Question about 2006 Hyundai Tiburon

Open Question

Anti theft system in my 2006 hyundia tiburon.... my remote was damaged and cant find the other on... why does my car not start

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

ghost4548
  • 776 Answers

SOURCE: Hello accent 2004 with anti theft system battery flat anti theft

Have you verified this system is running the battery down? The system you describe is called the Remote Keyless Entry System (Electronic Time/Alarm & Control System - ETACS Module). It cannot be 'disconnected' without disabling other systems (intermittent wipers, Chime bell, Door Warning, Dimming Off Room Lamp, Seat Belt indicator, remote power door lock/unlock system, etc.)

f92f17f.jpg

Posted on Jun 29, 2009

1fastbob
  • 301 Answers

SOURCE: 2006 hyundia tiburon clutch slips bad when you put

Usually when a clutch slips it need replaced. Take it to your mechanic. It will cost some bucks.

Posted on Sep 23, 2009

  • 1 Answer

SOURCE: My 2004 Tiburon GT will not unlock with the

you can get it to crank but you just won't be able to use the keyless function without going back to the dealer first locate the ecu fuse in the fusebox under the dash, pull it out but don't put it down. Next put your key in the ignition and start turning over the motor, now the car won't crank or push oil through the motor with the ecu deactivated so don't hold it for too long. Now as your turning the motor over, reinsert the ecu fuse. The car will fire to life...you will have essentially reflashed your ecu so people with tuned ecu's beware. Your keyless won't work but hey at least now you can drive to get it fixed...as for the naysayers, yes I tried this on my tiburon and it still works fine so don't worry...good luck

Posted on Jan 21, 2010

BCAS1298
  • 3092 Answers

SOURCE: 2004 Hyundia Tiburon Battery replacement

Sounds like your alternator is bad, if car will stay running long enough to get over to an auto parts place where they can do an alternator test for free have it check or you can remove alternator and take it to them so they can test it. or with a volt meter start car remove jumper cables and check voltage at battery, should have no less then 13.5 volts, what your checking is alternator output voltage.

Posted on Jun 04, 2010

40longyears
  • 275 Answers

SOURCE: new battery new starter only clicks will not start

Sounds like you should see if the engine is frozen by trying to turn over the engine by hand with a torque wrench or gripping the belt.Make absolutely the new battery has a sufficient charge by using beefy jumper cables. make sure all your connectors are really clean and tight.

Posted on Oct 11, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My car thinks it is being stolen 2008 Ford Fusion anti theft has disabled ignition. Tried disconnecting the battery; remote entry with ikt; using key to unlock; hit panic button and turned it off with...


Hi Eileen , How do you know your having a anti-theft system problem ? Any lights flashing when you try to crank the vehicle ? The engine does not crank over ? If it is a anti-theft system problem ,disconnecting the battery is not going to do anything except lose some learned setting's in some control modules . There are a few thing's you can check but if none of these are the problem your going to have to have it towed to the dealer ! It'll need to be checked for DTC'S - diagnostic trouble codes !
PATS disables the vehicle from starting if there is:
  • a damaged PATS key.
  • a non-programmed PATS key.
  • a non-PATS key (key has no electronics).
  • damaged wiring.
  • a damaged transceiver.
  • a damaged instrument cluster.
Inspection and Verification
  1. Verify the customer concern.
  1. Visually inspect the following for obvious signs of mechanical or electrical damage.


Visual Inspection Chart Mechanical Electrical
  • Large metallic objects, a second passive anti-theft system (PATS) key on the same key ring as the PATS key, or electronic devices on the key ring that can be used to purchase gasoline or similar items
  • Ignition lock cylinder
  • PATS key
  • Use of a non-PATS key or incorrect PATS key
  • More than one PATS key on key ring
  • Remote start system installed
  • Smart junction box (SJB) fuse(s):
    • 13 (7.5A)
    • 23 (7.5A)
    • 26 (7.5A)
  • Circuitry
  • PATS transceiver
  • Ignition switch
  • Instrument cluster
You may not know where some of these things are located !

Mar 22, 2015 | 2008 Ford Fusion

1 Answer

How to disconnect anti theft


It is hard to give a definite answer because I don't know which and how many wires were damaged...Anti theft can be a real HEADACHE.....You can begin by disconnecting battery cables..Use your VIN number for parts,Get new ignition with a programmed factory key from dealer only.....They probably blew certain fuses and or relays when this happened...Or maybe not..Install new ignition connect battery cables..,turn switch on just to check for bad fuses and relays...Disconnect battery again...replace any fuses blown...Connect battery again...( Each time you disconnect battery it resets the computer system and should clear anti theft codes..)..make sure all doors are unlocked by using door remote key fob....Now see if vehicle will crank..If all is done correctly it should start...However I don't know how much damage was done.....It may possibly be too much work to totally disengage anti theft....You could start with removing all fuses and relays related to anti theft but disconnect battery before...I DO NOT RECOMMEND trying to disable the theft system.....You may create more headaches that you want.......Begin by trying what I described just to be safe...!!....

Jan 27, 2015 | 2001 Ford Windstar

1 Answer

Citroen c3 2006 anti-theft


I had the same problem.when I used my main key my car wouldn't start and I got the message "anti theft faulty". The key and the remote still unlocks and locks the doors and turns the lights on/off but it just wouldn't start my car. I was able to start my C3 by using the spare key. The main key is still faulty and if used brings up the same message.

Oct 30, 2012 | Citroen Agusta F4 R312 1 plus 1 Cars &...

1 Answer

Flooded Hyundia Tiberon 2007


If your Hyundai, Tiburon refuses to start, it may be something more serious than a flooded engine. When the spark plugs look fine and the fuel injectors are running well, you may need a new charging or starting system for your car. If the starting system fails, then you need a new unit in order to get your Hyundai, Tiburon back on the road. The starting system in your Hyundai, Tiburon includes many parts such as the battery, ignition switch, starter motor and solenoid. Once you have the source of the problem contained, you have complete access to quality replacement parts here. Whether the battery dies or the ignition switch fails, you can find the parts you need for your Hyundai, Tiburon. Get your car back on the road when you check out this selection of charging and starting systems for your car.

Jul 22, 2012 | 2007 Hyundai Tiburon

1 Answer

How to reset the anti thief system of a 2006 pacifica when you have lost you remote


You cant bypass the anti-theft system. The dealer put that package in there so it couldn't be stolen. You need to go to the dealer for reprogramming. Probably will be $150.

Nov 20, 2009 | 2006 Chrysler Pacifica

2 Answers

How to reset factory anti theft system dodge intrepid


how to reset the anti theft system for my 2006 dodge ram 1500

Oct 19, 2009 | Cars & Trucks

1 Answer

2000 Hyundai Tiburon will not start


There is NO possible electrical cause (within REASON) which would create the problem you describe. I assume you tried the Keyless Entry Remote to DIS-ARM the anti-theft system. If the ALARM system was activated, it will stay activated until it's de-activated by the remote (typical design feature). The best SOLUTION is to take vehicle into Hyundai an have the problem diagnosed.

May 29, 2009 | 2004 Hyundai Tiburon

1 Answer

No. i need to find the fuse for my alarm system. and i don't have a manual


Section 13-11: Anti-Theft System, Active 1998 Villager Workshop Manual DIAGNOSIS AND TESTING Inspection and Verification
  1. Verify customer concern by operating the anti-theft alarm system.
  1. Visually inspect the following components of the anti-theft alarm system:


    VISUAL INSPECTION CHART Mechanical Electrical
    • Door lock key cylinders binding
    • Loose hood anti-theft switch
    • Blown fuse(s):
      • 7.5A S.E.C.
      • 10A ELECTRON (IGN)
      • 30A PWR WDW
      • 15A HORN
    • Damaged circuit breaker #1
    • Damaged or corroded anti-theft relay
    • Broken or loose wiring
    • Damaged,loose or misaligned hood anti-theft switch
    • Damaged or loose luggage compartment lamp switch
    • Damaged or loose door courtesy lamp switch(es)

  1. Verify that the following systems are operating correctly:
    • Horn.
    • Headlamps.
    • Instrument cluster and panel lighting.
    • Power door locks.
    • Keyless entry remote transmitter (if equipped).
    If any systems are not functioning properly, refer to the appropriate section of this service manual for diagnosis and testing before proceeding.
  1. Check wiring harness for obvious signs of looseness, corrosion, or damage.
  1. If the fault is not visually evident, determine the symptom and proceed to the Symptom Chart.

Apr 19, 2009 | 1998 Ford Expedition

Not finding what you are looking for?

Open Questions:

0 Answers

Shifting problems My car is a 2006 Hyundai Tiburon, Automatic, 2.0L 4 Cylinder I've had the car two years I don't know what's related and what isn't so here is the story. Bought car, (cruise control did not work) but everything else seemed fine, engine light came on code read Vehicle Speed Sensor so I bought an input and an out transmission speed sensor and had them installed, Motor blew 2 heads had motor replaced with an almost new motor. Cruise control now works, three days later car would not come out of park shifter moved but car stayed in park felt like shifting cable let loose, I called a backyard mechanic friend and he moved the shifter hard and it went into drive said probably buddy who changed motor forgot to unhook cable and stretched it (made sense to me) it did this everytime car was put into park had to yank on the shifter to get it to shift so I started parking her in neutral and it never messed up, after 3 weeks my new shift cable came in so I went to show my mechanic what car was doing it wouldn't do it worked fine, told him I'd call him next time it messed up this is a year and a half later hasn't messed up like that again! I had already bought the cable so I decided to have it installed anyways even though problem seemed fixed went to a shop they told me nothing is wrong with my cable..... Approx 6 months ago put car into drive and started driving the car reved out (I call it) motor got really loud and RPM gage went to 4K and car jerked really bad and made a really loud snap noise so I pulled over and roughley shift car into park and back into drive and drove this fixed the issue for that drive anyways.... my car one day over heated to red line in a 5 minute drive in the winter my mechanic said must be an air lock so he drained my fluid and replaced ect, next day car wouldn't start, blew starter, replaced that, next day driving car and in a 5 minute drive it overheated to red line took car to shop he said gage is reading wrong car is barely even warm so I decided to take the car home and worry about this issue pay day well the next day car wouldn't start, blew alternator, at this time my mechanic looked over car more closley turns out I had a bad ground so he put on new alternator and new ground, this was a month ago and no more issues with overheating or not starting. However I still have this issue (copy and paste) "put car into drive and started driving the car reved out (I call it) motor got really loud and RPM gage went to 4K and car jerked really bad and made a really loud snap noise so I pulled over and roughley shift car into park and back into drive and drove this fixed the issue for that drive anyways...." After having ground put on and shifting issue still there I took my car directly to Hyundai they ran all their computer tests and transmission tests and took car for a test drive car worked fine and only code that came up was Vehicle Speed Sensor. So here is where I stand first question how many speed sensors does my car have is a transmission input/output speed sensor different then a vehicle speed sensor? I looked on parts sites and only speed sensors I find are ABS speed sensor and Vehicle Speed Transmisson Sensor, so maybe sensors I bought are no good but they were bought new or maybe the connector for the sensors are bad? I don't know any suggestions would be greatly appreciated.

Jan 12, 2016 | 2006 Hyundai Tiburon

See all 2006 Hyundai Tiburon Questions

2006 Hyundai Tiburon Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8201 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...