Question about 1990 Toyota Camry

1 Answer

Drivers side window off track - 1990 Toyota Camry

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 1,986 Answers

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. Then pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything.

Posted on Aug 13, 2009

3 Suggested Answers

  • 3 Answers

SOURCE: DRIVER SIDE WINDOW OFF TRACK

you must pull door panel off (you can find the tool at any parts deals) then lift the window up with hands only it is hard but can be done get some one to hold the window glass up and check to see if any parts have fall if so put back on or replace. if not missing clean track and crank up to glass and line up. wind up and down to make sure it stay and then re-place door panel. hope this works it did for me on my 95 contour

alienphone

Posted on Jul 05, 2009

  • 1986 Answers

SOURCE: Drivers side window has slipped off track 2006 mazda mpv

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Pull back the weather seal and you can readjust the window mechanics.

Posted on Sep 29, 2009

  • 131 Answers

SOURCE: driver's side window came off track. How do I

gently pry the triangular speaker piece off the top there will be a screw under the handle, in the armrest of the door and around the edges most of the screws will have a plastic cover on them that pop off with all the screws out gently pry around the edge of the panel there will be 7-10 plastic push pins take your time they wont come out very easy but if you hury you could break the door panel once its free on the bottom and sides lift upward on the panel there will be a ledge the top hooks over on re-install make sure the edge is all the way over to have a good seal hope this helps good luck

Posted on Mar 17, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The drivers side window is off the track and now im having problems getting it closed


you can sometimes get it back in by lowering the window all the way down, pry or hold open the felt seals on the door, and look into the door with a flashlight, you might be able to get it back in track by moving the window back and forth (be carefull not to strain glass or it will shatter).. may have to remove door panel to put glass back on track.

Dec 15, 2013 | 2003 Chevrolet Malibu

1 Answer

Driver side glass not attached to track


you need to remove the door trim to see if something is broken

Aug 05, 2013 | 2004 Pontiac Montana

1 Answer

Drivers side window on a 2005 Jeep Grand Cherokee falls off track


Have to remove the inner door panel,
to see the problem
Most likely a broken window regulator

Jul 13, 2013 | 2005 Jeep Grand Cherokee

1 Answer

My 2004 acura rsx. the window track clips dont stick to the window when they go down. so the window works fine when it goes up. but doesnt come down with the track clips. is there a adhesive i can buy. or...


I had the same problem with our 2004 RSX. First the driver's side window now the passenger side. They tried to glue the window back twice (driver's side) and ended up having to replace the window and tabs. Now the passenger side did the same thing. My wife put up the window and it kept going, coming out of the track. I'm assuming the window will have to be replaced. Waiting for Acura's ruling. Must be a flaw in the tabs/glue...should have been a recall.

Jan 18, 2011 | Acura RSX Cars & Trucks

1 Answer

How do I remove driver side door window


You need to remove inner door panel by unscrewing the screws on inner door handle and take a flat screw driver wedge it between the panel and door use flash light to see the clips along the sides and lower part of door and pry them free. then look through the inner door cut outs to find window track. Once you see it use ratchet or screw driver and loosen the window free form track. Then carefully remove window.

Apr 01, 2010 | 2003 Mazda MPV

1 Answer

Drivers side door will not go up or down; window is off track and door will not open


Hello. You have two choices here on how to proceed. Often when this occurs, it is a sign that the window motor and the track inside that door are on their "last legs" This assembly is called the power window regulator and it can be found on the net for about $75.00 So, you may either put the window back in the track and hope for the best or you may choose to replace the power window motor and the track, which comes as one unit called a driver's side door power window assembly. Either way, you have to remove the inner door panel to expose the track and the motor and the glass.

Jan 25, 2010 | 2002 Chrysler Concorde

2 Answers

Driver side window falls down it is a power window


Window has come off track,try to lube the track, reset the window in the track an use a apoxy glue let it sit for a few hours an it should b fine that's what I did to mine, that last snow storm we had my truck was covered,I was keying my truck warm up I went to open the window it was stuck, so I gave it a little hit an then it fell in the door an the snow came in lol, then I found out what to do I never had a prob again

Jan 02, 2010 | 2001 Ford Expedition

1 Answer

Driver side window is falling down on its own


You need to replace your window regulators. (The tracks/pulleys and cables.)

May 14, 2009 | 1991 Nissan Maxima

1 Answer

2002 Mitsubishi Mirage Driver Side Window


If it is a power window you will need to get a new motor for it.If its' a manual window crank it's just off the track you just gotta pull the door panel off to put it back on track you might have to go to a junk yard to get the parts to put it back on track.

Nov 06, 2008 | 2000 Mitsubishi Mirage

Not finding what you are looking for?
1990 Toyota Camry Logo

Related Topics:

209 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...