Question about 2002 Mazda MPV

2 Answers

Engine cutting out at stops occasionally

When i stop at traffick lights car engine will cut out, sometimes but will start again .This does not happen every time i stop.

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Alternator

Posted on Jan 27, 2016

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

Could be fuel filter clogging up... fuel pump, or bad alternator going out...

Posted on Mar 12, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2010 subaru forester engine cuts out


consider this
when at the stop lights , you will have your foot on the brake as it will still be in drive or in gear and you don't want the car to move
a simple test is to apply the hand brake to stop the car and don't touch the foot brake
if it idles ok but cuts out when you apply the foot brake , replace the brake booster as it has a vacuum leak that is causing the problem
you can do this test in the garage by starting in neutral and allowing the engine to idle , then apply the foot brake
iof it dies it is the booster

Oct 01, 2016 | 2010 Subaru Forester

1 Answer

Engine cuts out while driving


CHECK CRANK SHAFT SENSOR.

Jan 30, 2016 | Cars & Trucks

1 Answer

I was accelerating away from traffic lights,i was waiting for it to go into top gearand the stop light came on, i lost power steering and engine cut out. i turned everything and started it again with no...


Check what rpm's you had when the engine cut out as you probably exceeded max rpm's setting for safe engine / rear box operation as set by sensors in the ECM

Apr 19, 2014 | 2000 Renault 181

1 Answer

My truck cuts off in first gear


Any sounds or smells?
Check engine light on?

Mar 19, 2014 | 1995 Chevrolet K1500

1 Answer

My vehicle cuts out and stalls when stopping and cornering sometimes, it alsoseems to want to cut out when driving occasionally . i have changed the oxygen and air fuel sensors as i did have a engine


If check engine lights is off since replacing air fuel ratio sensors then try cleaning throttle body. If light is on, check for DLCs If same codes , change mass air flow sensor and clear codes and retest

Nov 18, 2013 | 2003 Toyota RAV4

2 Answers

2009 c-class auto stalling when stopping?


Throttle sensor on the engine is the only thing that would cause this to happen.Have it checked or do a diagnostic yourself with a code tester.Get the code and look in your manual for that code.The engine management/check engine light will always come on after a stall when swich is still on.Comes on when you turn the swich on at startup also does it not.Computers ya know.

Aug 28, 2012 | 2009 Mercedes-Benz C-Class

2 Answers

2002 Jeep Wrangler 4.0 When Driving the Engine Dies


Put the key in the ignition and turn it on and off (3) times without starting the jeep, leaving it in the on position count the (1) flashing indicator Light, Eg: (5) flashes, Then there will be a pause, then it may flash (3) times, this is a code #53. Keep your Eye on them and write them down. If you should miss (1) Repeat as many times as needed, Info: A #55 means there are no codes!!

May 30, 2009 | 2002 Jeep Wrangler

1 Answer

1989 Cherokee stalls at low speeds, i.e. stop lights


could also be bad map sensor and crankshaft sensor postion on top of trannny near engine and map on firewall behind engine with one plu and a vac line same problems on my ride and this hooked it up

Apr 30, 2009 | 1989 Jeep Cherokee

1 Answer

Will cut out at speed. And then starts again.


boost too high,theres a boost cut out that interupts the engine by cutting out split seconds to stop overboosting,is it stock or has there been mods done

Mar 07, 2009 | 1995 Subaru Impreza

1 Answer

Squealing and turning off


check to see if the power steering pump is binding do you have the defroster on when this happens? if so it maybe the a/c compressor turn the defroster off and try to start it .

Mar 02, 2009 | 2003 Ford Mustang

Not finding what you are looking for?
2002 Mazda MPV Logo

Related Topics:

298 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

69199 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22026 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6817 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...