Question about Toyota Cars & Trucks

1 Answer

Engine overheats 1994 Toyota Pickup/3.0 VZE 3 liter------------ We replaced the radiator with a new one because it leaked. -We then discouvered that Water does not pump from radiator to the Engine (no circulations) . So we took the new radiator out to check the thermostat and water pump. The engine was full of antifreeze while the radiate had new, clean water in it which confirmed our notion that the water was not circulating. We found that boh the thermostat and water pump were in good working condition. We are stumped! Any answers?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Toyota Master
  • 5,280 Answers

There's got to be something up or wrong with the pump-that's the sole source of circulation for the entire cooling system. Did you pull it off to check it? Sometimes the impeller can shear off. Or did the blades show any signs of wear? Check the belt running it too for any problem.

Posted on Apr 22, 2013

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 603 Answers

SOURCE: circulation speed is slow and the engine overheats

How about the water pump!

Posted on Jan 14, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Where is crank position sensor on a 1994 toyota 2.2liter 4cyl ?


Where is the crank position sensor on a 95 Toyota celica gt 2.2

search.aibing.cc/Where+is+the+crank+position+sensor+on+a+95+Toyota...
P1335, No Crankshaft Position Sensor Signal - Engine Running. ... 91 1991 ToyotaCelica GTS Engine Mount Right 2.2L 4 Cyl Genuine. ... 1990, 1991, 1992, 1993, 1994, 1995, 1996, 1997, 1998, 1999, 2000, 2001 . ... Powered by a 2.2-liter engine, the Celica now had ST and GT trim models. ... in 1986 and a 2.0-liter ...

Where is crank position sensor on a 1994 toyota 2.2liter 4cyl ...

www.fixya.com/cars/t26080657-crank_position_sensor_1994_toyota
31 mins ago - It is not behind pully nor in dist all videos show - Toyota Cars & Trucks question. ... Change a crankshaft position sensor on a 2000 eclipse.

toyota camry crankshaft sensor - ABMforum.com

abmforum.com/toyota-camry-crankshaft-sensor.html
toyota camry crankshaft sensor 99 camry crankshaftcamshaft position codes i got a problem with my 97 ... The car 96 toyota camry 2.2 liter 4 cyl. ... 1994 toyota camry 2.2L 257k miles Symptoms Car overheats Top radiator hose hot bottom cold ...

Toyota Camry 5SFE Engine Timing Belt, Water Pump and ...

hubpages.com > Autos > Do It Yourself Auto Repair
Jul 10, 2014 - The Toyota 5SFE motor is a four-cylinder, 2.2 liter, timing-belt-driven, double ..... Remove the lower timing belt cover with the crankshaft position sensor. ..... I've never, ever replaced the harmonic balancer on a 4cyl 5SFE.

1995 Toyota Camry LE 4 cylinder - YouTube

? 2:27
https://www.youtube.com/watch?v=7TW6hlUiHWQ
Sep 6, 2011 - Uploaded by jacasan2000

Feb 03, 2016 | Toyota Cars & Trucks

1 Answer

1994 toyota pickup 4x4 sr5 v6 overheats after changing coolant


Sounds like your water pump may be not working, while vehicle is off try squeezing both upper and lower radiator hose you should be able to feel the fluid in the lines and the hose should feel firm and not squish all the way together. Make sure you used the right coolant orange vs green and mix ratio. after all this has been confirmed start vehicle and squeeze hoses again before they get to hot to make sure the fluid is moving and now hoses should be pretty hard to squeeze at all while the truck is running. if you don't feel movement of fluids or hoses are very squishy it could be a vacuum leak and worst case your water pump, hope this helps-

Nov 29, 2013 | Toyota Pickup Cars & Trucks

1 Answer

Car overheating when radiater full water


Have a coolant pressure test done looking for a head gasket problem. as well as the fan

May 18, 2013 | Toyota Cars & Trucks

2 Answers

How to adjust valves on 94 toyota pu 2.4 liter


Link to a factory manual here:
http://myweb.dal.ca/is353832/93fsm/maintenance/2maint.pdf

You might as well inspect/replace the PCV valve while you're there.

Jul 24, 2010 | 1994 Toyota Pickup

1 Answer

Hey there, I have replaced the thermostat on my 1994 Camry LE 3.0 liter, however it still overheats at about 20 miles of city traffic & I must use the heater. I made sure the thermostat opened, checked...


An engine can overheat due to 2 causes:
1 - the water flow is too small - due to either a failing water pump (replace it) or a clogged radiator (run a radiator cleaning solution).
2 - the fan isn't working as it should (or not at all) - in your case probably not at all since its sensor seems to be not connected.

Jun 05, 2010 | 1994 Toyota Camry

1 Answer

I have a 1994 toyota pickup ext cab 4x4. Its running hot . I put new radiator and thremostat. No water in the oil. No visible leaks i see


You might check for exhaust in the coolant ... perhaps you have a small head gasket leak that is the problem.

May 02, 2010 | 1995 Toyota Pickup

3 Answers

Engine overheats with a new radiator and new thermostat. Its on a 1993 Toyota 4Runner 4x4.The waterpump is not visibly leaking either. Before replacing my old radiator I had used a bottle of stopleak to...


might be your headgasket...are you losing coolant through the overflow? getting a hyrdocarbon test will show this very quickly...high carbons=blown headgasket

Sep 11, 2009 | Toyota 4Runner Cars & Trucks

1 Answer

1994 Toyota 4Runner V6 3.0 VZE Engine, Automatic, 4wd DTC trouble code 12 how do I troubleshoot this code?


With any trouble codes you can not get away with not trouble shooting to find out were the problem is at.

Sep 11, 2009 | 1994 Toyota 4Runner

1 Answer

1994 toyota pickup heater stopped working


Sounds like there is air in the cooling system causing the engine not to overheat but the heater not to work. Flush cooling system and work the air out of the system.

Mar 01, 2009 | 1994 Toyota Pickup

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

180 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...