98 ford exsplorer only has3psi to the fuel pump and needs at least 7 how do i fix that

SOURCE: 98 ford explorer fuel pump pressure

hello i have 1996 ford explorer this promblem is computer display [air ride switch off ]signal all time /////
please answer

SOURCE: need to find the fuel pump shut off switch in 98 ford expedition V8 4.6

in the trunk on the left side behind the trim. its up top close to the the trunk seal

SOURCE: remove fuel pump from tank ford windstar 98

To gain access to the fuel pump, it is necessary to remove the fuel tank.

1. Depressurize the fuel system and remove the fuel tank from the vehicle.
2. Remove any dirt that has accumulated around the fuel pump module attaching flange, to prevent it from entering the tank during service.
3. Turn the fuel pump module locking ring counterclockwise using a locking ring removal tool or a brass drift and remove the locking ring.
4. Remove the fuel pump module.
5. Remove the seal gasket and discard it.

1. Put a light coating of grease on a new seal ring to hold it in place during assembly. Install it in fuel tank ring groove.
2. Insert the fuel pump module into the fuel tank, then secure it in place with the locking ring. Tighten the ring until secure.
3. Install the tank in the vehicle.
4. Install a minimum of 10 gallons of fuel and check for leaks.
5. Install a pressure gauge on the throttle body valve and turn the ignition ON for 3 seconds. Turn the key OFF , then repeat the key cycle five to ten times until the pressure gauge shows at least 30 psi.
6. Check for fuel leaks at the fittings.
7. Remove the pressure gauge.
8. Start the engine and check for fuel leaks.

SOURCE: ford windstar 98 gl 3.8

should not be ran out of tank unless in watter if ran dry it is bad now

SOURCE: I NEED TO RESET THE FUEL PUMP SHUT OFF SWITCH ON

leave the battery unconnected for ten min and locate the fuse if there is one, both at the same time