Question about Cars & Trucks
Engine wont rev above 3000 revs / min
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Inadequate fuel pressure, change the fuel filter first, make sure the car sits for at least two hours before replacing the fuel filter because these fuel lines are under high pressure during the time of operation. The pressure usually decreases over time in the lines but wear safety glasses just the same, I would recomend depressurizing the fuel system first, buy a Haynes repair manual for detailed procedure to be safe. If problem persists go to Auto Zone and ask them to check for trouble codes these codes if present may instuct you in detail to replace the MAF sensor or give you a code that must be looked up to find the problem.
Posted on Jul 22, 2009
well the problem mostly is from
so try to clean it or change it other wise check the fuel filter and fuel pressure regulator
Posted on Aug 10, 2009
Have you inspected the catalytic converter for blockage? The other issue could be fuel pressure...the fuel regulator could be defective. Hope this helps.
Posted on Jun 12, 2012
Tips for a great answer:
Nov 01, 2016 | Nissan Cars & Trucks
Sep 27, 2016 | 2007 Hyundai Santa Fe
Dec 15, 2015 | Jaguar Cars & Trucks
Oct 22, 2015 | Nissan Cars & Trucks
Engine stall or RPM fluctuates
This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control
Sep 11, 2012 | Mazda Cars & Trucks
Jul 27, 2012 | 1995 Nissan Pickup
Jul 22, 2009 | 1997 Nissan Pathfinder
72 people viewed this question
Usually answered in minutes!