Question about 1998 Chevrolet S-10 Pickup

1 Answer

Not enough power to start

My 1998 Chevy S10 has enough power to stay on and sounds great but it does not have enough power to move. Especially in a lower gear. What could be wrong with it? I just rebuilt the engine and put in a new fuel pump and regulator as well as replaced many new censors.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 79 Answers

Fuel Injectors (Spider)

Posted on Apr 23, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 3 Answers

SOURCE: new fuel pump replaced on 2000 chevy s-10 blazer, no fuel

BAD FUEL PUMP


Posted on Apr 19, 2009

  • 2 Answers

SOURCE: 1998 chevy s10 won't start, engine cranks but it won't turn over.

replaced your fuel pump and when you buy it make sure to replace the oil sending sensor on the fuel pump it comes with a replacement when you purchase a new fuel pump

Posted on Jun 10, 2009

  • 12 Answers

SOURCE: truck idels fine but put into gear stalls

you need to adjust the engion timing

Posted on Jun 19, 2009

  • 541 Answers

SOURCE: My 4.3 vortec engine in my s10 blazer won't start

try the ignition module. if it is bad it does not send the signal for the the throttle body injectors to spray feul.

Posted on Oct 23, 2009

  • 7 Answers

SOURCE: 1993 Chevy S10 Blazer engine hesitation with smoke from exhaust

Had a 94 Olds Bravada that did a similar thing and it was EGR valve on the front of the intake. It' s easy to take off and clean with WD 40 and if you have an air compressor blow it out good.

Posted on Jan 24, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1998 chevy lumina want start changed starter and battery still want start turn key car dead want turn over can start with jumper swicth but want stay running


Have your alternator tested.Your car will not stay running if the alternator is not producing enough power to keep the battery charged.Also have your battery tested and fully charged.Make sure your cables are in good shape.

Sep 26, 2010 | 1998 Chevrolet Lumina

2 Answers

1998 chevy s10 will not start


engine wont run on an chevy s-10 pick-up 1998. 4cyl

Feb 14, 2010 | 1998 Chevrolet S-10 Pickup

1 Answer

I have 98 Chevy S10 pick-ups? MY problem is there


Yes it could well possibly be the ignition switch or starter solenoid or intermittent ignition switch starter contact.Again check connections on battery especially the ground connection at the block.Also there could be air in the fuel line any of these could be hindering start up!

Oct 02, 2009 | 1998 Chevrolet S-10 Pickup

1 Answer

1988 chevy s10 blazer 4.3, cut out , will srart but will not stay


Your vehicle as an ignition control module located on top of the distributor (under the cap and rotor) I would pull the ICM and take it to NAPA and have it tested if bad replace it (cost about $80). Sounds like a ICM problem or it could be the ignition switch located on the steering coloum which can't be tested but costs $20. Hope this works

Jul 15, 2009 | 2000 Chevrolet S-10

2 Answers

Heater 1998 chevy s10


You need to check your coolant level first. If it is low you have a coolant leak. No hot coolant=No heat

Jun 22, 2009 | 1998 Chevrolet S-10 Pickup

1 Answer

91 chevy s10 junk


did you try changing the fuel filter or scanning for codes? This would be a great place to start.

Mar 12, 2009 | 1991 Chevrolet S-10 Blazer

2 Answers

Chevy Suburban injection system


check your entire ignition system especially the ignition control module

Dec 26, 2008 | 1998 Chevrolet K1500

Not finding what you are looking for?
1998 Chevrolet S-10 Pickup Logo

76 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...