Question about Cars & Trucks
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
click on this link, and scroll down to 5.7L
Posted on Dec 22, 2008
Open up the tail gate, you will see two torque screws on the inside beside the tail lights. take these out, this will free up the housing and you can change it from there.
Posted on Feb 01, 2009
very easy take the mirror inside cap off if you can not get to the 3 bolts then you will have to take trim panel off to take trim panel off look for plastic caps take them out and unscrew them then pop out the bottom of the door and pop the sides out then lift up and out should be loose enough for the bolts now/ 10mm bolts 3 Please rate my response thank you very much
Posted on Feb 02, 2009
The combination fuel filter and fuel pressure regulator is used on all engines. It is located on the top of the fuel pump module. A separate frame mounted fuel filter is not used with any engine.
Both fuel filters (at bottom of fuel pump module and within fuel pressure regulator) are designed for extended service. They do not require normal scheduled maintenance.
Posted on Mar 22, 2009
SOURCE: location of oxygen sensor
I believe you may have three (3) O2 sensor, (2) of the sensor is on ether side of the exhaust down pipe and some times called up stream O2 sensor, the third O2 sensor know to some as the down stream O2 and is after the Catalytic converter.
The up stream O2 monitors the left and right side banks and sends signals to the ECM to make the adjustments to the injectors to keep the proper air/fuel ratio.
The down stream O2 monitors the catalytic converter and sends signal to the ECM if the catalytic converter has gone bad.
Good luck and hope this helps. If you get it scanned at Auto Zone, they should be able to let you know which O2 has gone bad so as to not change all three. You could always check the wire harness to the down stream O2 for corrosion. Keep me posted
Posted on May 29, 2009
Tips for a great answer:
Mar 02, 2015 | Dodge Cars & Trucks
Jan 16, 2015 | 2004 Dodge Ram
Oct 15, 2014 | Cars & Trucks
Apr 07, 2013 | Cars & Trucks
Mar 22, 2013 | 2004 Chevrolet Avalanche
Mar 20, 2012 | 2004 Dodge Ram 1500
Apr 12, 2010 | 2001 Dodge Ram 1500 Truck 2WD
Mar 22, 2009 | 2000 Dodge Ram 1500 Truck
100 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: