Question about 2005 Dodge Durango

1 Answer

Hi there! I have a really bad problem in my Dodge Caliber SRT4. Car will not start any longer, began to shut down while driving. It took about 30-60 seconds, and then started up again. now there is no

Hi there! I have a really bad problem in my Dodge Caliber SRT4. Car will not start any longer, began to shut down while driving. It took about 30-60 seconds, and then started up again. now there is no longer a source of running at all. headlights and turning signals was also problematic. where the problem could be? BCM (Body Control Module)? ECU? Anti-theft system? How to solve this problem? where is the car's BCM, or is it at all?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 119 Answers

Need to check the intelegent control module on fuse box but first check distriburator /fuel presure /or crank sensor

Posted on Sep 09, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
fknstart
  • 404 Answers

SOURCE: 2005 dodge durango anti-theft system

have you tried starting the car ,if not lock the car, open with key manually and try and start

Posted on Jan 05, 2009

SOURCE: car starting probs

u need a new key the Senty key Immobilizer module has not recognized a signal from the key during engine startup and means that the Skim anti-theft system has locked the engine down.

Posted on Jul 13, 2008

  • 1 Answer

SOURCE: 2009 dodge durango will not start

it could be that the theft system has something to do with it .it proably that the ignition system has a device in the module the locks the system up when the theft system has been activated you should have the dealer check the ignition system or the theft system check.

Posted on Feb 12, 2009

BPALepine
  • 61 Answers

SOURCE: 04 dodge intrepid sxt not picking up fuel, wont start

You may have to replace the fuel filter, the fuel pressure regulator or the fuel pump.

First I would check the fuel pressure and also check for leaks. If there are no leaks and the pressure is fine than your fuel injectors are probably clogged or you may have an ignition problem or even a compression problem.

If you don't have good pressure and there are no leaks I would first replace the fuel filter or the fuel pressure regulator. If problem still exists I would then check and replace the fuel pump.

If you need any help in any one of these procedures just post it and I will give you step by step instructions.

Posted on Apr 22, 2009

Molson02536
  • 3854 Answers

SOURCE: 97 Dodge Caravan Auto-Shutdown Problem

Been working on my dad's 97 Caravan longer then i can remember for things you mentioned and have been not able to get him to sell it.
I found that the electrical connections are prone to corrosion and have replaced lots of the wire and pin connection in the wire harness, thank god i have time on my hands.
The instrument panel where the wire harness connects, i found that the solder goes bad and i had to re solder the connector on the back side of the circuit board, where the harness goes so you need to remove the instrument panel from the dash,
Here is a link that can help you retrieve DTC codes and do research on your caravan. I'ld tell you everything what i needed to do to keep my dad's caravan running but that would be a novel. http://www.allpar.com/fix/stall.html

Good luck and keep me posted, glad to help you keep yours running too.

Posted on May 26, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Steering fluid leaking bad noise 2007 dodge caliber sxt


Hi, if your steering pump make noise because of less of transmission fluid.
Fix your leak first don't run the pump without trasmission you going to damage the pump. Where the transmission is leaking.

Mar 03, 2014 | 2007 Dodge Caliber SRT4 Hatchback

1 Answer

Electronic Throttle Control Indicator Light dodge caliber 2007


Stop using the car--period

Have it checked for codes,road tested &
diagnosed

I think you have very bad ignition coils that
put it into failsafe

They are so bad they spike the computer &
take out the throttle postion sensor signal &
you get ETC Failsafe

Can't use it like that-- it will ruin the exhaust converter

Dec 21, 2012 | 2007 Dodge Caliber SRT4 Hatchback

1 Answer

Cannot get defrost or floor vent to work in 2007 dodge caliber


The bottom line is this, you must take it apart and inspect the cause of the problem, guessing is really not an option here.

Nov 02, 2012 | 2007 Dodge Caliber SRT4 Hatchback

1 Answer

I need to remove the battery from my2008 dodge caliber, I got the cables off but it won't come out


Dodge caliber 2009 .Hi my car doesnt wormed up inside fast and i ready changed the termostat . What else can i do ?

Oct 08, 2012 | 2007 Dodge Caliber SRT4 Hatchback

2 Answers

Are there any 2007 caliber srt4 with automatic transmision


YEP 2007 DODGE CALIBER HAS A JATCO CVT2 AUTOMATIC TRANSMISSION.

Oct 06, 2011 | 2007 Dodge Caliber SRT4 Hatchback

1 Answer

Hi. My Dodge Caliber 2008 only start un neutral position. In Park position doesn't display "P" in the panel. Thanks!


could be the shifter needs an adjustment to line up properly - alternatively it may be the switch is loose when you put it into part, so that it doesn't click to release the "lock" indicator allowing the vehicle to start in park position... I think it is the alignment - needs adjustment.
Ck

Feb 13, 2011 | 2007 Dodge Caliber SRT4 Hatchback

1 Answer

Wont always start


Did anyone check the clutch interlock switch? It's possible the position is out of adjustment. My 2008 SRT4 is right at the bottom. If you don't push the clutch ALL the way down, it won't start.

Apr 17, 2009 | 2008 Dodge Caliber

Not finding what you are looking for?
2005 Dodge Durango Logo

124 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...