Question about 2007 Audi Q7 4.2 FSI

1 Answer

Rear a/c controls won't turn on

The a/c for the back seats says "OFF". When I push the on/off switch, it goes to -- -- for a few seconds, then returns to "OFF" I don't know if there is another set of controls that I'm missing, or if something is broken.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 22 Answers

Have you checked the setup feture for the rear a/c on the front panel of the MMI display. You can lock out the rear panel from there, also if you have child protect activated a lot of features in the rear compartment are disabled.

Posted on Aug 27, 2014

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 5 Answers

SOURCE: have 1990 audi 100,car won't turn over,have 12 volts,makes a click sound under back seat when I turn key

Sounds like a dead battery. Do the lights come on and radio work? Maybe the lights are dimmer than normal or the door is no longer dinging when opened. Also another way to tell when the battery is not getting any juice to the car.
You may be able to get the car started using jumper cables. I would take it to a parts store immediately and have them check it (almost always free).

One easy thing (which is free and a maintenance item) is to clean the battery terminals and cable terminals. These can get very corroded and actually cause the battery to stop charging when the car is running. They may just need a good cleaning and a jump. It might take care of it!

Probably not the starter, but also an outside chance (full disclosure).

Good luck!

Posted on Nov 12, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2006 LINCOLN ZEPHYR DRIVERS ELECTRIC SEAT WILL NOT MOVE BACK WHEN KEY IS TURNED OFF


Principles of Operation
The driver seat module (DSM) is on the controller area network (CAN) communication network. To support several vehicle subsystems, the module permits intermodule and diagnostic tool communications.
The DSM controls the memory driver seat and the passenger memory power exterior mirror. This passenger memory power exterior mirror feature allows the driver to program personalized mirror positions. Once the driver stores a mirror position, the driver can recall the setting by pressing the corresponding memory switch or by using a programmed remote keyless entry (RKE) transmitter. For additional information, refer to Section 501-10 .

How to Diagnose Controller Area Network CAN

Driver Seat Module - Memory Seat
The power driver seat, power outside rear view mirrors and power adjustable pedals are controlled by the driver seat module (DSM) only when the vehicle is equipped with the programmable/recall memory option. The DSM is located on the driver seat track.
This system allows automatic positioning of the driver seat to 2 programmable positions.
  • A power driver seat position can be stored at any time. The driver must move the seat to the desired position using the driver seat switch assembly. The driver must then depress the memory SET switch which activates the memory SET switch light emitting diode (LED). Within 5 seconds (before the LED goes out), the driver must select a memory position. Memory 1 is selected by depressing memory switch 1. Memory 2 is selected by depressing memory switch 2.
  • If no memory switch input is received within the 5-second time limit, the operation is aborted and the memory seat position switch (set switch) LED is turned OFF. This also occurs if one of the following inputs is received during the 5-second programming limit:
    • Driver seat control switch
    • Memory seat position switch (set switch)
    • Power adjustable pedal switch
A programmed seat position can only be recalled when the transmission selector is in PARK or NEUTRAL with the ignition switch in the RUN position. A position may be programmed at any time.

Easy Entry/Easy Exit
The driver power seat easy entry/easy exit feature can be enabled/disabled. Refer to Section 418-01 or the owner's literature.

This may need to be done with a scan tool

Apr 24, 2017 | Lincoln Cars & Trucks

1 Answer

Rear vent controls not working


The rear blower motor switch and the rear floor console switch bezel are serviced only as an assembly.

  1. Disconnect and isolate the negative battery cable.
  2. Remove the rear floor console.
Rear Blower Motor Switch

  1. Remove the rear floor console switch bezel by releasing the retaining tab located at each end of the switch bezel and pushing it out through the front surface of the console.
  2. Disconnect the wire harness connectors from the rear blower motor switch and the rear heated seat switches.
  3. Remove the rear heated seat switches from the rear floor console switch bezel by gently prying the switches free from the back of the switch bezel.
INSTALLATION
  1. Install the rear heated seat switches into the back of the rear floor console switch bezel. Make sure that the switch retaining tabs are fully engaged to the bezel.
  2. Connect the wire harness connectors to the rear blower motor switch and the rear heated seat switches.
  3. Install the rear floor console switch bezel into the rear floor console by pushing it in through the front surface of the console. Make sure that the bezel retaining tabs are fully engaged to the console.
  4. Install the rear floor console.
  5. Reconnect the negative battery cable.

Feb 20, 2014 | Chrysler Pacifica Cars & Trucks

1 Answer

WHat are some symptoms of a Subaru legacy fuel pump


The car won't start.

Lift up the rear back seat base cushion.
Turn the ignition on and listen for the fuel pump operation under the seat. If you hear no sound, then pull off the inspection panel there, and remove the fuel pump. Replace it, and retry.
This occurs on the Legacy from time to time, and I've replaced a few.

Nov 12, 2012 | Cars & Trucks

1 Answer

Temperature knobs won't change temperature Chevy Tahoe


You likely have a HVAC control head failure. The rear heater problem is likely a door actuator, the rear wiper is likely a open wire in the door jamb in the top. The gauges are likely a cluster failure.

Oct 17, 2012 | Chevrolet Tahoe Cars & Trucks

1 Answer

The brake lights won't turn off


If your rear brake lights are on all the time, I would first check your brake pedal. Near the top of the pedal, probably just about where the pedal is attached to its pivot, you'll see a little switch that is either pressed in or released when you step on the brakes. That's the switch that controls your rear brake lights. As an experiment, have a helper look at the brake lights while you manually pull or push this switch all the way in and out. These switches wear over time and can stick in position. Fortunately, they're not expensive to replace, if that turns out to be the problem.


If your brake light switch seems to be working properly (hard to tell if the brake lights won't go off), a second possibility is that there's a short somewhere in your wiring and your brake lights are getting power from the shorted wire. I think this is a pretty unlikely cause, because most of the wires that rub up against the brake light wiring are for your turn signals and tail lights, and these are not normally energized. If you said that your brake lights always came on when you activated your turn signal or when you turned on your other lights, then this cause would be much more likely.


Check your brake pedal switch and the wire connections to it. I have a feeling that you'll find your problem.

Jun 16, 2011 | 1993 Honda Accord

1 Answer

How do you remove the rear seat in a saturn 2000 ls


Thank you for the inquiry.
Ok, I know this is old but to help anyone in the future...
It is really, really easy to remove the rear seat cushion.

You just push the bottom of the seat cushion in and lift up.

Keep rear seat back in upright position.
You need to unlatch the rear seat cushion at 2 points, which are at the center of each seating position. You just squish the seat cushion towards the back of the car, right at the bottom where it meets the carpet and lift up. That half of the seat will popup, then repeat for other side.

It takes maybe 5 seconds to do.

You won't beleive how easy it is 'till you try it.
This is how many, many cars mount there rear seat cushions.

Hope this helps helps. Please keep us updated and remember to rate this answer.

Jun 04, 2011 | Saturn LS Cars & Trucks

3 Answers

1995 Jeep Grand Cherokee seat belt light does not go out.


Hi,
First of all, I take it you are using your seatbelt.
There is a small micro switch in the bottom of the seatbelt plug.
Check that it`s still in place. It`s only a contact breaker switch.
You could unwire it to stop the annoying light, but will need to fix it for the next MOT

Jan 19, 2009 | 1995 Jeep Grand Cherokee

2 Answers

Front driver seat adjustments. Push control forward seat goes back; push control back seat moves forward. Easy exit feature moves seat forward


probably the switch is installed backward in its cover so remove the switch and rotate it and put it back

Nov 19, 2008 | 2005 GMC Yukon Xl Denali

Not finding what you are looking for?
2007 Audi Q7 4.2 FSI Logo

146 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

yadayada
yadayada

Level 3 Expert

76630 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14378 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...