Question about Mitsubishi Carisma

Open Question

Mitsubishi central door locking

Door central locking goes nutts

Posted by Anonymous on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Suzman
  • 642 Answers

SOURCE: My Mitsubishi colt CZ1 (07

Central locking works by way of little electric motors that engages and disengages the door lock. The drivers door has an additional set of contacts in the actuator which signal the controller when it changes position. The controller activates the servo motors when a signal is received from the receiver or from the drivers door servo motor. So in your case I suspect the motor part of the drivers door actuator is done for.
To replace you will have to remove the inner driver's door panel to get at the actuator. The actuator itself cannot be repaired and needs to be replaced as a unit.

Posted on Apr 29, 2011

Testimonial: "Very helpful answer and a prompt response. Thanks"

  • 219 Answers

SOURCE: drivers door and fuel cap

Hello Alan,

I would suspect the fuel flap actuator has failed. Open the trunk. In the right rear corner is the access cover. Open it and you'll see some insulation matting near the top. Behind it is a fuse/relay carrier, I believe either fuse 55 or 56 is blown. If so the fuel flap actuator needs replaced. The fuse also controls the central locking system.

Posted on May 05, 2011

afarri
  • 1386 Answers

SOURCE: The passenger door on

Hello and welcome to FixYa!

As a first course of action, I strongly suggest that you replace the door lock actuator. It's the motor that locks and unlocks the door mechanism. Once replaced you'll be good.

Hope this helps and thank you for using Fixya! Have a good one!

Posted on Jul 21, 2011

  • 5280 Answers

SOURCE: central locking goes on and off whilst driving

Check your master switch on the door panel. If all doors are doing it, the master lock swith is suspect. Don't know if your car has a body control module, or if it has anything to do with the locks. good luck.

Posted on Oct 27, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is fuse box on mitsubishi colt mirage 2005 model i want door lock fuses change


Power Distribution Center *PDC* Located under hood in upper driver corner, fuse box and relay box. There might be a fuse box by the battery also,

recomend disconnect negative to battery, so accidently dont short any thing out.

Mar 08, 2017 | Mitsubishi Colt Cars & Trucks

1 Answer

How to troubleshoot central locking.


Wondering if the door lock mechanisms needs greasing
like some form of resistance to movement may put the power locking out of kilter ..

May 15, 2016 | Mitsubishi Lancer Cars & Trucks

1 Answer

Dear Sir, I have a double cab pick up 2.8TDI, the central lockink works independant. On press the driver door unlocks, second press the other doors unlock. Locking is in normal, on press all doors lock....


there is a central locking switch in the drivers door lock over time it will get mucky and or warn from use and weather. its built into the lock but you can clean it out by taking off the door card and spraying some cleaner in like wd40 or deep penetrating oil into the switch.

Mar 06, 2014 | Mitsubishi Cars & Trucks

1 Answer

Central locking


remove door panel and check linkages

Aug 13, 2017 | Cars & Trucks

1 Answer

Central locking


doors should open/ lock. with remote both.

Jan 12, 2014 | 1992 Mitsubishi Mirage

1 Answer

The passenger door on Mitsubishi Colt 2007 won't lock using central locking


Hello and welcome to FixYa!

As a first course of action, I strongly suggest that you replace the door lock actuator. It's the motor that locks and unlocks the door mechanism. Once replaced you'll be good.

Hope this helps and thank you for using Fixya! Have a good one!

Jul 21, 2011 | Mitsubishi Colt Cars & Trucks

2 Answers

My Mitsubishi colt CZ1 (07 plate) has problem with cental locking. I can manually central lock but with the remote it locks/unlocks all the doors except the driver's door. Please help. Thanks


Central locking works by way of little electric motors that engages and disengages the door lock. The drivers door has an additional set of contacts in the actuator which signal the controller when it changes position. The controller activates the servo motors when a signal is received from the receiver or from the drivers door servo motor. So in your case I suspect the motor part of the drivers door actuator is done for.
To replace you will have to remove the inner driver's door panel to get at the actuator. The actuator itself cannot be repaired and needs to be replaced as a unit.

Apr 29, 2011 | 2006 Mitsubishi Colt

1 Answer

Doors automatically lock sometimes while in motion other times after the engine has been shut off. Using the remote to unlock the doors results in the doors unlocking them immediately relocking.


it depend upon the program of the alarm system.the mitsubishi alarm system is programble or u can check the alarm system control under the steering column and check the central lock controller,the main actuator on the front driver side door

Feb 19, 2011 | 2005 Mitsubishi Galant

1 Answer

Rear door hatch won't unlock at all the remote unlocks all doors except the hatch. Once in awhile it might open


some cars are fitted with a valet key/lock 3 keys supplied new 2 normal 1 with a flute running down the middle.key with flute will not unlock the tailgate/glove box.tailgate has 2 positions key upright=locks with central locking.key turned to the left,(or right,cant remember which)then released to upright,locked,needs key to access.independant of central locking.

Jun 24, 2010 | 2004 Mitsubishi Endeavor

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...