Question about 1998 Chevrolet Cavalier

1 Answer

Evap emission system

Check engine light is on. getting an evap emission system reading.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 95 Answers

Have same problem with my 2002 Silverado. Changed purge valve. Still no luck. There is a fitting for forcing smoke into fuel system to find leaks. I checked out a friends Trailblazer (same code) Someone stole his gas cap. Bad gas cap can also cause this code. You can ignore this code. It does not have any effect on engine performance, but if you have to pass emision test must be repaired

Posted on Apr 23, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 1996 Chevy Blazer check engine light on

More then likely its the Canister Purge Solenoid. you can find it online at www.autozone.com the part number is PV140. And to replace it on blazer you have to remove the spare tire. Alot of people don't know where this part is so I hope this helps you and good luck.

Posted on Oct 14, 2008

  • 71 Answers

SOURCE: P0441 EVAP Control System Incorrect Purge Flow

Test the purge valve and the vent valve for leaks. This can only be done with a Tech 2 and or a vacuum pump.

Posted on Jun 21, 2009

  • 1 Answer

SOURCE: check engine light emission leak

youll have to take it a shop and have them fill the system with "smoke" and examine the entire system for the "smoke". the smoke will pour out from where ever it is leaking from

Posted on Jul 15, 2009

  • 2841 Answers

SOURCE: 08 Impala - Check engine lite on - Large Evap leak detected

If it is missing or not running perfectly you can damage the Oxygen sensors or the catalytic converter. If it is running perfectly then more than likely no damage will be done, but you still need to have it looked at by a professional with the proper tools and skill to diagnosis the problem and not just throw parts at it. The PCM and catalytic converter are covered by an 8 year 80,000 mile warranty whichever comes first. To know if your defect is covered which is highly unlikely, you need to talk to your local GM dealer.

Posted on Jun 07, 2010

Testimonial: "Appreciate the help. It really was helpful."

SOURCE: I have a 2006 Chevy Cobalt with the check engine

Did you get gas shortly before the light came on? It's not uncommon for a loose gas cap to set this code. Take the cap off and look at the seal. If it's cracked replace it with a new OEM cap. If not, reinstall it and make sure it's on all the way. Then you can clear the code and see if it comes back.

Posted on Jul 24, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Location for 2006 buick rainier EVAP purge solenoid


You should have an EVAP leak test done . It could be a leaking purge valve , you could need a new gas cap as well or it could be the fuel filler neck . or assorted hoses or the fuel tank pressure sensor . If the check engine light is lit there will be a code .
DTC P0442: Evaporative Emissions (EVAP) System Small Leak Detected or
DTC P0455: Evaporative Emission (EVAP) System Large Leak
DTC P0446: Evaporative Emissions (EVAP) Vent System Performance
You have to jack up the vehicle , the purge valve is attached to the engine behind the A/C compressor .

Dec 01, 2015 | 2006 Buick Rainier

1 Answer

Emissions Code


Error Code: P0441
Fault Location:
Evaporative Emission (EVAP) System - Incorrect Flow Detected
Possible Cause:
Malfunction Indicator Lamp (MIL) active.
- Purge control VSV connector disconnected.
- Evaporative Emission (EVAP) Canister Purge Regulator Valve is faulty/jammed.
- Evaporative Emission (EVAP) Canister Purge Solenoid Valve faulty/jammed.
- Evaporative Emission (EVAP) Canister Sealing faulty.
- Pipes between Tank Breathing and Throttle Body leaky/blocked.
- Hose connection(s).
- Intake leak.
Solutions:
- Check Evaporative Emission (EVAP) Canister Purge Regulator Valve.
- Perform Output Test.
- Check Evaporative Emission (EVAP) Canister Purge Solenoid Valve.
- Check Evaporative Emission (EVAP) Canister.
- Perform Basic Setting.
- Check Pipes between Tank Breathing and Throttle Body.

Jan 10, 2014 | Toyota Cars & Trucks

1 Answer

Diagnostic code p0701


P0453 means EVAP emission pressure sensor high input. Possible causes:
- Faulty Evaporative Emission System (EVAP) Pressure sensor
- Evaporative Emission System (EVAP) Pressure sensor harness is open or shorted
- Evaporative Emission System (EVAP) Pressure sensor circuit poor electrical connection.
Code p0701 means Transmission control system range/performance. Possible causes:
- Open or short transmission control system circuit
- Poor transmission control system electrical connection
- Check powers and grounds to Transmission Control Module (TCM)

Aug 27, 2013 | Cars & Trucks

1 Answer

Where is evap emission


Your evap emission system is your pressurized fuel system. If you are getting a check engine light and the scan is throwing an evap code start by changing your fuel cap. It is the cheapest part of the system and quite common to fail. Unfortunately if you change your cap and erase your fault codes and the check engine light returns for evap system again, you will probably end up at the dealership to track down the leak.

Apr 20, 2013 | 2005 Buick LaCrosse

1 Answer

Toyota echo won't start code 440 441 446


Error Code: P0440
Fault Location:
Evaporative Emission (EVAP) System - Malfunction
Possible Cause:
Malfunction Indicator Lamp (MIL) active.
Soution:
Check Evaporative Emission (EVAP) System Sealing.
Check Evaporative Emission (EVAP) Canister Purge Regulator Valve .
Check Evaporative Emission (EVAP) Canister Purge Solenoid Valve .

Error Code: P0441
Fault Location:
Evaporative Emission (EVAP) System - Incorrect Flow Detected
Possible Solutions:
Check Evaporative Emission (EVAP) Canister Purge Regulator Valve .
Perform Output Test.
Check Evaporative Emission (EVAP) Canister Purge Solenoid Valve .
Check Evaporative Emission (EVAP) Canister.
Perform Basic Setting.
Check Pipes between Tank Breathing and Throttle Body.

Error Code: P0446
Fault Location:
Evaporative Emission (EVAP) System, Vent Control - Circuit Malfunction
Possible Cause:
Wiring harness.
Evaporative emission (EVAP) canister purge valve.
Engine control module (ECM).

Feb 25, 2013 | 2002 Toyota ECHO

1 Answer

Po453 e150 econoline


P0453 - Evaporative Emission Control System Pressure Sensor High Input
Possible causes- Evaporative Emission System (EVAP) Pressure sensor harness is open or shorted
- Evaporative Emission System (EVAP) Pressure sensor circuit poor electrical connection
- Faulty Evaporative Emission System (EVAP) Pressure sensor
- Damaged fuel tank pressure sensor

Sep 05, 2012 | 2007 Ford Explorer Eddie Bauer

1 Answer

I have a 2003 Kia sorento 3.5 liter engine 2 wheel drive. Check engine light on reading code P0453 Evaporative Emission system pressure sensor / switch high input. Any idea what is the cause of this...


possible causes--- p0453-- - Rubber hose to EVAP control system pressure is clogged, vent, kinked, disconnected or improper connection.
- EVAP control system pressure sensor may be faulty
- EVAP posible solutions, - Retight gas cap - Replaced EVAP Control System Pressure Sensor. have a good day !!

May 19, 2011 | 2003 Kia Sorento

2 Answers

Check Engine lite comes on Code PO440


16824/P0440/001088 - EVAP Emission Control Sys: Malfunction Possible Symptoms
  • Malfunction Indicator Light (MIL) active
Possible Causes
  • Evaporative Emission (EVAP) System leaking
  • Evaporative Emission (EVAP) Canister Purge Regulator Valve (N80) faulty
  • Evaporative Emission (EVAP) Canister Purge Solenoid Valve (N115) faulty
Possible Solutions
  • Check Evaporative Emission (EVAP) System Sealing
  • Check Evaporative Emission (EVAP) Canister Purge Regulator Valve (N80)
  • Check Evaporative Emission (EVAP) Canister Purge Solenoid Valve (N115)

Jun 17, 2010 | 2000 Volkswagen Beetle

2 Answers

P0441 EVAP Control System Incorrect Purge Flow


Error Code: P0441
Fault Location:
Evaporative Emission (EVAP) System - Incorrect Flow Detected
Possible Cause:
Malfunction Indicator Lamp (MIL) active.
Evaporative Emission (EVAP) Canister Purge Regulator Valve faulty/jammed.
Evaporative Emission (EVAP) Canister Purge Solenoid Valve faulty/jammed.
Evaporative Emission (EVAP) Canister Sealing faulty.
Pipes between Tank Breathing and Throttle Body leaky/blocked.
Hose connection(s).
Intake leak.
Possible Solutions:
Check Evaporative Emission (EVAP) Canister Purge Regulator Valve .
Perform Output Test.
Check Evaporative Emission (EVAP) Canister Purge Solenoid Valve.
Check Evaporative Emission (EVAP) Canister.
Perform Basic Setting.
Check Pipes between Tank Breathing and Throttle Body.
VSV connector near air filter box disconnected.

Jun 15, 2009 | 1996 Chevrolet Monte Carlo

Not finding what you are looking for?
1998 Chevrolet Cavalier Logo

Related Topics:

134 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...