Question about Volvo Cars & Trucks

Open Question

How to remove quick release fuel filter clips on volvo v70

Volvo v70 2000

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 169 Answers

SOURCE: Ford E-450 fuel filter removal

YOU NEED T INSERT THE SPECIAL TOOL WICH RELEASES THE RETAINER INSIDE THE BULGED OUT PART OF THE LINE. TRY NAPA FOR TOOL NO. Part: SER 3290 Product Line: NAPA Service Tools WATCH OUT FOR FUEL THAT MAY SPRAY OUT WHILE DISCONNECTING! GOOD LUCK

Posted on Aug 26, 2008

  • 1 Answer

SOURCE: 2004 Volvo S40 Battery Removal

i had same problem trying to remove a battery on a s40 1998 volvo sorted it in the end, the clip just pulls off, pull clip forwards and upwards and it will come off do not try to slide left or right

Posted on Dec 21, 2008

  • 74 Answers

SOURCE: how do you remove fuel filter clips

The clips will be one of two varieties, which may depend on if you have a V6 or V8. Here's both solutions:

On one type, you should be able to just squeeze the clip with your fingers with firm pressure. If this doesn't work, then you my have to use channel locks or pliers to squeeze the clip. The fuel line will be held in by an O-ring more than likely, and it'll be a little tough to pull apart.

On the other type, you have to use quick disconnect tools. You can find them at any auto parts store. There's different kinds, the cheapest being a pack of different colored plastic ones. They're really cheap, maybe a few bucks.

The colored plastic will designate the size of the fuel line clips. Usually they come in packs of four...blue, red, white, etc.

Just insert these with the flange facing the clip, slide it in, and you'll feel it unlock. Pull apart the fuel line from the filter.

NOTE: Make sure you release the fuel pressure. And make sure you have rags as well as a container to catch the gas. If it's under pressure, it WILL spray you with gas, so be sure to release the pressure using the schrader valve on the fuel rail that feeds your injectors.

The fuel filter will probaby be a little stiff getting off since the O-ring will be old. Just make sure you wrap the line in a rag and avoid getting sprayed. Eye protection is recommended.

Posted on Feb 10, 2009

ftw1952
  • 10319 Answers

SOURCE: how to remove original fuel filter from 96 pontiac grand am

If this is the factory original I would use penetrating oil on it first on the threaded areas and let set for a few days. Other wise you may bend the lines up bad which will cost even more to replace

Posted on May 24, 2009

tepfy
  • 319 Answers

SOURCE: I need to replace my headlight bulb...

you have to look arund and find them. They could be bolts and they could be clips like on a air filter. They could even be some sort of pins.

Posted on Jun 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to remove transmission lines on a volvo 2.5t?


There are little clips that you squeeze in towards the line and that releases them. Squeeze the clips, then pull the line straight out of the radiator. Very simple. When you've done it, you'll go "aaahhh, that's neat!". :D

To reinsert the line, squeeze the little clips again and push the line back in and then gently give it a tug to ensure it latched properly.

Aug 18, 2014 | 2005 Volvo S60

1 Answer

Fuel filter location 08' volvo v50 1.8 petrol?


Removal & Installation

Print

NOTE The fuel filter is either on the left side of the firewall or next to the fuel pump near the left side of the fuel tank.

  1. Before servicing the vehicle, refer to the Precautions section.
  2. Relieve the fuel system pressure.
  3. Remove or disconnect the following:

    Negative battery cable Fuel filler cap Fuel lines from the fuel filter Fuel filter from the bracket

To install:
  1. Install or connect the following:

    Fuel filter to the bracket Fuel lines to the fuel filter Fuel filler cap Negative battery cable
  2. Start the engine and check for leaks.


  3. 0900c152801c13b0.jpg enlarge_icon.gifenlarge_tooltip.gif

    Fig. Using an open end wrench to push the quick disconnect coupler sleeves back-5-cylinder models
    Using an open end wrench to push the quick disconnect coupler sleeves back-5-cylinder models



NOTE The fuel filter is either on the left side of the firewall or next to the fuel pump near the left side of the fuel tank.
  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2. Relieve the fuel system pressure.
  3. Remove or disconnect the following:

    Negative battery cable Fuel filler cap Fuel lines from the fuel filter Fuel filter from the bracket

To install:
  1. Install or connect the following:

    Fuel filter to the bracket Fuel lines to the fuel filter Fuel filler cap Negative battery cable
  2. Start the engine and check for leaks.

    0900c152801c13b0.jpg enlarge_icon.gifenlarge_tooltip.gif

    Fig. Using an open end wrench to push the quick disconnect coupler sleeves back-5 cylinder models
    Using an open end wrench to push the quick disconnect coupler sleeves back-5 cylinder models



NOTE The fuel filter is either on the left side of the firewall or next to the fuel pump near the left side of the fuel tank.
  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Relieve the fuel system pressure.
  3. Remove or disconnect the following:

    Negative battery cable Fuel filler cap Fuel lines from the fuel filter Fuel filter from the bracket

To install:
  1. Install or connect the following:

    Fuel filter to the bracket Fuel lines to the fuel filter Fuel filler cap Negative battery cable
  2. Start the engine and check for leaks.

    0900c152801c13b0.jpg enlarge_icon.gifenlarge_tooltip.gif

    Fig. Using an open end wrench to push the quick disconnect coupler sleeves back-5-cylinder models
    Using an open end wrench to push the quick disconnect coupler sleeves back-5-cylinder models


On these models, the fuel filter is part of the fuel pump assembly. Refer to Fuel Pump removal and installation.

May 12, 2012 | 2005 Volvo V50

2 Answers

I need picture of a 2001 chevrolet calvalier fuel filter and where its located on car engine... thanks


Look in between the rear axle and the gas tank right above the charcoal canister. Use a 16mm and a 20mm wrench on the threaded side and a 5/16"quick release tool on the other side. Sometimes the quick release side will have a black plastic piece that can be pushed into the fitting to release it from the fuel filter. Sometimes it is a blue or green clip that needs to be released to remove the line from the filter.

It is a lot easier to move the charcoal canister out of the way to replace the filter.

Jan 23, 2011 | Chevrolet Cavalier Cars & Trucks

1 Answer

I need to replace a fuel filter on a 2001 s40 volvo. how do i do that?


ON EACH END OF THE FUEL FILTER THERE SHOULD BE A LOCKING CLIP RELEASE THE LOCKING CLIPS AND YOU MIGHT HAVE TO TRY AND TURN THE FILTER TO RELEASE IT FROM THE FUEL LINE, BUT IF YOU PULL AND TURN AT THE SAME TIME THE FILTER WILL COME OFF

Jan 11, 2011 | 2001 Volvo V40

1 Answer

Cannot get the fuel filter off the quick disconnect is not releasing


Most of the time that the disconnects are not working is because of dirt and grime build up. Most of the fuel filters take a line disconnect tool to release the clips. If your filter has plastic clips that you can see at the connection, you should be able to pinch the clips together while moving the line back and forth or twisting back and forth to disconnect the tabs. If this is not working, used compressed air to blow out all the debris from the quick disconnect. Other filter take the fuel line disconnect tools. Dirt and grime give the tools grief in getting the lines disconnected too. Clean the lines before attempting removal and you can save yourself a lot of grief. Hope this helps.

Dec 29, 2010 | Ford Explorer Cars & Trucks

1 Answer

Need to find location of fuel filter for 2002 Ford Explorer 4D, 4WD, 4.61 litre V8, XLT


Instructions Things You'll Need:
  • Quick release tool (Avail from most Napa auto parts stores)
  • Eye protection
  1. Step 1 Ensure your vehicle has had time to cool down since the last time it was driven. The engine block should be cool to the touch.
  2. Step 2 Remove the gas cap from your Ford Explorer and locate the Schrader valve attached to the vehicle's fuel line.
  3. Step 3 Don eye protection and depress the Schrader valve until no more gas and air comes out.
  4. Step 4 Locate the fuel filter. Your fuel filter will be located underneath the edge of the vehicle on the driver's side. There may be a plastic cover covering the filter. If so, unbolt it and remove it.
  5. Step 5 Take the safety clips off of the ends of the filter. Then, use a "quick release" tool to remove the fuel lines that are attached to the filter.
  6. Step 6 Connect your new filter to the fuel lines using the quick release tool to clamp the lines to each end of the filter.
  7. Step 7 Reinstall the safety clips on the new fuel filter by clamping them on each end of the filter.
  8. Step 8 Start your Ford Explorer and run at idle for five minutes. Visually verify underneath the body of the vehicle that there are no leaks from the fuel filter

Jul 28, 2010 | Ford Explorer Cars & Trucks

1 Answer

I have a 1995 Ford E-350 with a 5.8L engine.i am trying to replace the inline fuel filter. Your answer earlier about "plastic clips" is incorrect. Mine has steel spring clips that snap over the crimped on...


You will need a fuel line quick connect removal tool to release the inner clips holding the line in the filter.when you purchase the tool make sure you get the correct size for the line.

Jun 26, 2010 | Cars & Trucks

1 Answer

How to replace the oil filter on 1999 sunfire , the oil filter is surrouded by many things and we can not get to it. Is there a easier way?


Normal 0 false false false MicrosoftInternetExplorer4 /* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-parent:""; mso-padding-alt:0cm 5.4pt 0cm 5.4pt; mso-para-margin:0cm; mso-para-margin-bottom:.0001pt; mso-pagination:widow-orphan; font-size:10.0pt; font-family:"Times New Roman"; mso-ansi-language:#0400; mso-fareast-language:#0400; mso-bidi-language:#0400;}
  1. Place one wheel chock in front of each of the Sunfire's front tires. Lift the rear of the Sunfire with a floor jack. Then support the weight of the vehicle with one jack stand placed under each rear axle.
  2. Locate the fuel filter. The fuel filter is a metal cylindrical piece located underneath the Sunfire on the passenger's side of the fuel tank.
  3. Note that one end of the fuel filter has a nut, while the other end has a clip. Use a wrench to remove the portion of the fuel line which enters the side of the fuel filter which has the nut.
  4. Allow any fuel which is present in the line to drain into a bucket. Use a tool for quick connect fittings to release the clip on the opposite side of the fuel filter. The quick connect fitting tool is readily available at most auto parts stores, and can sometimes be rented instead of purchased. Once the fitting is released, pull the fuel line away from the filter.
  5. Press the end of the new fuel filter that has the clip onto the fuel line until the line clicks into place. Then use a wrench to tighten the end of the other fuel line to the fuel filter.
  6. Raise the back of the Sunfire with the floor jack. Remove the jack stands from underneath the axles. Then lower the Sunfire with the floor jack and remove the wheel chocks to complete the installation.

Jan 24, 2010 | 1999 Pontiac Sunfire

2 Answers

How do i change a fuel filter on a 2001 f150


The clamps are just a secondary lock, special tools are needed to unlock the fuel lines.

Nov 05, 2009 | 2001 Ford F150 Styleside SuperCrew

1 Answer

Replacing a fuel pump on 93 f150


there is a special tool to remove the fuel filter---if it close to the gas tank--remove the 2 nuts that hold the fuel filter bracket to get more room--any auto parts store should have the tool--install around fuel line & push towards filter & that unlocks the spring clip on the filter so you could remove the filter

Jun 25, 2008 | 1993 Ford F150 SuperCab

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

248 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volvo Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...