An expert who has achieved level 3 by getting 1000 points
An expert that got 10 achievements.
An expert that got 5 achievements.
An expert that has over 10,000 points.
Re: im getttting no power 2my a/c unit
Try autozone.com to see if they have your car listed for diagrams pictures and step by step instructions if your car is not listed then try your local library they have all the car manuals and even copy them for you
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
To start with you need to diagnose what the cause of the vehicle not runing is. It takes to things to make a car start, fuel and spark. Find out which one of those things are missing like are you not getttting fuel and if not do you have power to the fuel pump if you are then most likely it is the fuel pump but seems this is not in your case. Find out if you are getttting spark to your spark plugs. If not then you need to diagnose that to find out the cause of not getttting any spark. At this point this is all I can help you with until you can narrow down where the loss is. I hope I was able to help a litle in any case.
All these components operate via the central locking control unit. Check fuses No.4, 37, 6, 3, 14. If these fuses are ok, the control unit may be faulty and need to be replaced. The control unit is located behind the right dash panel.[on right hand drive vehicle , may be else where on left hand drive vehicle.
The interior map lamps are powered buy the battery saver relay ( non serviceable relay ) Which is powered by Fuse #25 ( cab fuse panel ). This is for the engine compartment and illuminated vanity lamps, as well as the map lights.
The FET ( Field-Effect Transistor ) shows the fuse #9 also on it. ( marked interior lighting ), which power the interior lamps ( door / switch ).
Could be a few things if both those fuses are OK.
1. The map / interior lamp combos are usually dual element bulbs, which means if the interior lamps ( door or dimer switch on headlamp panel ) are OK, it could still be a burn out bulb.
2. The FET is having an issue from a dead short ( blown bulb or dead short to ground ). Until the short is correct, the FET will not turn back on.
Start with checking Fuse #9 ( marked as Fuse #8 in the diagram, but that shows headlamp ), which is to the interior lamps, and drives 1 side of the FET.
have u check the bulbs?.... i would try to see if they ok remove em an check for power going to those locations, activate ur switches an see if you get any power may just be burned bulbs..... if the fuses seem to be OK