Question about Cars & Trucks

Open Question

How to adjustment 2001 hyundai tiburon clutch

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 69 Answers

SOURCE: change water pump on 2001 hyundai tiburon

It is a 2.0L (the delta blocks weren't in tibs until '03). You have to remove the timing belt tensioner, and then you can remove the bolts for the water pump. I would strongly recommend not only taking careful precaution not to disturb the orientation of the gears in this process, but also to replace the timing belt and water pump at the same time. You don't want to go through this process all over again do you?

Posted on May 27, 2009

ghost4548
  • 776 Answers

SOURCE: Need Instructions on 2003 Hyundai Tiburon Clutch Replacement

Go to http://www.hmaservice.com/ and register (vehicle by VIN). Afterward, you'll have access to technical information (manuals, wiring diagrams, service bulletins, etc) about your vehicle.

Posted on Jun 14, 2009

  • 1986 Answers

SOURCE: How do I adjust the headlights on 2001 hyundai

Pop the hood and you should see two dials (hex shaped plastic screws) on each of the headlight assemblies. One is for your high beams and one is for your low beams. You'll need to measure from the ground up to the center of your bulb and make that marking on the wall for each of your bulbs (so four marks). Then park about 30 feet away from the wall (make sure you're on a level surface that's level with the wall base. If the light says VOR, then the top of the brightest area of the light should line up with the mark. if it says VOL, then the top of the brightest area of the light should line up two inches below the mark.

Posted on Aug 21, 2009

ZJLimited
  • 17970 Answers

SOURCE: fuel filter location 2001 hyundai tiburon


2001 Hyundai Tiburon 2.0L MFI DOHC 4cyl
The Fuel Filter is located Under hood, passenger side, front side of strut tower, mounted on fenderwell.

066da8c.jpg

I hope help you with this, remember rated this help.

Good luck.

Posted on Sep 10, 2009

Testimonial: "THANK YOU !!!!!"

  • 9 Answers

SOURCE: trying to adjust clutch on 2001 Hyundai Accent.

hydraulic clutches are non-adjustable

Posted on Oct 14, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What would the hollow bolt that holds the clutch line to transmission be called on a 01 hyundai tiburon


You'll need to get it from the dealer, but this style of bolt is called a "banjo bolt" because the fitting that it goes through kind of looks like a banjo.

Apr 18, 2011 | 2001 Hyundai Tiburon

1 Answer

Need to replace a clutch and clutch slave cylinder, cant find a repair manual any suggestions?


go on the web and look for Hyundai coupe,there are loads of manuals available.......tiberon only in Korea and USA

Sep 22, 2010 | 2001 Hyundai Tiburon

1 Answer

2001 hyundai clutch is slipping- how do you get it to stop? Is there an adjustment- something that needs to be cleaned or replaced? The pedal is fine- everything seems to be moving/adjusted ok there- the...


Hi

If your clutch is slipping the clutch plate is worn out and will have to be changed. This involves engine and gearbox has to be taken out - then the gearbox has to be sperated from the engine to remove the clutch assembly and replace the clutch plate with a new one.

There is no adjustment on this clutch as it is hydraulic and therefore is self adjusting.

Hope this helps. Please remember to rate my answer. Thanks.

Jul 17, 2009 | 2001 Hyundai Tiburon

1 Answer

Valve adjustment


tiburon uses hydrolic lash adjusters there are no valve lash adjusting If you hearing a pecking sound on the top of the mtr try some oil additive or replace the hydrolic lash adjusters

Jun 15, 2009 | 2001 Mitsubishi Eclipse

1 Answer

2006 TIBURON CLUTCH ADJUSTMENT IS AT TOP


jai changer ma clutch dans mon tiburon pi elle ne marche pas ancor , jai blider la clutch pi ces parielle, que doige faire avec le petit bras qui est placer pour la clotch, le tourner an anvert pour le relisse bering va an place ou quoi, merci pour les sujestion.

Mar 20, 2009 | 2006 Hyundai Tiburon

1 Answer

How to replace clutch on 2001 tiburon


it might be very difficult if you have no idea how the clutch actually works.
if only the cables, that's easy.
but if the whole clutch assembly, you may need special tools.
and if you're the only to do it, you might get confused.

wow nice car you got sir!
i can't even afford to have one.

Nov 06, 2008 | 2003 Hyundai Tiburon

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

65 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...