers

Blower motor not working


If you do a voltage check right at the motor you'll know for sure. I usually use my test light or multimeter and poke into wires at motor. If no voltage, start back-tracking which usually means resistor next. If you have 12 volts going to motor & it's not spinning, then I'd be pulling motor. You can manufacture a set of jumper wires to motor connector, and use a 12 volt cordless battery to test motor if you know how.

May 08, 2009 | 1999 Mercury Cougar

1 Answer

Blower motor fuse is located 99 mercury cougar


SECTION 412-04: Control Components 1999 Cougar Workshop Manual REMOVAL AND INSTALLATION Blower Motor Resistor Removal
  1. Remove the upper footwell trim panel (passenger side).
    • Remove the pushpins.
  1. Disconnect the blower motor resistor electrical connector.
  1. Remove the blower motor resistor.
-------------------------------------------------------------------------
f9d16f6.gif

May 06, 2009 | 1999 Mercury Cougar

2 Answers

Mercury Cougar heater blower only works on high.


remove the trim panel below the glove box and you will see the blower motor,just to the left of it you will see a 4 wire connector plugged into the case. This is the blower motor resistor,this is what you need to replace.

Feb 12, 2009 | 1999 Mercury Villager

1 Answer

99 cougar heater


I had this exact problem, it is probably your Blower Motor Resistor. It is located under/behind your glovebox, one screw holds it in. Not too expensive either. If that doesn't work it may be your blower motor. Good Luck!

Nov 20, 2008 | 1999 Mercury Cougar

1 Answer

1999 mercury cougar blower motor removal


Thanks alabama! Cant use my garage so Im in the the driveway, its cold (Jan. in Indiana) and I don't have alot of patience right now. Again thanks very much for sharing!

Jun 21, 2008 | 1999 Mercury Cougar

Not finding what you are looking for?
1999 Mercury Cougar Logo

561 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Fordexpert

Level 3 Expert

5331 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...