Question about Ford Escape
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
The little air holes above the gas tank hole don't work very well on these. I've noticed it too. Just hold the pump at a little bit of an angle when this happens which will allow more air to escape your tank.
Posted on Apr 15, 2010
SOURCE: I have 2008 Ford Escape
this is an obd2 trouble code table, it can help you understand the meaning of code,
and for p0455:
A code p0455 most likely means one or more of the following has happened:
A loose or improperly affixed gas cap
A non-conforming gas cap (i.e. not factory/original brand)
Other leak or damaged piece in EVAP system
With a p0455, the most common repair is to:
Remove and reinstall the gas cap, clear the codes, and drive for a day and see if the codes come back.
Otherwise, replace the gas cap, and/or
Inspect the EVAP system for cuts/holes in tubes/hoses (you may hear a vacuum noise or smell fuel), repair if necessary
The only way a P0457 can set by itself is if the gas cap is left loose, assuming the van is in working order. when the engine controller sees a large increase in fuel level it knows you put some in the tank, and it runs the evaporative emissions system test to see if the system is sealed. If it sees a large leak it knows the cap was left off and sets the P0457. If you are positive the cap wasn't left even a little bit loose you may have a leak back there. It could be in the filler neck, from the tank to the evaporative emissions canisters just behind the subframe on the left side, and from there on up to the right front corner of the engine compartment where the purge solenoid is. If you don't see any leaks you probably have a bad NVLD, the unit that checks the system for leaks. This is probably what you are going to find.
The pressure or vacuum in the fuel tank when you remove the cap tells me that the system probably is sealed and has no leaks. Many times there will either be a little bit of pressure or vacuum in the tank, and it's perfectly normal.
The fuel gauge being innaccurate is either the sending unit or a problem with the pump module itself. there were some problems with some of the pump modules that allowed continuity between two of the terminals in the fuel pump connector and it caused the gauge to be wrong. You will probably end up needing to replace the fuel pump assembly for the gauge issue.
Posted on Jul 09, 2011
Tips for a great answer:
Jan 24, 2016 | 2013 Ford Explorer Limited
Oct 16, 2013 | 2007 Ford Escape
Oct 05, 2012 | 2009 Ford Escape
Jun 13, 2011 | 2003 Ford F250 Super Duty Crew Cab
Mar 18, 2010 | 2005 Ford Escape
Feb 02, 2010 | 2006 Ford Escape
Jul 24, 2009 | Toyota Land Cruiser Cars & Trucks
Oct 31, 2008 | 2001 Ford Escape
142 people viewed this question
Usually answered in minutes!