Question about 1997 Dodge Intrepid
Water does not leak out when sitting but must add every two or three days
You probably need to change the thermostat in your vehicle; I found this answer in http://en.allexperts.com/q/Dodge-Repair-809/2000-Dodge-Intrepid-Thermostat.htm
THERMOSTAT - 2.7L
Disconnect negative cable from remote jumper terminal
WARNING: DO NOT REMOVE PRESSURE CAP WITH THE SYSTEM HOT AND UNDER PRESSURE BECAUSE SERIOUS BURNS FROM COOLANT CAN OCCUR.
Drain cooling system.
Remove accessory drive belt for removal of the generator.
Raise vehicle on hoist.
Remove generator attaching bolts. Set generator aside for ease of access to thermostat.
Remove lower radiator and heater hoses from thermostat housing.
Remove thermostat housing bolts Thermostat and Housing - 2.7L Engine
Remove thermostat and housing.
Clean gasket sealing surfaces
NOTE: Install thermostat with the bleed valve located at the 12 o'clock position.
Install thermostat and gasket into the thermostat housing.
Install thermostat and housing to cylinder block. Tighten attaching bolts to 12 N·m (105 in. lbs.) Thermostat and Housing - 2.7L Engine
Connect heater and lower radiator hoses. Install hose clamps.
Install generator and attaching bolts.
Install accessory drive belt. Refer to procedure outlined in this section.
Refill cooling system. Refer to Cooling System Refilling.
Connect negative cable to remote jumper terminal.
Posted on Mar 12, 2009
Tips for a great answer:
Sep 24, 2016 | 2006 Dodge Stratus
May 12, 2014 | 1993 Honda Accord
May 21, 2011 | 1995 Jeep Grand Cherokee
Feb 12, 2010 | Volvo 240 Cars & Trucks
Oct 15, 2009 | 1999 Cadillac DeVille
Sep 17, 2009 | 2000 BMW 3 Series
Aug 30, 2009 | 1993 Audi 100
Apr 03, 2009 | 1999 GMC Jimmy
Mar 09, 2009 | 1993 Toyota Tercel
472 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: