Question about 1997 Buick Riviera

Open Question

Motor mount replacement Buick Riviera 1997 - 1997 Buick Riviera

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: serpentine belt

You actally have to take the Motor Mount off. The way I did it was to remove the Front Right Wheel and the Plastic Guard. There you will see the Motor Mount and the Bolt that needs to be removed. Once removed, the melt piece betwee the bracket and engine pops out. Then you can replace the belt and put everything back together.

Posted on Sep 02, 2008

Ad
  • 3 Answers

SOURCE: replacement of the serpentine belt on 1997 buick lesaber how

Yes, I have a 97 buick and the motor mount does have to be removed. See information below that I retireved from Autozone.com:

REMOVAL & INSTALLATION
See Figures 7 through 13

  1. Disconnect the negative battery cable.
0900c152800b19a8.jpgFig. 7: Many vehicles have an accessory drive belt routing label affixed to the radiator shroud
  1. Remove the belt guard or coolant recovery reservoir as required.
  2. For 1996-99 supercharged engines, perform the following:
    1. Raise and safely support the vehicle.
    2. Remove the right-hand splash shield.
    3. Remove the connector from the crank sensor.
  3. For 1996-99 vehicles, remove the engine mounting bracket lower nut, stud and spacer. Carefully lower the vehicle.

Posted on Jan 28, 2009

  • 5 Answers

SOURCE: 1996 Buick Riviera Heater/AC blower motor replacement

should be seven mil. screws pass. bottom take plastic panels off

Posted on Sep 28, 2009

  • 2 Answers

SOURCE: how do i remove water pump on 1998 buick riviera

u must jack up the car underneath the oil pan to support the engines weight. Then remove the motor mount. Then you can remove the last two bolts on the water pump.There are two holes in the bracket that is bolted to your engine block.These holes allow u access to the last two water pump bolts. If you loosen the upper bolt of the bracket itself u can swing it forward to get to the bolts on the water pump more easily. Do not completely remove the bracket! It's a tight space, but you'll extend the repair time if you remove the bracket versus swnging it forward.

Posted on Oct 03, 2009

  • 1 Answer

SOURCE: How to replace headlight on 99 buick riviera

Hello. I happen to own a '99 and had to do the same. You can access the back of the bulb by removing your air filter and hose. This will free up room for you to reach the bulb.

Posted on Nov 01, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where can I find motor mounts for 98 riviera


BUICK RIVIERA Anchor Industries Engine Torque Strut Mounts 2662 @ summitracing.com

Feb 25, 2015 | 1998 Buick Riviera

1 Answer

Motor mount passenger side rusted out


Sounds like you need to get that replaced. If the metal that the mount is attached to is also rusted you need to get to a fabricator or body shop to have that replaced too.

Apr 21, 2013 | 1997 Buick Riviera

1 Answer

1996 Buick Riviera getting serpintine belt through on or over? motormount?


the motor mount has to come off. you have to support the motor when you take off the motor mount. I am trying to find a video for you.. the hard is the bottom bolt on your right side under the alternator

Jan 26, 2013 | 1996 Buick Riviera

1 Answer

My belt for the supercharge broke can I still drive the car?? 1997 riviera


Yes, you can still drive the car. No real damage will occur, but performance will be poor. It's not impossible to change the belts, just time consuming with the way the belt is run around the motor mount bracket.

Jan 04, 2013 | 1998 Buick Riviera

1 Answer

How do I get to the blower motor on a 1984 oldsmobile toronado?


Your Buick Riviera's heater fan is powered by a blower motor, which in turn is powered by a blower motor resistor. The resistor is a small electrical component that also regulates the fan speeds of the blower motor. Like any part, the blower burns out from time to time and has to be replaced. Replacement blower motor resistors cost about $50. It will take you about 30 minutes to install a new one in your Buick Riviera.

Things You'll Need

  • Socket set
  • Screwdriver
    • 1

      Open the hood and disengage the negative battery cable on your Buick Riviera using your socket set. You will need a 10mm socket to loosen the battery cable bolt.

    • 2

      Remove the plastic trim panel under the glove compartment on the passenger side of your Riviera.

    • 3

      Loosen and remove the mounting screws that hold the blower resistor in place on your Riviera.

    • 4

      Unplug the wiring harness from the old blower resistor and then remove the resistor completely.

    • 5

      Plug the wiring harness into your Buick's new resistor. Also tighten the screws to hold the resistor in place.

    • 6

      Reattach the negative battery cable on your Riviera and tighten it with your socket set.

Jan 11, 2012 | 1984 Oldsmobile Toronado

1 Answer

Spark plug firing diagram for '97 buick riviera supercharged v-6


1997 Buick Riviera 3.8 liter SC V-6 VIN "1"
or
1997 Buick Riviera 3.8 liter V-6 VIN "K"

76b7366.gif

I hope help with this; remmeber to rate this.

Oct 02, 2010 | 1997 Buick Riviera

1 Answer

Can you tell me how to replace the passenger side head light bulb on my 1997 buick riviera?


On a 1997 Buick riviera the light bulbs simply plug in from the back side of the lens. You will have to twist the bulb pod from the socket. Change the bulb,wipe it with a clean cloth and twist it back in.

Dec 13, 2009 | 1997 Buick Riviera

3 Answers

Looking at a 3.8L supercharged Buick Riviera.


BUICK 3.8 ENGINES ARE PRETTY GOOD ENGINES.

Jul 26, 2009 | 1997 Buick Riviera

1 Answer

Looking on the steps to replace the starter on 1997 Buick Riviera


Disconnect your battery (make sure you know radio security code if you have one) Unbolt starter, lower it and remove wires. Some twisting and turning may be required to get it out. Reverse process to install.

Jun 03, 2009 | 1997 Buick Riviera

1 Answer

Heater


the blower motor took mabe 30 min to replace it should be on the passanger side under the dash it has 3 screws to hold it in or it on the fire wall pass side

Nov 20, 2008 | 1997 Buick Riviera

Not finding what you are looking for?
1997 Buick Riviera Logo

Related Topics:

42 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6924 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...