Question about 1999 Chevrolet Lumina

1 Answer

Hazard lights dont work. when i press the switch the dash lights dont illuminate and the exterior lights dont either. fuse is good since the horn works. Blinkers work so its not the flasher relay. Any ideas?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 14,337 Answers

I would go to Autozone and get a flasher relay,if it doesn't work,they will refund.

Posted on Jun 03, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 840 Answers

SOURCE: 1996 carpice classic park lights fail

their is another fuse box in the engine compartment check that as well

Posted on Jan 24, 2009

USfalcon
  • 175 Answers

SOURCE: horn does not work

check B+ in the horn pin and check the ground on the horn if there is B+ and B- just change the horn if there is no B+ on the horn conector replace the relay .
B+ = battrey power
B- = battrey ground

Posted on Mar 14, 2009

Molson02536
  • 3854 Answers

SOURCE: 97 Chevy truck blinkers not working but hazards do

Try replacing the Flasher first before spending to much money for a possible simple fix. If it's not your flasher then it could be the turn signal leaver.
Ok, this may seem stupid, but that's what they did to the blazer. They set the flasher near the middle and under the center console behind the radio.


It's to the left of the radio right behind the dash. The hazard flasher and the turn signal flasher are side by side.  It right next to the Cig lighter behind the panel. They do mark the turn signal from the hazard flasher on the plastic behind them. Turn is on the right.

Good luck and hope this helps.

Posted on May 02, 2009

VREGG
  • 41 Answers

SOURCE: Blinkers stay solid and dont flash, Hazards work fine.

CHECK GROUND ON TAIL LIGHT HOUSING.

Posted on May 08, 2009

duane_wong
  • 6826 Answers

SOURCE: i have a 1996 chevy s-10pick-up truck my blinkers

Flashers are generally located either under the dash (they hide them behind the horizontal panel) under the hood in the fuse box.

Also, relays can be hidden under the hood or in the fuse box.

The interior fuse box is where the 'turn signal' fuse is located.

Circuit Protection Fuses Underhood Fuse Block (Base) gm_truck_s10_undr-hd_fs-blk.gif

gm_truck_s10_undr-hd_fs-blk_chrt1.gif

gm_truck_s10_under-hd_fs-blk_chrt2.gif

Underhood Fuse Block (Except Base) gm_truck_s10_up-lvl_pk-up_fs-blk.gif

gm_truck_s10_up-lvl_pk-up_fs-blk_chrt1.gif

gm_truck_s10_up-lvl_pk-up_fs-blk_chrt2.gif

gm_truck_s10_base-pu_undr-hd_fs-blk-3.gif

I/P Fuse Block gm_truck_s10_i-p_fs-blk.gif

gm_truck_s10_i-p_fs-blk_chrt1.gif

gm_truck_s10_i-p_fs-blk_chrt2.gif

gm_truck_s10_i-p_fs-blk_chrt3.gif

prev.gif next.gif

Posted on Jul 19, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 91 mazda miata. my horn stopped working, buzzer isnt working and my hazards arent working either. i check to see if it was connecting it was. then i checked the fuses and relays, all were good. i...


Horn and brake lights are on the same fuse. Even if it looks OK replace it with a new fuse to be sure. Your 91 uses a 15-amp large-sized blade fuse for the horn/brakes.


The door buzzer is a separate plug-in module on the fuse box inside under the driver's side dash. If you're not getting any buzzing the whole module can be unplugged and replaced.

Last item to check would be the grounds located under the dash. I'd suggest tracing back from the hazard switch as that's easiest to access (but still not easy) and make sure all the grounds are clean and tight. Then the same for the horn switches in the wheel.

Aug 07, 2013 | Cars & Trucks

2 Answers

I have a 1995 grand prix Blinkers dont work but, other lights do.


First check turn signal fuse and relay if, they are good then try pressing on and off the hazard switch while turning the signal switch on.If signals start to work replace hazard switch.If hazard switch is good then replace turn signal switch.

May 02, 2011 | 1995 Pontiac Grand Prix

1 Answer

I just bought a 2000 Saturn SL 4-dr sedan. It's in great shape, but the horn doesn't work and the dashboard light don't work. Is this a simple fix with replacing the fuses or dash light or is it a little...


Check fuse for horn and for dash lights. If the interior lights work then suspect dimmer switch for the dash lights. If you press the horn button do you hear a click under the hood or inside the car? If you do not then the fuse is blown and if the fuse is good then the relay may be suspected bad. If the fuse is good and the relay clicks then suspect the horn to be bad. If fuse is blown and you put a new one in and you push the horn and the fuse blows again, then disconnect the horn before replacing the fuse again. Then push the horn button and see if you hear the relay click if you hear a click the the horn is bad or wiring butmost likely the horn. If you have the horn unplugged and the fuse is good and you push thee horn button and no relay click suspect the horn button to be bad. Hope this helps.

Sep 06, 2010 | 2000 Saturn SL

1 Answer

My brake, hazard and turn lights dont work, i


well u have two seprate problems the hazards and turn signals have a flasher that needs replacing if the fuse is good on the fuse box marked signals .and there is a brake light switch under the dash board near the brake pedal it has two wires on it check the wires make sure they are connected if so replace the brake light switch

Nov 13, 2009 | 2002 Chevrolet Astro

2 Answers

My brake lights wont work,i checked all the fuses,bought new bulbs,and bought a brake switch,and still nothing.my regular lights come on,just my brake lights dont work.dont no if this is part of the...


Just had a similar problem. Brake (stop) lights and horn didn't work. Couldn't find mention of stop lights in fuse chart. Found horn fuse to be slot 21 in the engine fuse block (not the fuse block in car interior). Replaced 15A fuse and all now ok.

Aug 21, 2009 | 2005 Mazda 3

1 Answer

WHAT IS A BTN FUSE ON A 1992 MAZDA MPV . IT HAS SOMETHING TO DO WITH THE HEADLIGHTS OR DIMMER SWITCH I THINK


BTN stands for Body/Tail/iNterior. It protects the HAZARD, ANTENNA, ROOM, STOP, ILLUM and ABS fuses in the cabin fuse box, which in turn protect the hazard lights, antenna, ECU memory, brake lights, tail lights2.gif, ABS, power locks, clock, horn, illumination, stereo, HVAC, interior lights and alarm. smile.gif __________________

Jul 21, 2009 | 1992 Mazda MPV

2 Answers

Brake Lights do not work and hazard button is stuck


I could not tell you how many times people have brought their cars into my shop and tell me that they had already checked all fues and they are OK, then I check the car and find a blown fuse or a fuse that is completely missing.

Your dash (Instrument Cluster) illumination lights are powered by the "PARK LP" fuse in the underhood fuse panel - it is fuse number 37 and should be a 20 Amp fuse. If this fuse is blown, your Park lights on the exterior of the car will also not be working. If they are working and your dash lights are not, then the problem is probably in your headlamp switch.

Your Brake lights are powered by the "STOP LAMP" fuse in the instrument panel (IP) fuse block it is a 15 Amp fuse.

Your Hazzard lights are powered by the "HAZZARD" fuse in the (IP) also a 15 Ap fuse.

If both of these fuses are good, then the most likely problem with your brake and hazzard lamps is the multifunction (Turn Signal) switch.

What any of the above has to do with replacing your window regulators remains a mystery.

Jul 20, 2009 | 2003 Pontiac Grand Prix

2 Answers

Cut harness from stereo in 1990 corolla dx sedan


did u know that they make a harness for your car that plugs into your factory harness and then adapts to your aftermarket radio? for the lights, you have blown the interior light fuse, it may be the same fuse as the cigar lighter.Below is your radio wire colors and what they do.
1990 Toyota Corolla Car Stereo Radio Wiring Diagram.
Radio Constant 12V+ Wire: Blue/Yellow
Radio Switched 12V+ Wire: Gray
Radio Ground Wire: Brown
Radio Illumination Wire: Green
Radio Dimmer Wire: N/A
Radio Antenna Trigger Wire: N/A
Radio Amp Trigger Wire: N/A
Front Speakers Size: 4′
Front Speakers Location: Dash
Left Front Speaker Wire (+): Pink
Left Front Speaker Wire (-): Purple
Right Front Speaker Wire (+): Purple
Right Front Speaker Wire (-): Light Green
Rear Speakers Size: 4′
Rear Speakers Location: Rear Deck
Left Rear Speaker Wire (+): Black
Left Rear Speaker Wire (-): Yellow
Right Rear Speaker Wire (+): Red
Right Rear Speaker Wire (-): White
-->

Dec 19, 2008 | 1990 Toyota Corolla

Not finding what you are looking for?
1999 Chevrolet Lumina Logo

97 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...