Question about 1993 Jeep Grand Cherokee

1 Answer

1995 Jeep Cherokee removing rear drums

How do I get the rear drums off?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jeep Master
  • 6,982 Answers

If drums are frozen to axles, spray around center with wd40. also, if you can, back off adjusters through backing plate access hole. You can also use a hammer, but dont go crazy on them!

Posted on Mar 13, 2009

5 Suggested Answers

81vasquez
  • 34 Answers

SOURCE: does a 1995 jeep grand cherokee have rotors or

drum

Posted on Jun 07, 2009

ZJLimited
  • 17970 Answers

SOURCE: 2003 Jeep Grand Cherokee, how to replace rear tail light

I thinking tha you are fix the CHMSL (Central High Mounted Stop Light); review the Service Manual, the section ZJ-Secc-8L-Lamps (page 7, fig. 11).

I hope help you with this, good luck (remember rated this help).

Posted on Sep 16, 2009

  • 96 Answers

SOURCE: knocking in rear of 1995 jeep grand cherokee while

check rear suspension for any broken links

Posted on Sep 17, 2009

  • 23 Answers

SOURCE: 1995 Jeep Grand Cherokee with fulltime 4wd and only turns rear!

You know for a fact no power is being sent to the front axle? This transfer case only sends power to the front axle when the rear axle is slipping. Are there any unusual noises in the front axle?

If it is the transfer case, replacing it is not too big of a deal. If you are the least bit confident of your abilities, then you can do it yourself. I believe you have the NP242 transfer case, but I could be wrong. There will be a tag on the back side of the case, facing the rear axle, to the left of the drive shaft. On that tag, it will tell you which case you have. You can either have yours rebuilt, or buy a replacement either new or used.

To remove the t-case, first drain the fluid. Next remove the front driveshaft by removing the four bolts holding the u-joint in place. Then remove the rear drive shaft by doing the same as the front driveshaft, only this time it's at the rear differential. Once the drive shaft is free, support the full weight of the driveshaft, not that heavy, and pull it out of the t-case and set aside. Disconnect the shifter linkage and wiring harness. Next, remove the bolts that connect the t-case to the t-case cross member. Lift slightly and support the tranny/t-case assembly and remove the cross member. The t-case isn't very heavy, but you don't want it falling on your head, so remember to support it as you remove the bolts that connect it to the rear of the tranny. Once you bring it out from under the Jeep, and it's rebuilt or you have another unit to replace it, installation is the reverse of removal. Just remember to refill the t-case with the proper fluid.

Posted on Dec 09, 2009

  • 638 Answers

SOURCE: remove rear wiper arm 1995

on some of these models, there is a plastic piece made into the wiper arm, remove the plastic piece, and arm should be able to be brought backwards, if no plastic piece is there, then you press onto a small plastic clip that is on the wiper arm, and push wiper blade downward, this should release the wiper blade.

Posted on Apr 22, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I am taking the rear axle out to replace a seal, it will not come out. Have taken cover off rear end, removed pin and it will not come out!! can you help


I had a 1996 jeep grand cherokee, I had to take the rear end cover off and to take the side axle bolt/pin out, to remove the side axle

Aug 29, 2011 | 1995 Jeep Grand Cherokee

1 Answer

Remove rear wiper arm 1995 jeep cherokee


on some of these models, there is a plastic piece made into the wiper arm, remove the plastic piece, and arm should be able to be brought backwards, if no plastic piece is there, then you press onto a small plastic clip that is on the wiper arm, and push wiper blade downward, this should release the wiper blade.

Apr 22, 2011 | 1995 Jeep Cherokee

1 Answer

How to replace rear wiper arm 1995 jeep cherokee


At the base of the wiper arm there is usually a plastic cover hiding a nut under it. Remove the nut then lift the wiper arm and jiggle it to break it free.Have a good day.

Mar 11, 2011 | 1995 Jeep Cherokee

1 Answer

How do you remove the front drive shaft in a 1995 jeep grand cherokee limited


Use white paint, chalk or a scribe to mark the relationship of the front U joint to the front diferential pinion yoke. Mark the relationship of the rear U joint flange to the transfer case companion flange. Unbolt the front end of the drive shaft from the pinion yoke and the rear end from the transfer case companion flange and remove the drive shaft from the vehicle.
hope thei info helps.
sammyc47

Feb 24, 2011 | 1995 Jeep Grand Cherokee

1 Answer

Where can i get the ratio for a 1995 jeep grand cherokee rear axil?


Check the tag bolted to the cover on the rear axle. If it has already been removed, check the tag on the cover (also bolted) of the front rear. 3:55 and 3:73 are the most common. Otherwise, if you remove the rear cover, count the teeth on the big gear, then count the teeth on the smaller one (right or left). Divide the larger number into the smaller number to find the ratio. Hope that helps. If so please rate my assistance and leave a testimonial.

Dec 29, 2010 | 1995 Jeep Grand Cherokee

1 Answer

Hello. Where s the drain **** and the drain plug on jeep grand cherokee limited 1995?


Hi,

If you look under the engine you will see the drain plug at the rear of the engine sump.
You may need to remove the under belly shield to see it.

Hope this helps.

Thanks

Jason

Aug 17, 2010 | 1995 Jeep Grand Cherokee

1 Answer

Back passenger rear wheel is locked


It sounds more like your rear end has a bad bearing or a bad pinion gear. If it has high miles it may be time for a rebuild. It could be brake related also, take off the back drum and see if anything is rattling around in there or broken. If your not hitting the brakes they shouldn't engage.

Apr 17, 2010 | 1995 Jeep Grand Cherokee

2 Answers

How to change rear brake pads on a 1995 jeep grand cherokee


The Caliper PISTON Requires CLOCKWISE Turning to Open for Recieving New Pads, And if you Have Metal to Metal the Rotor Is BAD NOW and Will Need to Be Rerplaced. If you Need Illistrations on this I Can Email you Full Instructions. Im @ rejakwilson @ aol.com

Sep 27, 2009 | 1995 Jeep Grand Cherokee

Not finding what you are looking for?
1993 Jeep Grand Cherokee Logo

Related Topics:

73 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...