Question about Cars & Trucks

Open Question

Passing gear 97 FORD F-150

PASSING GEAR STOPPED WORKING TODAY.transmission shifts good when taking off slow,but if you take off fast,you got to let off gas pedal for it to change gears,what could it be

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Trans clunking when slowing down

Sounds like youi may have a few serious problems going on to have that kind of back lash occuring at higher speeds. I have experiance with low spped clunks on Bronkos and your type of vech being a car dealer. One you might try for low speed clunk on take off and braking at stop likts just completeing a stop? Pull the drive shaft and lubricate the splin - two check your leaf springs for weakness and wore bushings - take a look at your shocks - three u bolts holding springs to rear axle housing may be letting the axle housing actually dip or tweak or all those thing in combination - now you may have some serious slop in the pig - transfer case may be causing that clunk - as far as high spped clunk and activity you have a serous problem and you just might drop the transferr case have an accident fliping over..............Mike South Bend Indiana don't just keep driving and making problem worst...........

Posted on Sep 27, 2008

jrod1125420
  • 161 Answers

SOURCE: transmission shifting funny.

sounds like either your transmission is having problems with the valves...might want to have that looked at before your transmission dies completely......also have them check vacuum lines as i believe that car uses vacuum pressure to shift.

Posted on Oct 01, 2008

  • 1 Answer

SOURCE: 2006 chrysler 300 transmission slips

Low on transmission fluid. The tranny fluid can only be checked by Chrysler, there is no dip stick, because you have to know the motor temp to be able to know where the fluid should register on the dip stick. Crazy!
Its not slipping now, but shifts hard. Has to be looked at by Chrysler again, but its done this since Ive had it, so I didnt realize it was a problem....

Posted on Oct 12, 2008

  • 1 Answer

SOURCE: 2001 Ford Windstar Van- transmission

i have a 1996 wind star van the over drive light is flashing and it downshifts sometime it seems like it is in over drive when you take off. is there a censor on the transmission that needs replaced

Posted on Oct 16, 2008

  • 1114 Answers

SOURCE: 2002 Ford F150 5.4L hard shifting

Have you ever changed the transmission fluid flush and replaced the transmission filter?

Posted on Jan 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

What causes 1996 Dodge Neon SOHC automatic transmission to delay or slip shifts?


that is a hum dinger, largest ever posted, in one shot.
very good.!
one word , the transmission slips. (never drive a slipping tranny)
overheat indicator.! that is key.
many newer cars will change the transmission shifting any time
the engine over heats.
and overheat wins over transmission , every time.
if the engine burns up, what good is any transmission.? nada.

solve overheat first.

slip or flare.
is when the engine RPM rises fast and the car dont go faster.
SLIPS.
and slipping burns up trannyclutchs and increases the damage. inside the transmission, dont do that. dont allow it,
park it and fix it.

on some tranny there is a temperature sensor that the TCM
watches and changes shift patterns based on AFT fluid temps.
and if the ATF fluid gets too hot , it takes actions. to keep the tranny from harm.

why not get a scan too and see what DTC errors there are..
DTC, engine overheate.
DTC< tranny overheat (caused by above)

Jun 14, 2014 | 1996 Dodge Neon

1 Answer

1994 automatic transmission A4LD slow upshift in all gears


low fliud pressure in transmission..check levels and change fluid/filter and retry vehicle.

Feb 10, 2013 | 1994 Ford Ranger Supercab

1 Answer

Transmition problems with 1989 ford f150 1/2 ton 2wd 5.0


Sorry bud you need a transmission repair or replacement.

Sep 19, 2012 | 1989 Ford F 150

1 Answer

1989 Ford F-150 4.9L 300 inline 6 cylinder 5 speed stuck in 3rd Gear? any solutions


If your clutch master cylinder is good in all other gears: you can disengage and, shift the other gears with the engine not running and, you have the correct amount of clutch fluid
in your clutch master cylinder: to release the clutch:
you have a broken 5th gear syncro and, a bent fork
remove the transmission and, when you remove the shift cover you will
see the problem; you must drain the transmission case remove any metal debris; remove the gear set and, replace the syncro...the fork can probably be
re-straightened use clean, new case oil when you reassemble the transmission.

Aug 04, 2010 | 1989 Ford F 150

1 Answer

97 FORD TRANSMISSION


make shure your livels are good that happned to me and i hand no trany oil

Apr 13, 2009 | 1997 Ford Taurus

1 Answer

No Power in Passing Gear


That means you're transmission is shot and you need to get a new one.

Mar 25, 2009 | 1997 Ford Thunderbird LX

1 Answer

Having a problem with my allison md 3060 transmission


Hi mate I had the same problem with a camper once and the only way that you will ever stop it from shifting hard into gears down shifting or up is to take it into a Detroit Allison work shop and ask them to reset the throttle position and reset Un-adaptive shifts then to do an Fast-adaptive shift with the electronic tool called Allison Doc.

Ask them also to do a clutch report on the electronic tool, that will tell you straight away the condition of the box on the inside.

Thats the problem with these new electronic transmissions they force you to go back to the suppliers. If I had my book here I could have helped you with the fault code but you would have had to take it in any way to get all the parameters reset.

What happens is that when you buy this trans new they set it to UN-adaptive shifts then to fast adaptive then it learns how long the solinoids should be open and how quick to open them to have a good shift, but over a few ignition cycles the fast-adaptive changes to normal over a year or two the clutch plates wears with a few 001 and the computer cant keep up have to be reseted which is normal to them, expect to take it back every year or two to be reseted.

Mar 20, 2009 | 1999 Ford Super Duty F 450

1 Answer

2002 Ford F150 5.4L hard shifting


Have you ever changed the transmission fluid flush and replaced the transmission filter?

Jan 11, 2009 | 2002 Ford F150 Regular Cab

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...