Question about 2004 Mazda 6

Open Question

2004 Mazda 6 manual transmission clicking

I have a 2004 Mazda 6 that makes a clicking noise when I shift to 3rd and fourth gear. My brake fluid is full and my transmission fluid is good. It does not make the clicking noise in 1st, 2nd, 5th or reverse.

Posted by on

6 Suggested Answers

adhamsaid88
  • 58 Answers

SOURCE: 1992 Eagle Talon Transmission Problem

hello ,
thank you for asking ,
i know that this is really a silly problem , but i am sorry to tell you that you better to get another transmission automatic gear box , because the repairing will cost you a lot , but if you found that it will not cost that much so it's ok to repair it , and if you have any other problem all you should do is asking me , and thank you for using fixya ,
have a great day ,
Adham Said

Posted on Jun 27, 2008

  • 1 Answer

SOURCE: cannot shift properly

My Saturn did the same thing - twice. Where the clutch cables connects to the shifter box(??) there is a little clip that had fallen off. The first time this happened, the mechanic told me that I needed to replace the whole shifter box - costing me $400 dollars. The second time - about two years later a different mechanic charged me $15 for the clip and labor.

Posted on Sep 06, 2008

  • 14036 Answers

SOURCE: my 92 honda accord will not go into 1st 3rd or 5th gear

check shift fork adjustment. make sure you bleed the slave cylinder.also check shift cable adjustment.

Posted on Apr 11, 2009

  • 11 Answers

SOURCE: Saturn SW1 will not shift into 2nd, 4th, or reverse

no hydralic fluid in the resvoir look for the resvoir on the fire wall of the drivers side if its empty well fill it back up lol not sure if the sw1 has this but ive had too fix this problem before

Posted on Jun 18, 2009

agent91
  • 2100 Answers

SOURCE: I have a 2001 mazda

It sounds more like a clutch problem than tranny. You can try the oil in there, but I think the clutch is shot. Check the fluid in the clutch master and make sure it is working right, no slipping, crunching, grinding, the jerking sounds like oil on the clutch. Check it out.

Posted on Sep 05, 2010

dj_relly999
  • 4070 Answers

SOURCE: My 5 speed 2004 Mazda

Hi and welcome to FixYa!

Since it's a 2004 I doubt that the gearbox is faulty, it's too early for it to get be worn out so you can leave the gearbox issue. I do suspect that you have a faulty clutch lining. If they are worn out this issues occur. I strongly suggest that you replace the clutch lining, release bearing and pressure plate. Once replaced you'll be good.

Hope this helps and thank you for using FixYa! Have a good one!

Posted on Jan 10, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 mazda 6 wont shift out of 1st gear smoothly. It whines, then finally catches. If it's cylinder (will be 3rd one) which number is it?


your gear selector linkage cable has come adrift from the linkage bracket just below the battery tray ,you can temporarily fix with two cable ties ,but will need to replace one of the two cables one is for neutral and the other is to select gear

Jan 09, 2013 | 2004 Mazda 6

1 Answer

Hard shifting


probably just your transmission being old and wear and tear catching up to it. engine braking is a good thing in a manual but since automatics cant judge how far to let out a clutch mechanism that doesnt exist to make it smooth, it usually causes more wear and tear than its worth. maybe time for a transmission rebuild and time to leave engine braking to manual transmissions. $30 brake pads vs $2000 transmission. hope this helps ya

Oct 25, 2012 | 2004 Buick Century

1 Answer

76 Cadillac automatic won't shift from 3rd to 4th


For Automatic transmission problem,Check the list of help links below.click the link below:----Automatic transmission troubleshooting:----

http://howtobyme.blogspot.com/2011/11/automatic-transmission-will-not-go-into.html

---------
Automatic transmission shift lever issues?-------

http://technoanswers.blogspot.com/2012/01/automatic-transmission-shift-lever-hard.html

-----------
AUTOMATIC TRANSMISSION FLUID LEVEL? --

http://schematicsdiagram.blogspot.com/2011/07/how-to-check-automatic-transmission.html

--------------

AUTOMATIC TRANSMISSION FLUID AND FILTER?

http://schematicsdiagram.blogspot.com/2011/07/how-to-change-automatic-transmission.html

-----------
Transmission fault light on car dash?

http://schematicsdiagram.blogspot.com/2011/12/transmission-fault-light-on-car-dash.html

--------
Transmission shifting problem?

http://schematicsdiagram.blogspot.com/2012/01/transmission-shifting-problem-on-toyota.html

--------
Transmission Slips out of 2nd gear?

http://repairhelpcenter.blogspot.in/2012/02/transmission-slips-out-of-2nd-gear.html

-----------
OD light flashing and transmission fluid leaking?

http://repairhelpcenter.blogspot.in/2012/02/od-light-flashing-and-transmission.html

----------
Why Transmission fluid leaks near radiator?

http://repairhelpcenter.blogspot.in/2012/02/transmission-fluid-leaks-near-radiator.html

----------
transmission fluid leaking?

http://technoanswers.blogspot.in/2012/02/ford-windstar-transmission-fluid.html

-------------
****** wont go in reverse?

http://technoanswers.blogspot.in/2012/02/dodge-neon-wont-go-in-reverse.html

-------------
Automatic transmission will not go into reverse?

http://technoanswers.blogspot.in/2012/02/dodge-automatic-transmission-will-not.html

----------
Transmission is making buzzing noise?

http://technoanswers.blogspot.in/2012/02/transmission-is-making-buzzing-noise.html

-----------

This will help.

Thanks.

Feb 12, 2012 | 1976 Cadillac Deville

1 Answer

My check engine light came on along with the "AT" on my 2005 Mazda 6s automatic. Then the transmission was stuck in 3rd gear. I can only put it into park and reverse. Once i shift to drive, it...


suggest that you check your transmission fluid post haste please. you may only need to add transmission fluid to your car. also,if you have to add the fluid,where did your fluid leak? check for leaks under your car when parked. you may need transmission fluid and filter change,suggest that you do this with new filter and add lucas transmission treatment to the fluid change also. you'll need to purchase this yourself,unless you have a mechanic in the family that can do it for you.if not i suggest you find a mechanic you trust,then tell him,or,her to add this to your tranny fluid change. also suggest while the mechanics there at the transmission to check the modulator valve on the transmission,and the vacum line that operates it. just a hint. thanks for choosing fixya.com

Mar 04, 2011 | 2005 Mazda 6

1 Answer

Mazda 6 gears jerking between 80-100km.. the transmission was recently refurbished by local dealer but they seemed to be lost what could this be?


Check you tranny fluid make sure its full.Also check if its not leaking into the gears making them to slip while changing gears. Also as the transmission job is done.Make sure the transmission is aligned properly. If you feel a strong **** or clunk while shifting, the car may have a transmission problem. Every gear should shift smoothly and easily without any noises or jerks. If still the same problem then its the transmission problem it has to be replaced.There are many many other users facing the same exact problem in Mazda -6 cars.That mazda is having transmission problems, they had it on the 6 and they now have a new program to upgrade the car software to fix the shifting problem .Ask you car Mazda dealer about the updated program for this transmission shifting problem. Thanks. Keep updated for any more query. You can rate this solution and show your appreciation.

Jul 17, 2010 | Mazda MAZDA6 Cars & Trucks

1 Answer

2004 mazda 3 transmission problem


Check transmission fluid. If that is full, try changing the fuel filter. It could be starving for gas, and trying to shift but can't. It could also be the speed sensor, or shift solenoid.

Jul 06, 2009 | 2005 Mazda 3

1 Answer

Transmisson problems


it can be the shift solenoid in the trans there is one for 1st and 2nd then there is one for 3rd and fourth easy to change drop pan they are right there.about 40 to 60 at dealer for solenoid and of course fluid and filter about 60.00

May 23, 2009 | 2005 Chevrolet Silverado 1500 2WD

1 Answer

My 2006 mazda 6s has a 6speed automatic transmission. But whenever I brake and the transmission shifts back, it gives a big "bang" when it downshifts at the fourth gear. What might be wrong?


The first thing to check would be the transmission fluid level. Typically checked with engine warm, idling, and in PARK. If the fluid level is OK, and the fluid is a pinkish red in color, you may need a computer update. I believe there were some recall 'flash' updates for this problem. If the fluid is brown or smells burnt, you should have the tranny fluid changed. Make sure you use the correct fluid type if you add or change fluid!! Also check on the mazda6club.com forum for similar issues. The tranny and computer should be covered for at least 60K on the warranty coverage.

Nov 07, 2008 | Mazda MAZDA6 Cars & Trucks

Not finding what you are looking for?
2004 Mazda 6 Logo

Related Topics:

245 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...