Question about 1999 Nissan Frontier

1 Answer

Neutral safety switch location

Its a stick shift 4x4 3.3l. It says on the part box switch interruptor. part number JA4341

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Nissan Master
  • 1,209 Answers

Should be under the dash attached to the clutch pedal.

Posted on Apr 23, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

j_del
  • 1586 Answers

SOURCE: where is the neutral safety

On both Nissans I've owned (90 Sentra and 90 300ZX) the neutral safety switch was on the side of the transmission. If you look down there, you'll see wire connectors (probably 3 of them) going to connections near or on the transmission - one of those should lead you to the neutral safety switch.

Posted on Jul 21, 2008

  • 2 Answers

SOURCE: Need to replace nuetral safety switch on a 1991 Buick Park Avenue

It is located on the transmission follow the gear shift cable to the end on my 1996 nissan sentra it is located on the front righthand side if your looking at the engine (below the battery) it has 3 (10mm) screws to remove and it slips out of the gear shift cable.

Posted on Dec 10, 2008

motor1258
  • 6674 Answers

SOURCE: 1995 nissan altima

Check this link.

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c15280078b09

Posted on Jan 02, 2009

  • 157 Answers

SOURCE: where is neutral safety switch located?

Hi there,

The switch appears to be attached to the trans axle near where the linkage attaches. If you have someone move the shifter while you look under the hood you should be able to see it.

Hope this helps...

Posted on Jan 24, 2011

  • 5370 Answers

SOURCE: where is the neutral safety

It is on the clutch pedal. Meaning the clutch must be depressed in order to start the vehicle, since this effectively ensures the vehicle is in neutral.

-----------
This should help.Thanks.Helpmech.

Posted on Jul 01, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you replace the neutral safety switch on a 1991 ford f150 six cylinder lariat


The neutral safety switch is located on the transmission shift lever. Its held onto the transmission case by 2 bolts in slotted holes. You will need to remove the kickdown lever. The switch will slip off the shift lever with just a little pry if dirty. Replace the switch while the transmission is in neutral. There is a small hole in the side of the switch to stick a small pin or awl into to locate the neutral position of the switch. I would try to adjust the old switch before replacing it.

Feb 25, 2015 | Ford Cars & Trucks

1 Answer

How is the nuetral safety switch on a Hyundia Santa fe 06? I believe if I'm facing the car its accessible on the left side. I removed the skid plate but can't locate it.


First we need to make sure that its the neutral safety switch how did you come about that conclusion? Try this next time it will not start shift the gear into neutral and try to start it again if it starts every time you shift to neutral I would say yes start with your neutral safety switch. Your neutral safety switch is incorporated with your transmission range sensor located on the transmission follow the transmission linkage to the transmission there you should find the neutral safety switch usually black in color made of plastic with a wire harness connected to it you could get someone to shift it for you while you look to make sure you are looking at the right part.

May 26, 2014 | Hyundai Santa Fe Cars & Trucks

1 Answer

2008 BMW 528 neutral safety switch location


on steering column if column shift or floor shift might be there

Jan 11, 2014 | 2008 BMW 528i

2 Answers

Where is the neutral saftey switch on an 2004 chevy cavalier


It should start in neutral position. Neutral safety switch is usually located under the shift console by the shift lever.

Mar 27, 2013 | 2004 Chevrolet Cavalier

1 Answer

Netural safety switch


Daewoo cars have track record for dependability in addition to solid construction. The most important part of a car's design is the safety features. Circumvent excessive risk while motoring by insuring that your car has the safety gear that you want. A vehicle's Neutral Safety Switch is located on your clutch in the case that it's a manual transmission, and on the shifter in an automatic. A broken Neutral Safety Switch can cause your vehicle to suddenly start in gear, causing vehicle damage or personal injury.

If you don't have the Neutral Safety Switch, your vehicle will fail to work. The Neutral Safety Switch is typically situated below the clutch of trucks which have a stick-shift transmission. The primary function of a Neutral Safety Switch is to stop your truck from starting when in gear. The car's Neutral Safety Switch acts as a safety feature, keeping you from starting the engine if the car is in gear. The Neutral Safety Switch is an electronic part which is essential while starting your car.Here's a link to what it look's like.

Mar 22, 2013 | 2000 Daewoo Lanos

1 Answer

2001 CHEVY BLAZER starts but not able to shift out of PARK. if i start in NEUTRAL it is able to shift, WHY IS THIS?


Check the park neutral safety switch. It is a black box located on the side of the transmission. You will want to heat up the switch where the electrical connectors go in with a heat gun, or you will break the switch or connectors.

Feb 13, 2013 | 2001 Chevrolet Blazer

2 Answers

How to replace neutral saftey switch on a 1980 cadillac deville?


Use like reference guide for GM Cadillac 1967-1989 Repair Guide Neutral Safety Switch - REMOVAL & INSTALLATION

All Except 1985-89 Eldorado and Seville
See Figure 1
The neutral safety switch prevents the engine from being started in any transmission position except Neutral or Park. The switch is located on the upper side of the steering column under the instrument panel on column shift cars, and inside the shift console on floor shift models.
  1. Remove the console for access on floor shift models.
  2. Disconnect the electrical connectors.
  3. Remove the neutral switch.

To install:
  1. Place 1967-70 column shift lever models in Drive, and 1971 and later models in neutral. Locate the lever tang against the transmission selector plate on column shift models.
  2. Align the slot in the contact support with the hole in the switch. Insert a 3 / 32 in. (2.38mm) diameter pin in place. The switch is now aligned in Drive position.

1973 and later neutral safety switches have a shear-pin installed to aid in proper switch alignment so that insertion of a pin is unnecessary. Moving the shift lever from Neutral shears the pin.
  1. Place the contact support drive slot over the drive tang. Install the switch mounting screws.
  2. Remove the aligning pin. Connect the electrical wiring, and replace the console.
  3. Set the parking brake and hold your foot on the service brake pedal. Check to see that the engine will start only in Park or Neutral.
7b3f2a9.jpg

Fig. 1: Installation of a common neutral safety switch



ADJUSTMENT
See Figure 2
1974 and later cars do not have a neutral safety switch. Instead, these cars have an interlock between the lock and the transmission selector, which is non-adjustable.
  1. Place the shift lever in Neutral.
  2. Move the switch until you can insert a gauge pin, 3 / 32 in. (2.38mm) diameter, into the hole in the switch and through to the alignment hole.
  3. Loosen the switch securing screws. Remove the console first, if necessary.
  4. Tighten the screws and remove the pin.
  5. Step on the brake pedal and check to see that the engine will only start in Neutral or Park.
05843d3.jpg


Fig. 2: Adjustment of a common neutral safety switch


1985-89 Eldorado and Seville
See Figure 3

All neutral safety/back-up light switches come with a small plastic alignment pin installed. Leave this pin in place.
  1. Place the shifter assembly in the Neutral position.
  2. Remove the shifter lever-to-switch nut and the lever.
  3. Disconnect the electrical connector from the neutral safety/back-up light switch.
  4. Remove the neutral safety/back-up light switch-to-transaxle bolts and the switch from the vehicle.

To install:
  1. Position the shifter shaft in the Neutral position.

If using an old switch or the plastic pin (new switch) is broken, install a3/32in. (2.38mm) diameter pin gauge (drill bit) into the neutral safety/back-up light switch; the switch is then locked into its Neutral position.
  1. Align the flats of the shifter shaft and the neutral safety/back-up light, then, align the switch-to-tang on the transaxle. Torque the switch-to-transaxle bolts to 22 ft. lbs. (30 Nm). Remove the pin gauge.
  2. To complete installation, reverse the removal procedures. Make sure that the engine starts only in the Park and Neutral positions.
c796664.jpg

Fig. 3: Neutral start and back-up lamp switch - 1985-89 Eldorado and Seville

Hope help with this (remember rated and comment this). Good luck.

Mar 21, 2010 | 1980 Cadillac Deville

2 Answers

My 1997 monte carlo wont start


Most likely a bad starter.
Less likely a wiring problem.

Apr 26, 2009 | 1997 Chevrolet Monte Carlo

2 Answers

Where is the neutral safety switch location/located


On top of the transmission, right under the shift linkage. Look down under the brake master cylinder.

Mar 13, 2009 | 1997 Ford Taurus

1 Answer

1995 pontiac grand prix se neutral safley switch


this is part of the gear position switch on top of the trans where the shift linkage connects, it is mounted over the selector post that sticks out of the trans. Here is a picture.
300? 300: true ); MAX-HEIGHT: 400px; ; HEIGHT: expression(this.height > 400? 400: true )" src="http://info.rockauto.com/getimage/getimage.php?imagekey=96388&imageurl=http%3A//info.rockauto.com/ACDelco/12450003.jpg" />

Feb 13, 2009 | 1995 Pontiac Grand Prix

Not finding what you are looking for?
1999 Nissan Frontier Logo

138 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...