Question about 1995 Hyundai Sonata

1 Answer

Just cranks does not run - 1995 Hyundai Sonata

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 4,669 Answers

Have you checked for spark?

Posted on May 19, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have aa 2007 chev her with 2.22 liter some of the fuses don't get power and some do on the fuse box block under hood everything to start and run car is dead


2007 Chevy her ? HHR ? 2.2L 4cylinder , check the run/crank relay ! Relay # 51 in the under hood fuse/relay box.
Power to many of this vehicle?€™s circuits are controlled by the module that is designated the power mode master (PMM). This vehicle?€™s PMM is the body control module (BCM). The PMM controls which power mode (Run, Accessory, Crank, Retained Accessory Power, or Off) is active.
Run/Crank Relay The run/crank relay control circuit is connected to a constant ground and is switched by the ignition 1 circuit or the body control module (BCM). The BCM, will in lieu of the ignition switch position, activate the Run/Crank relay during a remote start event. The Run/Crank relay supplies a power signal to the following circuits, when the a Run or Crank power mode is selected:
?€¢
Automatic transmission shift indicator


?€¢
Automatic transmission (A/T)


?€¢
Switched power feeds to the BCM


?€¢
Electronic brake control module (EBCM)


?€¢
Electronic ignition module (spark control)


?€¢
Electronic power steering module (EPS)


?€¢
Fuel injectors


?€¢
Powertrain control module (PCM)


?€¢
Park neutral position (PNP) switch

Dec 22, 2015 | Cars & Trucks

1 Answer

Have a 2003 Isuzu rodeo 6 clyinder 4wheel . Starter turns over a little longer before cranking. Done tune up, changed out fuel regulator but still dose the same ,what is my problem . t


a little longer before cranking.

what does that mean?

dont crank,
cranks slow.
cranks (Fast) called normal.
cranks fast starts, then stalls.
cranks fast, starts easy, starts, runs and stays running, normal
at what point does it fail, and how exactly.

we can't hear it, or watch you, so...................................

Dec 13, 2015 | 2003 Isuzu Rodeo

3 Answers

Why won't it start?


Air and fuel filter,tune up,battery and connection ,

Aug 02, 2015 | 2005 Jeep Grand Cherokee

1 Answer

No power going to ignition control module, what would cause this?


Yes, the pink wire to the ICM and from the run/crank relay should have battery voltage in run or start. If not, check fuse 11, a 10 amp fuse in the Fuse Block-Underhood. Also check fuses 38- a 30 amp fuse supplying power to the run/crank relay, and fuse 9- a 10 amp fuse between the run/crank relay and the ECM. All of these fuses are in the underhood fuse block.
Fuse 38-the 30 amp fuse, the power feed for the run/crank relay- will be hot at all times. Fuses 9 and 11 will be hot in run or start. Check for power at the fuses. If the relay is not turning on and sending power to those fuses and to the ICM, and the ECM, (and to the injectors through fuse 16 - a 10 amp fuse), then work back to the ignition switch and the body control module. Wish I didn't have to say that, but yes, the BCM is between the ignition switch and the run/crank relay.
Good luck, Michael.

May 27, 2014 | 2003 Saturn ION

1 Answer

Fuel relay


Short answer, your batter is bad. or is disCHARGED:
Long.:

wont crank?
no engine, cranks ,unless the starting system works.
unless pushed fast, like my car or i park on a hill and coast jump my car.(M/T tranny rule)

NO crank, is the true failure here:
slow Cranks are , bad battery , or a discharged battery , due to bad charging system or parked for 3 months or longer.

so ill assume its NO CRANK.
I turn the key TO START and the starter fails to CRANK.
the starter motor is dead. (key clue 1)
so i attach a set of jumper cables to my Caddy, running and this car
now cranks and RUNS (you left that out. above, huh? runs)

turnsover means nothing, because the engine starter turns over
and the engine can turn over and the engine can run,
once running the EFI system SUSTAINS runninng.
so there are 4 states there. (4 phases )

No cranks #1 reason to be slow , are a bad battery
so I charge that battery, and see how if it cranks , now?
it dont crank means a bad battery
it does work( crank) see how long it works.../?
if it dies again, or better, check the cars Alternator for by measuring
accross the battery terminals running , with any volt meter.
13.3 to 15vdc is a good alternator running the engine.
if NOT, the charge system is bad. (system)

On some cars the IMMO can block Cranking or for sure blocks
fueling after 2 seconds. So. watch the IMMO light on the dash.
Immo is the Immoblizer. option.





Sep 22, 2013 | 2001 Acura 3.2CL

1 Answer

My 98 e320 runs and then dies...? Sometime crank right up and run sometime won't crank for a while. Replaced pump and filter ?.


you should check on your battery cables,chasis cables, and engine bay cables related to your ground or bad connection in between connectors, terminals or hubs.

May 04, 2012 | Cars & Trucks

Not finding what you are looking for?
1995 Hyundai Sonata Logo

Related Topics:

44 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

64052 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...