Question about Cars & Trucks

Open Question

How do you remove the light dome of my guardian 21230 without breaking it

Posted by Anonymous on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
philschneide
  • 448 Answers

SOURCE: The interior dome light is burned out, removing cover problem.

You will have to pry off the lens CAREFULLY using a small screwdriver. There are two little plastic protrusions on each long side of the lens which fit into the casement. You can ease the casement away from the lens enough to get it to pop out. Re-inserting it is the same, but probably easier.
Gently, give it a try.
Hope this helps you.

Posted on Oct 23, 2009

Ad
emissionwiz
  • 76848 Answers

SOURCE: antilock break light stays on

you have a defective doom light switch, when u brake the body of the car flexes and that is just enough to turn on the switch, have the dealer scan the car to isolate the bad switch.

Posted on Jun 10, 2009

  • 2841 Answers

SOURCE: the bulb of my remote

Install a 60 watt 120 volt rough service bulb. This is listed under the troubleshooting section on page 5-18 number 19 Defective Light Bulb. If the new bulb does not work unplug the opener from the outlet on the ceiling and then reconnect it. If the known good bulb still does not work the logic board is defective. Here is the manual. http://www.perthwindsordoors.com.au/pdf/Guardian_manual.pdf

Posted on Dec 12, 2010

  • 5371 Answers

SOURCE: how to safely remove lense cover from dome light

Just try a little pressure squeezing it inward form the ends with your fingers, or from the sides. There should be little clips or tangs on the underside of lens.

Posted on Nov 16, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Which fuse do I pull that goes to the dome lights


Typically, the dome light fuse runs other items as well. If you wish to kill the dome light without stopping other things as well, it would be better to just remove the bulb. You don't say what you are working on, but most dome light covers come off pretty easily by squeezing the plastic and popping them loose.

Dec 18, 2014 | Cars & Trucks

1 Answer

Dome lights will not turn off


There are a few possibilities. First, the Dome light usually has 3 settings on its own switch located in the Dome light case.
One position is full OFF, another position is by Door opening, and the final position is FULL ON.
If these settings do not help, then you must have a bad doorjam switch or a grounded wire. When the door switch is pushed in by the closing of the door, the plunger in the stem of the door switch is suppose to separate the wires.
If the switch is cracked within the door frame opening, the wires may not separate and break the connection. You would need to remove the doorjam switch and BEFORE you removed the wires tape something to the wires to prevent losing the wiring loom in the frame of the body.
Another potential reason for the Dome light staying ON is the headlight switch. Turning the light switch beyond the full dash brightness limit will MANUALLY turn on the Dome light. Check to see if the light switch is turned too far.

May 23, 2013 | Ford Econoline Cars & Trucks

1 Answer

How to safely remove lense cover from dome light


Just try a little pressure squeezing it inward form the ends with your fingers, or from the sides. There should be little clips or tangs on the underside of lens.

Nov 16, 2011 | Cars & Trucks

1 Answer

Replacig a light bulb for a dome in 2001 dodgegrandcaravan


Remove the screw holding the dome light cover in place by turning it counterclockwise with a screwdriver....Remove the old bulb by twisting it slightly to the left and pulling it straight out. Dome light bulbs can be fragile, so be careful not to break the bulb with your fingers...Slip the replacement bulb back into place by pushing it in and twisting it slightly to the right...Replace the cover. I hope this helps, thank you for using FixYa!

Jul 02, 2011 | 2001 Dodge Grand Caravan

1 Answer

How to remove the dome or map light on a 2001 lincoln ls


It snaps in place
There will be two places on each side, you need to push on,while pulling down. It is called an overhead console
Your best bet,is to fabricate a plastic tool,like a plastic putty knife, to use .
Every thing on the LS seems to snap together The challange is to figure it out,without breaking something

May 08, 2010 | 2001 Lincoln LS

1 Answer

The interior dome light is burned out, removing cover problem.


You will have to pry off the lens CAREFULLY using a small screwdriver. There are two little plastic protrusions on each long side of the lens which fit into the casement. You can ease the casement away from the lens enough to get it to pop out. Re-inserting it is the same, but probably easier.
Gently, give it a try.
Hope this helps you.

Oct 23, 2009 | 1994 Honda Accord

1 Answer

Antilock break light stays on


you have a defective doom light switch, when u brake the body of the car flexes and that is just enough to turn on the switch, have the dealer scan the car to isolate the bad switch.

Jun 10, 2009 | 1995 Mitsubishi Diamante

1 Answer

My passenger door has no power,my security light is on constantly


Have lost power to the passenger side door. Without power system doesnt recognize door closed because of no power to door ajar switch which keeps dome light on. Security light stays on because without power to rest of systems supplied by fuse it cannot tell if doors and windows closed to engage security features. Most common is for power wire to break somewhere near where it leaves to main body and enters the door.

Apr 25, 2009 | 2003 Pontiac Bonneville

1 Answer

Dome lighting issue


Try replacing the bulb it really is east. Gently pry off dome so as to not break it and with all doors closed you should be able to remove bulb and replace it. The dealership will do this for about 150 US Good Luck

Dec 07, 2008 | 2001 Audi A4

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

216 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...