Question about 2004 Mitsubishi Lancer

1 Answer

Clutch fluid location

Cant locate clutch fluid location

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 16 Answers

It should be near the brake master cylinder

Posted on Apr 23, 2013

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 14 Answers

SOURCE: where can i locate to put tansimittion fluid in my 87 might max manuel clutch

first of all it takes clutch fluid or dot 3 brake fluid the resivoir is usually located on driver side under hood on fire wall should be up high & close to brake fluid resvoir it will be round & small after filling pump pedal up& down quickly until you get pressure then have someone else open bleeder valve down on side of bell housing while holding pedal down closing it back & repeat until pedal has good feel if this doesnt work then one or the other is bad the master cylinder or slave cylinder is bad & needs replacing good luck with this info

Posted on Mar 03, 2013

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where can i locate to put tansimittion fluid in my 87 might max manuel clutch


first of all it takes clutch fluid or dot 3 brake fluid the resivoir is usually located on driver side under hood on fire wall should be up high & close to brake fluid resvoir it will be round & small after filling pump pedal up& down quickly until you get pressure then have someone else open bleeder valve down on side of bell housing while holding pedal down closing it back & repeat until pedal has good feel if this doesnt work then one or the other is bad the master cylinder or slave cylinder is bad & needs replacing good luck with this info

Mar 03, 2013 | 1994 Mitsubishi Mighty Max

1 Answer

Where is the clutch auto adjustment located at on a 98 manual Volkswagen jetta?


you most likely have a hydraulic clutch, which the clutch master cylinder is located on the firewall on the driverside close to your drivers side windsheild.it takes brake fluid to fill dot brake fluid will fill it properly. however if your slave cylinder on the transmission is leaking,this will require a replacement of the clutch slave cylinder. look for leakage under passenger side,,just under or below passenger side seat onto ground. recommend if you replace the clutch slave cylinder,you also replace clutch master cylinder located on the drivers side firewall at wind sheild.look under the car while someone pumps the clutch in and out,if you see brake fluid leaking under car onto ground or inside onto carpet at brake pedal,you have a bad clutch master cylinder. recommend you replace both slave cylinder and clutch master cylinder. this will save you lots of time and headaches. thank you for choosing fixya.com

Sep 24, 2011 | 1998 Volkswagen Jetta

3 Answers

5 speed manual...wont go into gear when engine is on...but will go and stay in all gears when i turn off engine??? any help on this?


This may be one of two things, i have just repaired one with the same problem, the first thing may be the clutch slave cylinder, this is what pushes the clutch plate to release it or engege it, if this part is bad it will not disengage the clutch and will not let you shift, the one i just repaired had a bad pressure plate this is a part of the clutch and the clutch needs replacing, the best way to check is to locate the slave cylinder on the trany and watch it as someone presses the clutch pedal to floor the cylinder should push the fork all the way out if it does then the problem is the pressure plate and a clutch replacement is needed, if the fork is not pushed out enough then the problem is in the slave or the master for the slave, here are the parts to help you locte them, as far as the clutch and the plate they are located inside trany housing and cant be seen without pull trany, also make sure the clutch fluid is full, this is located near brake fluid resivor, and it also uses brake fluid,hope this helps.johnjohn2_62.jpgjohnjohn2_63.jpgjohnjohn2_64.jpg

Feb 20, 2011 | 1998 Toyota RAV4

3 Answers

Where do I add clutch fluid to a 1995 volkswagen Jetta glx?


There are two 5 speed manual transmissions possible in your vehicle. One of them is controlled by a cable. (there is no fluid) For the other one, you would put the fluid in the clutch reservoir which would be mounted just above the clutch master cylinder in the engine compartment. The clutch master cylinder is directly in front (on the engine side of the firewall) of the clutch pedal.

NOTE: If you are having to add fluid to a hydraulic clutch, you have a leak in the system that needs to be fixed. You should never have to add fluid to the clutch reservoir.

Jan 16, 2011 | 1995 Volkswagen Jetta

1 Answer

Changed clutch on 1994 honda accord and when pressed down clutch peddle stay in, then also where is clutch oil located?


sounds like you need to blead out the hydraulic clutch fluid. the resivour is located next to the brake fluid resivour drivers side corner. blead through the slave cylinder on the transmission and check for leaks

Oct 29, 2009 | 1994 Honda Accord

2 Answers

CANT FIND WHERE TO PUT CLUTCH FLUIDON 99 FORD ESCORT


It is close to the firewall on the drivers side of the vehicle (most vehicles) it will look almost identical to the brake master cylender just a much smaller scale. Add your fluid their.

Jun 20, 2009 | 1999 Ford Escort

1 Answer

Help..where to put clutch fluid in 01 tt


Your hydrolic clutch fluid resivor is usualy located next to your master cyllender, where you put your brake fluid in. It is usualy a small round plastic container with a screw cap on it located near the master.
Good luck

Dec 16, 2008 | 2001 Audi TT

1 Answer

My clutch cable just went on my daewoo nubira 98


Hi there, I would be checking the fluid in the clutch master cylinder first, It should have a small yellow lid on it make sure it is full it might only be a hydraulic issue rather than a clutch plate. If it has no fluid in there check the slave cylinder for leaks that is located on the end of the clutch fork on the gearbox. Hopefully thats the problem and it wont cost alot.Good luck.

Jul 08, 2008 | 1999 Daewoo Nubira

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

100 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...