Question about Cars & Trucks

Open Question

Wiring diagram 2008 mitsubishi l200 pickup

2008 Mitsubishi L200 pick up A/C System wiring diagraam I need it.

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 7 Answers

SOURCE: Mitsubishi Pick up

check your transmission fluid, tune up plugs wires etc,good luck

Posted on Jun 20, 2008

Ad
  • 534 Answers

SOURCE: i have a mitsubishi l200 which runs very 'lumpy'

Look for a vacuum leak on the motor intake system, such as perished hose, loose inlet manifold or air intake fitting.
Check operation of the PCV valve and associated hoses.

Posted on Jul 09, 2009

Wolfman304
  • 720 Answers

SOURCE: Where do I find engine and chassis numbers on a

Hi,

The typical location of a Mitsubishi Identification plate, is usually found under the hood, riveted to the firewall (below the windscreen).

The plate will display all detail you require.





** If this has helped you in any way, please rate this solution **


Posted on Nov 13, 2009

  • 64 Answers

SOURCE: mitsubishi l200 4wheel drive light flashes

Hi, this is caused by a few things. It might be that the 4x4 switches on the transfer case are sticky or you do not have sufficient vacuum on the front diff actuator which is caused by a hole in one of the vacuum pipes or the vacuum solenoids not operating correctly. You can test the vacuum solenoids with your finger. Start the vehicle and pull off the vacuum pipes connected to the top of the vacuum solenoids. When 2wd is selected you should have vacuum on one solenoid and when 4wd is selected the vacuum should change to the other solenoid.

Posted on Nov 23, 2009

Danniboi
  • 1098 Answers

SOURCE: mitsubishi l200 animal 2006 leaking oil from steering rack

Its most likely a seal on the power steering rack by the age it will most likely just be a seal they are about £7 in UK but possible the rack is goosed although I doubt it, please be careful using the car as it can lock the steering in position, and,,,, well you get it.

Posted on Jan 13, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Electric wiring diagram mitsubishi L 200 turbo


Search "wiring diagram Mitsubishi L200 turbo"

Aug 01, 2015 | Mitsubishi Cars & Trucks

1 Answer

Hw can i get a wiring diagram for the fuse box under the bonnet on a mitsubishi l200 2007


go to your mitsubishi dealer and ask for it theyll give it to u for free.

Apr 23, 2015 | Mitsubishi L200 Cars & Trucks

1 Answer

Hello, in my Mitsubishi L200 (2004) the circuitbreaker ( no 4) for my tail- and dim lights keeps popping. So I am searching for the wiring diagram to find out what could cause this short circuiting


You may have a shorted light in one of the tail or turn signal assemblies. You can get a wiring diagram, but you will still start there; testing all four corners, all lights and wires behind the plugs, and you will find the culprit. If you have a tow package, try disconnecting the trailer plug. Those go bad and you will spend days tracing nothing !

Sep 14, 2014 | 2006 Mitsubishi L200 2.5

1 Answer

I have purchased recently a 2003 Mitsubishi L200 pick up truck Diesel 2500 cc.\r\nI need a service nanual for the above truck and and tips on its regular service (i.e frequency of oil changes or other...


You can try this site. It is free. You can either read it on the site or down load it. Have a good one Nick. www.doocu.com Sometimes takes a second to find, but it has all you need.

Feb 18, 2011 | 1988 Mitsubishi Pickup

1 Answer

How do i replace the front brake disc on l200 4 door pick up 02MY


Remove the wheel
Take out the caliper bolts
press piston back into caliper with a brake tool or c-clamp
put new pads in
replace caliper
replace wheel
PUMP BRAKES UP MANY TIMES TO SEAT PADS
Your Done

Jan 30, 2010 | 1988 Mitsubishi Pickup

1 Answer

When i turn my front fog lights on my L200 warrior pick up , the side lights come on instead of the fog lights . what causes this ?


a short can be causing it wires can be touchin making ur sides lights come on instead of the fog lights

Nov 14, 2009 | 1988 Mitsubishi Pickup

1 Answer

ABS light has come on on my mitsubushi l200 pick-up yr 2002


there may be a problem with your anti-lock braking system. I recommend taking it to a brake mechanic

Jun 26, 2008 | 1986 Mitsubishi Pickup

1 Answer

Mitsubishi Pick up


check your transmission fluid, tune up plugs wires etc,good luck

Jun 19, 2008 | Mitsubishi Pickup Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

142 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...