Question about 1995 Oldsmobile Cutlass Supreme

1 Answer

1995 cutlass supreme

Right front tire fell back pulling the u-joint out of the housing

Posted by on

  • yadayada
    yadayada May 11, 2010

    WHAT IS THE QUESTION HERE?

  • wes smalley May 11, 2010

    by fell back you mean literally fell or is tilted in toward the car?

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

New driveshaft, ball joint and alignment. might not hurt to have the wheel and tire checked as well.

Posted on Mar 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the brake bleeder on a 1995 oldsmobile cutlass supreme?!?!


you have 4 of them 2 in front / 2 in back . 2 in back are on the brake backing plate 1 bleeder on each side. 2 in front 1 bleeder on each side on the caliper. when bleeding start with rigth rear left rear front rigth frontleft . check master cylinder fluid level while bleeding. keep full of fluid

Nov 12, 2010 | 1995 Oldsmobile Cutlass Supreme

2 Answers

My hood is stuck and won't pop


While you are pulling out on cable have someone hit hood with each fist on front of hood near grill left & right of center at same time.

Jun 28, 2010 | 1995 Oldsmobile Cutlass Supreme

1 Answer

Need to know the firing order of sparkplug wires on a 1995 olsmobile supreme cutlass


For the 1995 Oldsmobile Cutlass Supreme:
I do not know if you have the 3.1L V6 or the 3.4L DOHC V6; however below are included below:

For the 3.1L V6:
Firing Order:
1-2-3-4-5-6
Cylinders:
........(back)........
|...1......3.......5...|
..........................
|...2.......4......6...|
.........(front)
Ignition Coil Connections:
...........(back)
.|5..2.|..|.3..6.|..|.4..1.|
...........(front)

For the 3.4L DOHC V6:
Firing Order:
1-2-3-4-5-6
Cylinders:
.........(back).........
|...1.......3.......5...|
...........................
|...2.......4.......6...|
..........(front)
Ignition Coils Connections:
..........(back)
.|.1..4.|.|.3..6.|.|.2..5.| (Honestly: I'm thinking it should be 6..3 not 3..6)
..........(front)

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!







Apr 14, 2010 | 1995 Oldsmobile Cutlass Supreme

1 Answer

How to remove alternator from a 1994 olds cutlass supreme 3.4 sl


TO REMOVE ALTERNATOR.TURN OFF RADIO FIRST SO YOU WONT LOSE RADIO CODE WHEN YOU DISCONNECT NEGATIVE BATTERY CABLE.THIS IS A LIST OF THINGS YOU HAVE TO REMOVE TO GET TO ALTERNATOR.REMOVE AIR CLEANER ASSEMBLY REMOVE COOLANT RECOVERY RESERVOIR SET ASIDE.REMOVE SERPENTINE BELT.RAISE AND SAFELY SUPPORT VECHICLE.REMOVE POWER STEERING PIPE RETAINING CLIP NUT FROMUPPER ALTERNATOR STUD.REMOVE RIGHT FRONT TIRE AND WHEEL ASSEMBLY.SEPARATE LOWER BALL JOINT FROM LOWER CONTROL ARM.REMOVE THE HALFSHAFT FROM TRANSAXLE.REMOVE RIGHT HAND ENGINE SPLASH SHIELD DISCONNECT CONNECTORS AND WIRES FROM ALTERNATOR.REMOVE THE BRACE BOLT FROM ALTERNATOR AND LOOSEN BRACE AT ENGINE BLOCK.REMOVE ALTERNATOR LOWER MOUNTING BOLT AND ALTERNATOR..PUT EVERYTHING BACK VISA VERSA.

Apr 03, 2010 | 1994 Oldsmobile Cutlass Supreme

1 Answer

Ball joint broken in half and drive shaff pull out how do you change joint are they rebits on the top of the joint and does drive go back right back in. the car is Cutlass 95 supreme


they are usually bolted in place and will come with new bolts and it simply slips back into place and then secure it with the nut and cotter pin

Oct 07, 2009 | 1995 Oldsmobile Cutlass Supreme

1 Answer

Radio Wiring colors for 1995 cutlass supreme


red is always hot and black is ground wires as for the speaker wires you may need to experiment until you figure left rear front right etc ..

Sep 23, 2009 | 1995 Oldsmobile Cutlass Supreme

1 Answer

Cutlass Supreme new front wheel bearing repeatedly goes out


You may have pulled the inner tri-pod joint out of the cv shaft and that will make noise. Is the bearing really bad? Does it turn freely?

Jun 23, 2009 | 1995 Oldsmobile Cutlass Supreme

1 Answer

Popping sound on diver front tire


I dont work as a car mechanic but have some limited knowledge,,,, Most of the time that you get popping noises in the front end (usually while turning) it is the CV joint,,, the boot drys and cracks and dirt, sand and grit take out the joint, so if you replaced the joint and the boot and lubed it up,,, could be the tire is not completely round(was told my rear tires were shaped like eggs by one shop) other than that, you have to limit it down to the when and wheres... like when does it happen, how fast are you going, stopping,,turning, braking,,, out of gear(in nuetral..etc) then I think the answer will be easily to tell.

May 09, 2009 | 1994 Oldsmobile Cutlass Supreme

2 Answers

Unable to locate thermostat on 1994 cutlass


follow the upper radiator hose to the motor and you will find the thermostat housing there

Apr 13, 2009 | 1995 Oldsmobile Cutlass Supreme

1 Answer

Cv joint replacement


Remove the tire and tighten 2 lugnuts onto the brake rotor. remove the axle nut in center of the brake rotor and drive the axle out of the spindle. If the ball joint is original, you have to grind out the rivets on the lower control arm. Remove and replace the ball joint with the hardware included with the ball joint. Next, pry-unsnap the axle end from the transaxle with a prybay and drive-snap in the new axle shaft into the transaxle. reverse to assemle, align front end and wholla! your done. 1 hour,15 min. $115.00 to do it yourself.

Mar 07, 2009 | 1995 Oldsmobile Cutlass Supreme

Not finding what you are looking for?
1995 Oldsmobile Cutlass Supreme Logo

Related Topics:

72 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...